Two loop control-based generalized cycle-to-cycle optimization for machining workpieces with non-circular curve in CNC grinding
- 18 Downloads
In many scenarios of machining system, a workpiece with non-circular curve is manufactured by repetitively performing a given command. The size of the workpiece, however, is quite unlikely to be precisely measured until one process (or a cycle) has been completely finished. Although in-process measurement and control are possible, it is often economically prohibitive or practically complex to be conducted. To overcome this drawback, a two loop control-based generalized cycle-to-cycle (GCTC) feedback control scheme, which is an offline optimization control method, is proposed for machining workpiece with non-circular curve in this study. Inner loop is a local controller which is used to guarantee the tracking accuracy. GCTC feedback control is adopted to serve as an optimization module for the closed-loop system under the local controller to update the reference in the outer loop. The GCTC control model is developed based on the reference and measure error of the prior cycle of the machining system. The equivalent dynamic model of the machining system can be obtained by the extended state observer and repetitive control in inner loop. The sufficient stability conditions and convergence of the GCTC control are derived in this study. The proposed GCTC controllers are developed comprehensibly. The simplicity of the method lies in that only a low-pass filter and a proportional gain are required to be chosen. The superiority is demonstrated by the simulations and experiments on CNC cam grinding based on GCTC control. The application results justify the effectiveness of the GCTC scheme.
KeywordsA workpiece with non-circular curve Generalized cycle-to-cycle (GCTC) control Equivalent dynamic model CNC cam grinding
Unable to display preview. Download preview PDF.
This work is supported by the Ph.D. Programs Foundation of Henan Polytechnic University—The Intelligent Profile Error compensation in High Speed & High Precision CNC Cam Grinding (B2018-660807/027).
- 1.Huo F, Poo A-N (2012) Precision contouring control of machine tools. Int J Adv Manuf Technol 64(1–4):319–333Google Scholar
- 2.Xi X-C, Poo A-N, Hong G-S, Huo F (2010) Experimental implementation of Taylor series expansion error compensation on a biaxial CNC machine. Int J Adv Manuf Technol 53(1–4):285–299Google Scholar
- 3.Ernesto CA, Farouki RT (2009) Solution of inverse dynamics problems for contour error minimization in CNC machines. Int J Adv Manuf Technol 49(5–8):589–604Google Scholar
- 6.Koren Y (1980) Cross-coupled biaxial computer control for manufacturing systems. J Dyn Syst Meas Control 102(4):265. https://doi.org/10.1115/1.314961218
- 7.Lee JH, Dixon WE, Ziegert JC (2005) Adaptive nonlinear contour coupling control for a machine tool system. Int J Adv Manuf Technol 61(9–12):1057–1065Google Scholar
- 11.Zhou Y, Fei YU, Jianming XU (2011) The cascade type iterative learning cross-coupled contour error control method. Bull Sci Technol 27(5):737–739Google Scholar
- 15.Siu TS (2001) Cycle to cycle feedback control of manufacturing processes. Mass Inst Technol 114(2):158–174Google Scholar
- 19.Khalil HK (2001) Feedback systems: the small-gain theorem, in nonlinear systems, 3rd edn. Prentice-Hall, Upper Saddle River, pp 217–221Google Scholar