Applied Microbiology and Biotechnology

, Volume 40, Issue 6, pp 786–790 | Cite as

Effect of carbon source and concentration on the molecular mass of poly(3-hydroxybutyrate) produced by Methylobacterium extorquens and Alcaligenes eutrophus

  • Behnam Taidi
  • Alistair J. Anderson
  • Edwin A. Dawes
  • David Byrom
Biotechnology
Received:
Revised:
Accepted:

Abstract

In shake-flask culture, Methylobacterium extorquens accumulated poly(3-hydroxybutyrate) (PHB) possessing a substantially higher weight-average molecular mass (MW) than previously reported for this organism. The MW of PHB produced by M. extorquens was dependent on the initial concentration of methanol or sodium succinate, used as sole carbon sources. The highest MW values (0.6 and 1.7 × 106) were obtained with low initial concentrations of methanol or sodium succinate (4.0 and 3.0 g l−1, respectively) and the latter substrate always yielded PHB of higher MW than that produced from methanol. Thus PHB with an MW in the range 0.2–1.7 × 106 could be produced by selection of the carbon source and its concentration. In contrast to the findings with M. extorquens, the MW of PHB produced by Alcaligenes eutrophus was high (1.1–1.6 × 106) and generally unaffected by the choice or concentration of the carbon source. The use of glycerol as sole carbon source did, however, result in the accumulation of PHB with a markedly lower MW (5.5–8.5 × 105) than that produced from other sole carbon sources by this organism under similar conditions.

Keywords

Sodium Methanol Glycerol Carbon Source Molecular Mass 
These keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.
This is a preview of subscription content, log in to check access.

Preview

Unable to display preview. Download preview PDF.

Unable to display preview. Download preview PDF.

