Abstract
Due to the wide bandgap and other key materials properties of 4H-SiC, SiC MOSFETs offer performance advantages over competing Si-based power devices. For example, SiC can more easily be used to fabricate MOSFETs with very high voltage ratings, and with lower switching losses. Silicon carbide power MOSFET development has progressed rapidly since the market release of Cree’s 1200V 4H-SiC power MOSFET in 2011. This is due to continued advancements in SiC substrate quality, epitaxial growth capabilities, and device processing. For example, high-quality epitaxial growth of thick, low-doped SiC has enabled the fabrication of SiC MOSFETs capable of blocking extremely high voltages (up to 15kV); while dopant control for thin highly-doped epitaxial layers has helped enable low on-resistance 900V SiC MOSFET production. Device design and processing improvements have resulted in lower MOSFET specific on-resistance for each successive device generation. SiC MOSFETs have been shown to have a long device lifetime, based on the results of accelerated lifetime testing, such as high-temperature reverse-bias (HTRB) stress and time-dependent dielectric breakdown (TDDB).
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
B.J. Baliga, Fundamentals of Power Semiconductor Devices, Springer Science, New York (2008).
T. Kimoto and J.A. Cooper, Fundamentals of Silicon Carbide Technology, IEEE Press, John Wiley & Sons, Singapore (2014).
H. Iwata and K.M. Itoh, J. Appl. Phys. 89(11), 6228–6234 (2001).
J.J. Sumakeris, J.R. Jenny, and A.R. Powell, MRS Bulletin 30, 280–286 (2005).
A.R. Powell, J.J. Sumakeris, Y. Khlebnikov, M. Paisley, R. Leonard, M. O’Loughlin, E. Deyneka, S. Gangwal, J. Ambati, V. Tsvetkov, J. Seaman, A. McClure, C. Horton, O. Kramarenko, V. Sakhalkar, J. Guo, M. Dudley, and E. Balkas, Inter. Conf. on SiC and Related Materials (ICSCRM) (Oct. 5, 2015).
H.S. Kong, H.J. Kim, J.A. Edmond, J.W. Palmour, J. Ryu, C.H. Carter, Jr., J.T. Glass, and R.F. Davis, Mater. Res. Soc. Symp. Proc. 97, 233 (1987)
S. Davis, Power Electronics Technol., pp. 36–40, Feb. (2011).
J. W. Palmour, L. Cheng, V. Pala, E. V. Brunt, D. J. Lichtenwalner, G.-Y. Wang, J. Richmond, M. O′Loughlin, S. Ryu, S. T. Allen, A. A. Burk, and C. Scozzie, Proc. of the 26th Inter. Symp. on Power Semiconductor Devices & IC’s (ISPSD), pp. 79–82, (2014).
CoolMOS™ C7 Technology and Design Guide, Application Note AN 2013-04, V1.0 April (2013), Infineon Technologies.
G.Y. Chung, C.C. Tin, J.R. Williams, K. McDonald, R.K. Chanana, R.A. Weller, S.T. Pantelides, L.C. Feldman, O.W. Holland, M.K. Das, J.W. Palmour, IEEE Electron Dev. Lett. 22, 176–178 (2001).
D. Okamoto, H.Yano, K.Hirata, T.Hatayama, T.Fuyuki, IEEE Electron Dev. Lett. 31, 710– 712 (2010).
D.J. Lichtenwalner, L. Cheng, S. Dhar, A. Agarwal, J.W. Palmour, Appl. Phys. Lett. 105(18), 182107 (2014).
A. V. Penumatcha, S. Swandono, and J. A. Cooper, IEEE Trans. on Electron Devices 60(3), 923–926 (2013).
G. Liu, B.R. Tuttle, and S. Dhar, Appl. Phys. Rev. 2, 021307 (2015).
V. Pala, A. Barkley, B. Hull, G. Wang, S.-H. Ryu, E. Van Brunt, D.J. Lichtenwalner, J. Richmond, C. Jonas, D.C. Capell, S. Allen, J. Casady, D. Grider, J. Palmour, IEEE Energy Conversion Congress and Exposition (ECCE), pp. 4145–4150 (2015).
S.-H. Ryu, C. Capell, E. Van Brunt, C. Jonas, M. O’Loughlin, J. Clayton, K. Lam, V. Pala, B. Hull, Y. Lemma, D. Lichtenwalner, Q. J. Zhang, J. Richmond, P. Butler, D. Grider, J. Casady, S. Allen, J. Palmour, M. Hinojosa, C. W. Tipton and C. Scozzie, Semicond. Sci. Technol. 30, 084001 (2015).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Lichtenwalner, D.J., Hull, B., Pala, V. et al. Performance and Reliability of SiC Power MOSFETs. MRS Advances 1, 81–89 (2016). https://doi.org/10.1557/adv.2015.57
Published:
Issue Date:
DOI: https://doi.org/10.1557/adv.2015.57