Prediction of temperature distribution over cutting tool with alumina-MWCNT hybrid nanofluid using computational fluid dynamics (CFD) analysis
- 18 Downloads
The accurate measurement of tool tip temperature in turning has been a challenging task for researchers. The present study covers the computational fluid dynamics (CFD) analysis of a single point carbide cutting tool dissipating heat and subjected to streams of nanofluid mist. This study is an attempt to numerically analyze the thermal behavior of the cutting tool having constant temperature heat source at its tip. To determine the optimized experimental value of nodal temperature, machining of AISI 304 steel has been carried out using alumina and alumina-MWCNT hybrid nanofluid mist with minimum quantity lubrication (MQL) system. Furthermore, the conjugate heat transfer (CHT) analysis has been performed to investigate the temperature distribution over the rake and flank face of carbide cutting insert. An overview of the mathematical model, complete geometry, and mesh generation of the carbide cutting tool is presented. Additionally, the CHT simulation results for the mist of alumina and alumina-MWCNT hybrid nanofluids were compared and validated successfully with the experimental data. The maximum variation of 5.79% has been observed between experimental and simulation data, which in turn proves the proposed conjugate heat transfer-based CFD model as an alternative approach to investigate the influence of cooling media on cutting tool under MQL technique.
KeywordsTemperature CFD Hybrid Nanofluid MWCNT Turning
Unable to display preview. Download preview PDF.
The authors acknowledge the support from Dr. Sandipan Roy of SRM Institute of Science and Technology Kattankulathur and Rabesh Kumar Singh of IIT (ISM) Dhanbad for his valuable suggestions for preparing the paper in its present form.
- 4.Shaw MC (2006) Metal cutting principles, 1st edn. Oxford University Press Inc., New DelhiGoogle Scholar
- 5.Astakhov VP (2006) Tribology of metal cutting. Tribology and Interface Engineering Series, No. 52. UK: Elsevier LimitedGoogle Scholar
- 6.Chow JG, Wright PK (1998) On-line estimation of tool/chip interface temperatures for a turning operation. T-ASME 110:56–64Google Scholar
- 33.Najiha MS, Rahman MM (2014) A computational fluid dynamics analysis of single and three nozzles minimum quantity lubricant flow for milling. IJAME 10:1891–1900Google Scholar
- 35.http://www.matweb.com/search/DataSheet.aspx?MatGUID=d4fe3bb60c91416fb508f7ae067f094e (Access date: 29/08/2017)
- 37.Vine LD (2005) A report on the development of a set of tools to visualize CFD data using texture based visualization algorithms. In: 2005–2006 QPSF Summer Internship Project. Queensland University of Technology, Brisbane, AustraliaGoogle Scholar
- 38.Anderson JD, Degroote J, Degrez G, Dick E, Grundmann R, Vierendeels J (2009) Computational fluid dynamics: an introduction, 3rd edn. Springer-Verlag, Berlin HeidelbergGoogle Scholar
- 39.Sayma A (2009) Computational fluid dynamics. Ventus Publishing Aps, ISBN: 978-87-7681-430-4Google Scholar
- 40.ANSYS, Inc (2009) ANSYS CFX solver theory guide. USAGoogle Scholar
- 43.Heywood JB (1988) Internal combustion engine fundamentals. McGraw Hill Inc., USAGoogle Scholar