Advertisement

General report

  • Lamond Joseph F. 
International Symposium on Aggregates Theme 5. Aggregates for Concrete

Summary

An understanding of the behavior of aggregates when used in concrete is necessary for that concrete to perform satisfactorily in service. There are as many as fifty aggregate properties that may have an influence on the properties of both freshly mixed and hardened concrete. The large number of papers presented at this session of the symposium is evidence of the desire for that understanding. Considerable progress has been made in the field of concrete technology. Since aggregates occupy approximately 75 percent of the volume of concrete, considerable investigations have been performed to improve selection, testing and evaluation of aggregates. In selecting new aggregate sources representative samples and detailed geological investigation are necessary. Petrographic analysis should be mandatory. However a petrographic analysis is far more meaningful if the petrographer recognizes the service condition to which the aggregates are to be used and the limitations of the concrete constituents to perform under those anticipated service condition. Also more detailed and new test procedures are needed to properly evaluate the aggregates used in concrete.

Keywords

Fine Aggregate High Strength Concrete Concrete Aggregate Lightweight Aggregate American Concrete Institute 

Rapport general

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

References

  1. [1]
    ACI Committee 221: “Selection and Use of Aggregates for Concrete” American Concrete Institute, Detroit, Michigan, 1961, pp 22.Google Scholar
  2. [2]
    ACI Committee 221: “Guide for Use of Normal Weight Aggregates in Concrete” American Concrete Institute, Detroit, Michigan, 1984, pp. 24.Google Scholar
  3. [3]
    ACI Committee 213: “Guide for Structural Lightweight Aggregate Concrete” American Concrete Institute, Detroit, Michigan, 1979, pp 30.Google Scholar
  4. [4]
    ASTM Committee C9: “Significance of Test and Properties of Concrete and Concrete Aggregates, Special Publication No. 169B, American Society for Testing and Materials, Philadelphia, Pennsylvania 1978, pp. 539–764.Google Scholar
  5. [5]
    DOLAR-MANTUANI, Ludmila: “Handbook of Concrete Aggregate A Petrographic and Technological Evaluation, Noyes Publications, Park Ridge, New Jersey, 1983 pp 345.Google Scholar

Copyright information

© International Association of Engineering Geology 1984

Authors and Affiliations

  • Lamond Joseph F. 
    • 1
  1. 1.U.S. Army Corps of EngineersWashington, D.C.USA

Personalised recommendations