Investigation on the effect of mandrels on hollow shafts in cross-wedge rolling
- 9 Downloads
Cross-wedge rolling (CWR) hollow shafts with mandrels can control the hole contour and reduce internal defects so that the working conditions for the shafts can be met. The diameter of the mandrel plays an important role in this forming process. In this study, numerical simulations and experimental trials were conducted as part of a detailed investigation on the mechanism of a mandrel and its influence on the forming quality of CWR hollow shafts. The contact areas between the mandrel and workpiece, the rolling forces of the mandrel, stress-strain fields, metal flows and temperatures were analysed in detail. The gaps on the surface of dies designed to prevent torsion failure of the rolled piece lead to noticeable steps on the surface of the rolled piece, as the relative diameter of the mandrel is too large. The diameter and non-circularity of the outer and inner surface increase with the increase of the relative diameter of the mandrel. The results can provide theoretical guidance for the production application of cross-wedge rolling hollow shafts with mandrels.
KeywordsCross-wedge rolling Hollow shafts Mechanism of mandrel Forming quality
Unable to display preview. Download preview PDF.
This work is supported by the Fundamental Research Funds for the Central Universities (Grant No. FRF-BD-17-003A). This work is also supported by the National Natural Science Foundation of China (Grant No. 51875036, Grant No.51705018).
- 1.Hu ZH, Zhang KS, Wang BY, Shu XD, Yang CP (2004) Forming technology and simulation of cross wedge rolling parts. Metall Ind Press, BeijingGoogle Scholar
- 4.Li D, Yang H, Guo LG, Zeng WD, Zhang J (2015) Study on exit temperature evolution during extrusion for large-scale thick-walled inconel 625 pipe by FE simulation. Int J Adv Manuf Tech 76(5–8):1421–1435Google Scholar
- 5.Barbara R, Lorenzo D, Luca T (2016) Multi-goal optimization of industrial extrusion dies by means of meta-models. Int J Adv Manuf Tech:1–13Google Scholar
- 8.Zhang KS, Wang BY, Liu JP, Hu ZH (2000) Research on wall thickness of hollow workpiece rolled by cross wedge rolling. Forg Stam Technol 23(2):34–36Google Scholar
- 9.Zhang KS, Liu JP, Wang BY, Hu ZH (2001) Analysis on stable rolling condition of hollow workpiece rolled by cross wedge rolling. J Univ Sci Technol Beijing 23(2):155–157Google Scholar
- 10.Wang JL, Xu CG, Ren GS (2000) The numerical simulation on hollow part’s precise sizing process with cross-wedge rolling. J Shanghai Jiaotong Univ (Science) 1:248–252Google Scholar
- 13.Pater Z, Bartnicki J (2006) Wedge-rolls rolling of hollowed parts. J Ach Mater Manu Eng 18(1–2):407–410Google Scholar
- 18.Ji HC, Liu JP, Wang BY, Tang XF, Huo YM, Zhou J, Hu ZH (2016) Constitutive relationship of 4Cr9Si2 and technological parameters on the inner bore of cross wedge rolling for preform hollow valves. Int J Adv Manuf Tech 86(9–12):1–13Google Scholar
- 31.Fu XB, Wang BY, Zhu XX, Tang XF, Ji HC (2016) Numerical and experimental investigations on large-diameter gear rolling with local induction heating process. Int J Adv Manuf Tech 91(1–4):1–11Google Scholar