Journal of Geodesy

, Volume 92, Issue 12, pp 1467–1467 | Cite as

Correction to: AUSGeoid2020 combined gravimetric–geometric model: location-specific uncertainties and baseline-length-dependent error decorrelation

  • N. J. BrownEmail author
  • J. C. McCubbine
  • W. E. Featherstone
  • N. Gowans
  • A. Woods
  • I. Baran

1 Correction to: Journal of Geodesy

In Appendix A of the original article, the units used to compare the relative uncertainty from Eq. (11) to the square root of the sum of squares of the error estimates of point 1 and point 2 were incorrectly written as mm. This is incorrect. The units should have been written in cm. Therefore, the correct information reads as follows:

The relative uncertainty in the AHD height difference of two points is smaller than the square root of the sum of squares of the error estimates of point 1 and point 2 (10.2 cm vs. 14.1 cm).

All other results are unaffected by this error in units.

Copyright information

© Springer-Verlag GmbH Germany, part of Springer Nature 2018

Authors and Affiliations

  1. 1.Geodesy Section, Community Safety and Earth Monitoring DivisionGeoscience AustraliaCanberraAustralia
  2. 2.School of Earth and Planetary SciencesCurtin University of TechnologyPerthAustralia
  3. 3.Department of Environment, Land, Water and PlanningOffice of Surveyor-General Victoria, Land VictoriaMelbourneAustralia
  4. 4.Location Data ServicesLandgateMidlandAustralia
  5. 5.Spatial ServicesDepartment of Finance, Services and InnovationSydneyAustralia
  6. 6.Cooperative Research Centre for Spatial Information for This ProjectCarltonAustralia

Personalised recommendations