Girculation model for monitoring arterial systolic blood pressure

  • G. Warner
  • T. S. Sankar
Article

Abstract

The theoretical basis of a new technique for monitoring systolic blood pressure is explained. This method permits continuous beat-by-beat monitoring of systolic pressure. The circulatory system is considered as a simple elastic reservoir emptying through a resistance. If certain assumptions and conditions hold, the time rate of blood-volume change in a peripheral vascular region, during diastole or systole, can be related to the arterial systolic pressure. A critical element of the technique is the maintenance of the measured peripheral vascular region at near maximal vasodilatation. If the peripheral vascular bed is well dilated, and the subject is resting or doing light exercise, the technique should permit following of blood-pressure changes with a good approximation after calibration against a standard method of measuring blood pressure (sphygmomanometer).

Keywords

Elastic reservoir Systolic blood pressure Circulation model 

Sommaire

Le principe de base d’une nouvelle technique pour le contrôle de la pression sanguine systolique est exposé. Cette méthode permet le contrôle constant, pulsation par pulsation, de la pression systolique. Le système circulatoire est considéré comme un simple réservoir élastique se vidant par l’intermédiaire d’une résistance. Si certaines hypothèses et conditions sont retenues, le facteur temps du changement de volume sanguin dans une région vasculaire périphérique, pendant la diastole ou la systole, peut alors avoir un rapport avec la pression sanguine systolique. Le point délicat de cette technique est le maintien de la région vasculaire périphérique mesurée à un niveau de vasodilatation presque maximum. Si le lit vasculaire périphérique est bien dilaté et si le sujet se repose ou fait de légers exercices, la technique devrait permettre de suivre les variations de la tension artérielle avec une approximation satisraisante après étalonnage avec un appareil courant de mesure de la tension artérielle (sphymomanomètre).

Zusammenfassung

Die theoretische Basis eines neuen Verfahrens zur Überwachung systolischen Blutdruckes wird erklärt. Dieses Verfahren ermöglicht kontinuierliche Schlag-zu-Schlag-Überwachung des systolischen Druckes. Das Kreislaufsystem wird als einfaches elastisches Reservoir angesehen, das sich durch einen Widerstand entleert. Falls bestimmte Annahem und Bedingungen bestehen bleiben, kann die Zeitrate der Blutvolumenänderung in einer peripheren Gefäßzone während der Diastole und Systole mit dem arteriellen systolischen Druck in Beziehung gebracht werden. Ein kritisches Element des Verfahrens ist die Aufrechterhaltung der gemessenen peripheren Gefäßzone auf nahezu maximaler Gefäßdehnung. Falls das periphere Gefäßbett gut gedehnt ist und der Patient ruht oder leichte Korperübungen ausführt, sollte das Verfahren gestatten, mit guter Annäherung nach Kalibrierung gegen ein Norm-Blutdruckmeßgerät (Sphygmomanometer) den Blutdruckänderungen zu folgen.

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

References

  1. Catton, W. T. (1957)Methods in physiology, Pitmans.Google Scholar
  2. Cope, F. W. (1965) InAdvances in biological and medical Physics 10, p. 278.Google Scholar
  3. Grodins, F. S. et al. (1960) Performance characteristics of the right heart bypass preparation.Am. J. Physiol. 198, p. 552.Google Scholar
  4. Hertzman, A. B. andRoth, L. S. (1942) Absence of vasoconstrictor reflexes in forehead circulation. Effects of cold.136, p. 692. 0Google Scholar
  5. Uretsky, G. andPalti, Y. (1971) A method for comparing transmitted and reflected light photoelectric plethysmograph.J. Appl. Phys.,31.Google Scholar
  6. Warner, G. (1974) A new technique for continuous monitoring of systolic blood pressure. M. Eng. thesis, Concordia University, Montreal.Google Scholar

Copyright information

© International Federation for Medical & Biological Engineering 1977

Authors and Affiliations

  • G. Warner
    • 1
  • T. S. Sankar
    • 1
  1. 1.Department of Mechanical EngineerinConcordia UniversityMontrealCanada

Personalised recommendations