Sulla determinazione e interpolazione della traiettoria dell’utensile nelle macchine a controllo numerico continuo
Article
Received:
- 17 Downloads
On the generation and interpolation of the cutter path in contouring control systems
Abstract
In this paper procedures are described allowing the calculation of the cutter position at any given time in two axis, contouring, numerically controlled machinetools.
It is assumed that input data define the profile being machined and the cutter offsct and feedrate. The profile consists of straight lines and arcs. It is allowed the cutter offset to be redefined during the machining operation. Procedures mainly consist of a staircase approximation of the theoretical tool-path, as defined from the geometry of the profile and the cutter offset. They require only additions, subtractions and comparisons and are intended for implementation by low-cost special purpose computers.
Preview
Unable to display preview. Download preview PDF.
Riferimenti
- [1]J. Thilliez,Le commande numerique des machines (1967), Dunod, Paris.Google Scholar
- [2]O. S. Puckle, J. R. Arrowsmith,An Introduction to Numerical Control of Machine-Tools (1964), Chapman & Hall, London.Google Scholar
- [3]D. F. Walker,Data Processing for Numerical Control of Machine-Tools, J. Brit. IRE (1963), 501–515.Google Scholar
- [4]T. Kaiwa, S. Inaba,Simple Arithmetic Computes Cutter Offsets, Control Engng 9 (Marzo 1962), 93–96.Google Scholar
- [5]P. Maestrini,Algoritmi per l’elaborazione del profilo normalizzato in un sistema per il controllo numerico continuo di macchine utensili. Centro Studi Calcolatrici Elettroniche, Nota Interna II-30. Pisa 1966.Google Scholar
Copyright information
© IAC 1970