Cellulose

, Volume 1, Issue 2, pp 145–160 | Cite as

Surface characterization of unbleached kraft pulps by means of ESCA

  • Janne Laine
  • Per Stenius
  • Gilbert Carlsson
  • Göran Ström
Research Papers

Abstract

The effect of digestion conditions (amount of effective alkali, digestion time) on the surface compositions of unbleached softwood (Pinus sylvestris) kraft pulp has been investigated by electron spectroscopy for chemical analysis (ESCA). The quantities monitored were the angular dependence of the total O/C ratio, the relative amounts of carbons in different states of oxidation and the adsorption of Al and Ca ions to the carboxyl groups in the surface. Examination of the angular dependence of ESCA intensities shows that the concentration of alkyl carbon is high in a very thin surface layer and that it decreases linearly with decreasing kappa number. The concentration of alkyl carbon is decreased by extraction of the fibres with dichloromethane, but the amount remaining in the surface after extraction still decreases linearly with decreasing kappa number (i.e. it decreases with increasing digestion time). It is suggested that the observed enrichment of alkyl carbon in the outermost surface layers most probably is due to reprecipitation of lignin. In pulp that has not been extracted, there is also strong enrichment of extractives in the surface. This amount increases with increasing effective alkali but is relatively independent of digestion time. ESCA analysis of the Al and Ca bound to the carboxyl groups shows that the amount depends on digestion time; the results are consistent with the notion that the reprecipitated lignin contains carboxyl groups.

Keywords

kraft pulp surface properties ESCA lignin extractives carboxyl groups 

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

References

  1. Björklund Jansson, M., Back, E. L. and Tufvesson, M. I. (1985) A review of kraft pulp deresination and pitch problems. InPapermaking Raw Materials, (V. Punton, ed.). London, Mechanical Engineering Publications, Vol. 2, pp. 729–760.Google Scholar
  2. Buchert, J., Tenkanen, M., Viikari, L. and Pitkänen, M. (1993) Role of surface charge and swelling on the action of xylanases on birch kraft pulp.TAPPI J. 76, 131–135.Google Scholar
  3. Carlsson, G. (1991)Plasma Treatment of Pulp and Paper: ESCA Characterization, Water Wettability and Adhesion to Polyethylene, Lic. Thesis, Royal Institute of Technology, Stockholm.Google Scholar
  4. Carlsson, C. M. G. and Ström, G. (1991a) Reduction and oxidation of cellulose surfaces by means of cold plasma.Langmuir 7, 2492–2497.Google Scholar
  5. Carlsson, C. M. G. and Ström, G. (1991b) Adhesion between plasma-treated cellulosic materials and polyethylene.Surf. Interface Anal. 17, 511–515.Google Scholar
  6. Dorris, G. M. and Gray, D. G. (1978a) The surface analysis of paper and wood fibres by ESCA (electron spectroscopy for chemical analysis). I. Application to cellulose and lignin.Cellul. Chem. Technol. 12, 9–23.Google Scholar
  7. Dorris, G. M. and Gray, D. G. (1978b) The surface analysis of paper and wood fibres by ESCA. II. Surface composition of mechanical pulps.Cellul. Chem. Technol. 12, 721–734.Google Scholar
  8. Freudenberg, K. and Neish, A. C. (1968)Constitution and Biosynthesis of Lignin. Berlin: Springer-Verlag.Google Scholar
  9. Gray, D. G. (1978) The surface analysis of paper and wood fibres by ESCA. III. Interpretation of carbon (1s) peak shapeCellul. Chem. Technol. 12, 735–743.Google Scholar
  10. Janson, J., Palenius, L., Stenlund, B. and Sågfors, P-E. (1975) Differences in colour and strength of kraft pulps from batch and flow cooking.Pap. Puu 57, 387–390.Google Scholar
  11. Kyrklund, B. and Strandeil, G. (1969) Applicability of the chlorine number for evaluation of the lignin content of pulp.Pap. Pun. 51, 299–305.Google Scholar
  12. Laine, J., Lövgren, L., Stenius, P. and Sjöberg, S. (1994) Potentiometric titration of unbleached kraft cellulose fibre surfaces.Colloids Surf., in press.Google Scholar
  13. Mjöberg, P. J. (1981) Chemical surface analysis of wood fibres by means of ESCA.Cellul. Chem. Technol. 15, 481–486.Google Scholar
  14. Pijpers, A. P. and Donners, W. A. B. (1985) Quantitative determination of the surface composition of acrylate copolymer latex films by XPS (ESCA).J. Polym. Sci., Polym. Chem. Ed. 23, 453–462.Google Scholar
  15. Sarkanen, K. V. and Ludwig, C. H. (eds.) (1971)Lignins, Occurrence, Formation, Structure and Reactions. New York: Wiley-Interscience.Google Scholar
  16. Sawatari, A. and Nakamura, H. (1992) Study on the functional groups of the corona-treated cellulose fiber sheet surface by means of chemical modification-ESCA technique. InLignocellulosics. Science, Technology, Development and Use (J. F. Kennedy, G. O. Phillips and P. A. Williams, eds.). Chichester: Ellis Horwood, pp. 365–370.Google Scholar
  17. Scallan, A. M. and Grignon, J. (1979) The effect of cations on pulp and paper properties.Svensk Papperstid. 82, 40–47.Google Scholar
  18. Sjöström, E., (1993)Wood Chemistry, Fundamentals and Applications, 2nd edn. New York: Academic Press.Google Scholar
  19. Stenius, P. and Laine, J. (1994) Studies of cellulose surfaces by titration and ESCA.Applied Surface Sci. 75, 213–219.Google Scholar
  20. Ström, G., Stenius, P., Lindström, M. and Ödberg, L. (1990) Surface chemical aspects of the behavior of soaps in pulp washing.Nordic Pulp Paper Res. J. 5, 44–51.Google Scholar
  21. Ström, G. and Carlsson, G. (1992) Wettability of kraft pulps-effect of surface composition and oxygen plasma treatment.J. Adhesion Sci. Technol. 6, 745–761.Google Scholar
  22. Ström, G., Carlsson, G. and Kiar, M. (1992). Bestimmung der Alkylketendimer-Verteilung in Probeblättern mittels Elektronenspektroskopie (ESCA).Wochenbl. Papierfabr. 120, 606–611.Google Scholar
  23. Ström, G., Carlsson, G. and Schulz, A. (1993) Chemical composition of coated paper surfaces determined by means of ESCA.Nordic Pulp Paper Res. J. 8, 105–112.Google Scholar
  24. Sundquist, J. (1985) The multiform nature of residual lignin in chemical pulps. Technical papers, International Symposium on Wood & Pulping Chemistry, Vancouver, pp. 23–26.Google Scholar
  25. Takeyama, S. and Gray, D. G. (1982) An ESCA study of the chemisorption of stearic acid vapour on cellulose.Cellul. Chem. Technol. 16, 133–142.Google Scholar
  26. Ödberg, L. and Ström, G. (1983). ESCA studies of retention and dewatering aids. The adsorption of Polymin SN and Polymin SN-lignosulfonate complexes on cellulose.Svensk Papperstid. 86, R141-R145.Google Scholar

Copyright information

© Blackie Academic & Professional 1994

Authors and Affiliations

  • Janne Laine
    • 1
  • Per Stenius
    • 1
  • Gilbert Carlsson
    • 2
  • Göran Ström
    • 2
  1. 1.Laboratory of Forest Products Chemistry, Department of Forest Products TechnologyHelsinki University of TechnologyEspooFinland
  2. 2.Institute for Surface ChemistryStockholmSweden

Personalised recommendations