References

  1. Anderson AJ, Haywood GW, Williams DR, Dawes EA (1990) The production of polyhydroxyalkanoates from unrelated carbon sources. In: Dawes EA (ed) Proceedings of the NATO Advanced Research Workshop on New Biosynthetic Biodegradable Polymers of Industrial Interest from Microorganisms, 26–31 May 1990, Sitges, Spain. Kluwer, Dordrecht, pp 119–129Google Scholar
  2. Anderson AJ, Williams DR, Taidi B, Dawes EA, Ewing DF (1992) Studies on copolyester synthesis by Rhodococcus ruber and factors influencing the molecular mass of polyhydroxybutyrate accumulated by Methylobacterium extorquens and Alcaligenes eutrophus. FEMS Microbiol Rev 103:93–102Google Scholar
  3. Anthony C (1982) The biochemistry of methylotrophs. Academic Press, LondonGoogle Scholar
  4. babel W (1992) Peculiarities of methylotrophs concerning overflow metabolism, especially the synthesis of polyhydroxyalkanoates. FEMS Microbiol Rev 103:141–148Google Scholar
  5. Ballard DGH, Holmes PA, Senior PJ (1987) Formation of polymers of ß-hydroxybutyric acid in bacterial cells and a comparison of the morphology of growth with the formation of polyethylene in the solid state. In: Fontanille M, Guyot A (eds) Recent advances in mechanistic and synthetic aspects of polymerization, NATO ASI ser., ser. C215, vol 215. Reidel (Kluwer) Publishing, Lancaster, UK, pp 293–314Google Scholar
  6. Berger E, Ramsay BA, Ramsay JA, Chavarie C (1989) PHB recovery by hypochlorite digestion of non-PHB biomass. Biotechnol Tech 3:227–232Google Scholar
  7. Bourque D, Quellette B, André G, Groleau D (1992) Production of poly-ß-hydroxybutyrate from methanol: characterization of a new isolate of Methylobacterium extorquens. Appl Microbiol Biotechnol 37:7–12Google Scholar
  8. Bousfield IJ, Green PN (1985) Reclassification of bacteria of the genus Protomonas Urakami and Komagata 1984 in the genus Methylobacterium (Patt, Cole and Hanson) Emend. Green and Bousfield 1983. Int J Syst Bacteriol 35:209Google Scholar
  9. Bradel R, Kleinke A, Reichert K-H (1989) Molecular weight of bacterially produced poly-d(−)-3-hydroxybutyrate. DECHEMA Biotechnol Conf 3:207–209Google Scholar
  10. Bradel R, Kleinke A, Reichert K-H (1991) Molar mass distribution of microbial poly(d(−)-3-hydroxybutyrate) in the course of intracellular synthesis and degradation. Makromol Chem Rapid Commun 12:583–590Google Scholar
  11. Brandl H, Gross RA, Lenz RW, Fuller RC (1988) Pseudomonas oleovorans as a source of poly(ß-hydroxyalkanoates) for potential applications as biodegradable polyesters. Appl Environ Microbiol 54:1977–1982Google Scholar
  12. Braunegg G, Sonnleitner B, Lafferty RM (1978) A rapid gas chromatographic method for the determination of poly-ß-hydroxybutyric acid in microbial biomass. Eur J Appl Microbiol 6:29–37Google Scholar
  13. Collins SH (1987) Choice of substrate in polyhydroxybutyrate synthesis. In: Stowell JD, Beardsmore AJ, Keevil CW, Woodward JR (eds) Carbon substrates in biotechnology. (Special publications of the Society for General Microbiology, vol 21) IRL Press, Oxford, pp 161–168Google Scholar
  14. Daniel M, Choi JH, Kim JH, Lebault JM (1992) Effect of nutrient deficiency on accumulation and relative molecular weight of poly-ß-hydroxybutyric acid by methylotrophic bacterium, Pseudomonas 135. Appl Microbiol Biotechnol 37:702–706Google Scholar
  15. Doi Y (1990) Microbial polyesters. VCH, New YorkGoogle Scholar
  16. Hanaham DJ, Olley JN (1958) Chemical nature of monophosphoinositides. J Biol Chem 231:813–828CrossRefPubMedGoogle Scholar
  17. Hardy GA, Dawes EA (1985) Effect of oxygen concentration on the growth and respiratory efficiency of Acinetobacter calcoaceticus. J Gen Microbiol 131:855–864Google Scholar
  18. Haywood GW, Anderson AJ, Ewing DF, Dawes EA (1990) Accumulation of a polyhydroxyalkanoate containing primarily 3-hydroxydecanoate from simple carbon substrates by Pseudomonas sp. strain NCIMB 40 135. Appl Environ Microbiol 56:3354–3359Google Scholar
  19. Holmes PA (1988) Biologically produced (R)-3-hydroxyalkanoate polymers and copolymers. In: Bassett DC (ed) Developments in crystalline polymers, volume 2. Elsevier, Barking, UK, pp 1–65Google Scholar
  20. Kawaguchi Y, Doi Y (1992) Kinetics and mechanism of synthesis and degradation of poly(3-hydroxybutyrate) in Alcaligenes eutrophus. Macromolecules 25:2324–2329Google Scholar
  21. Odian G (1981) Principles of polymerization. Wiley, New YorkGoogle Scholar
  22. Steinbüchel A (1991) Polyhydroxyalkanoic acids. In: Byrom D (ed) Biomaterials. Novel materials from biological sources. Macmillan, Basingstoke, UK, pp 123–213Google Scholar
  23. Suzuki T, Yamane T, Shimizu S (1986a) Mass production of poly-ß-hydroxybutyric acid by fully automatic fed-batch culture of methylotroph. Appl Microbiol Biotechnol 23:322–329Google Scholar
  24. Suzuki T, Yamane T, Shimizu S (1986b) Kinetics and effect of nitrogen source feeding on production of poly-ß-hydroxybutyric acid by fed-batch culture. Appl Microbiol Biotechnol 24:366–369Google Scholar
  25. Suzuki T, Yamane T, Shimizu S (1986c) Mass production of poly-ß-hydroxybutyric acid by fed-batch culture with controlled carbon/nitrogen feeding. Appl Microbiol Biotechnol 24:370–374Google Scholar
  26. Suzuki T, Deguchi H, Yamane T, Shimizu S, Gekko K (1988) Control of molecular weight of poly-ß-hydroxybutyric acid produced in fed-batch culture of Protomonas extorquens. Appl Microbiol Biotechnol 27:487–491Google Scholar
  27. Ueda S, Matsumoto S, Takagi A, Yamane T (1992a) Synthesis of poly(3-hydroxybutyrate-co-3-hydroxyvalerate) from methanol and n-amyl alcohol by the methylotrophic bacteria Paracoccus denitrificans and Methylobacterium extorquens. Appl Environ Microbiol 58:3574–3579Google Scholar
  28. Ueda S, Matsumoto S, Takagi A, Yamane T (1992b) n-Amyl alcohol as a substrate for the production of poly(3-hydroxybutyrate-co-3-hydroxyvalerate) by bacteria. FEMS Microbiol Lett 98:57–60Google Scholar
  29. Vishniac W, Santer M (1957) The thiobacilli. Bacteriol Rev 21:195–213Google Scholar

Copyright information

© Springer-Verlag 1994

Authors and Affiliations

  • Behnam Taidi
    • 1
  • Alistair J. Anderson
    • 1
  • Edwin A. Dawes
    • 1
  • David Byrom
    • 2
  1. 1.Department of Applied Biology, School of Life SciencesUniversity of HullHullUK
  2. 2.Zeneca Bio ProductsBillinghamUK

Personalised recommendations