Abstract
The influence of the conditions of electrospark machining on the structural changes and roughness of the machined surfaces and hence on their wear resistance is studied experimentally. After electrospark machining of 38Х2Н2МА steel with the minimum parameters, the roughness of the machined surface is found to be minimal. However, the depth of the modified layer (the zone of diminished microhardness) is a maximum. When using the maximum electrospark parameters, the roughness of the machined surface is a maximum, whereas the depth of the modified layer is a minimum. The zone of diminished microhardness affects the wear resistance of the working surfaces and the working life of the part as a whole. In specifying the conditions of electrospark machining, large currents I (А) must be used, or else subsequent operations will be required to remove the modified layer from the machined surface.
Similar content being viewed by others
REFERENCES
Ablyaz, T.R., Khanov, A.M., and Khurmatullin, O.G., Sovremennye podkhody i tekhnologii elektroerozionnoi obarabotki materialov (Modern Approaches and Technologies of EDM Processing of the Materials), Perm: Perm. Nats. Issled. Politekh. Univ., 2012.
Serebrenitskii, P.P., Sovremennoe elektroerozionnye tekhnologii i oborudovanie: uchebnoe posobie (Modern Electroerosive Technologies and Equipment: Manual), St. Petersburg: Balt. Gos. Tekh. Univ., 2007.
Ablyaz, T.R. and Borisov, D.A., Influence of the surface roughness of the electrode tool on the productivity in electric discharge machining of steel, Russ. Eng. Res., 2017, vol. 37, no. 8, pp. 730–732.
Ablyaz, T.R., Simonov, M.Y., Schlykov E.S., et al., Surface analysis of bimetal after EDM machining using electrodes with different physical and mechanical properties, Res. J. Pharm., Biol. Chem. Sci., 2016, vol. 7, no. 5, pp. 974–981.
Ablyaz, T.R., Roughness of the machined surface in wire EDM, Russ. Eng. Res., 2016, vol. 36, no. 8, pp. 690–691.
Ablyaz, T.R. and Zhurin, A.V., Influence of wire-cut electrical discharge machining on surface quality, Russ. Eng. Res., 2016, vol. 36, no. 2, pp. 156–158.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by Bernard Gilbert
About this article
Cite this article
Ablyaz, T.R., Panov, D.O., Muratov, K.R. et al. Influence of Electrospark Machining on Surface Performance. Russ. Engin. Res. 39, 252–254 (2019). https://doi.org/10.3103/S1068798X19030031
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X19030031