Abstract
The influence of the conditions of wire electric-discharge machining (EDM) on the cut width in the machining of 09G2S steel is experimentally investigated. The relation between the cutting power and the cut width is obtained. It is shown that, with reduction in the power, more thermal energy is concentrated at the machined section of surface, the probability of secondary spark discharges increases, and consequently the cut width increases.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Stavitskii, I.B., Electrophysical and electrochemical methods of material processing, Nauka Obraz., 2004, no. 10. http://technomag.edu.ru/doc/46142.html. Accessed July 25, 2015.
Ablyazm T.R., Khanov, A.M., and Khurmatullin, O.G., Sovremennye podkhody i tekhnologii elektroerozionnoi obarabotki materialov (Modern Approaches and Technologies of EDM Processing of the Materials), Perm: Perm. Nats. Issled. Politekh. Univ., 2012.
Dauw, D.F., Sthioul, H., Delpretti, R., and Tricarico, C., Wire analysis and control for precision EDM cutting, CIRP Ann., 1989, vol. 38, no. 1, pp. 191–194.
Kinoshita, N., Fukui, M., and Kimura, Y., Study on wire-EDM: in process measurement of mechanical behavior of electrode-wire, CIRP Ann., 1984, vol. 33, no. 1, pp. 89–96.
Nemilov, E.F., Elektroerozionnaya obrabotka materialov: uchebnoe posobie (Manual on EDM Processing of the Material), Leningrad: Mashinostroenie, 1983.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © T.R. Ablyaz, R.V. Lesnikov, 2016, published in STIN, 2016, No. 2, pp. 23–25.
About this article
Cite this article
Ablyaz, T.R., Lesnikov, R.V. Influence of the wire EDM conditions on the cut width. Russ. Engin. Res. 36, 786–787 (2016). https://doi.org/10.3103/S1068798X16090033
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X16090033