Abstract
Agglomeration of ceramics of partially stabilized zirconium dioxide containing 5 wt % of aluminum oxide depending on the amount of additive (iron oxide) was studied. It was shown that introduction of an additive promotes a decrease in agglomeration temperature to 1400–1450°С and formation of a dense structure, as well as acquisition of high strength up to 450 MPa (after agglomeration at 1400°С).
Similar content being viewed by others
References
Rödel, J., et al., Development of a roadmap for advanced ceramics: 2010–2025, J. Eur. Ceram. Soc., 2009, vol. 29, no. 9, pp. 1549–1560.
Deshmukh, R.M. and Kulkarni, S.S., A review on biomaterials in orthopedic bone plate application, Int. J. Curr. Eng. Technol., 2015, vol. 5, no. 4, pp. 2587–2591.
Andrianov, N.T., Balkevich, V.L., Belyakov, A.V., Vlasov, A.S., Guzman, I.Ya., Lukin, E.S., Mosin, Yu.M., and Skidan, B.S., Khimicheskaya tekhnologiya keramiki: uchebnoe posobie dlya vuzov (Chemical Technology of Ceramics: Manual for Higher Education Institutions), Moscow: Stroimaterialy, 2011.
Toug, A.M., Hassan, S.M., and Naga M., Toughening and strengthening of Nb2O5 doped zirconia/alumina (ZTA) composites, Int. J. Refract. Met. Hard Mater., 2015, vol. 48, pp. 338–345.
Singh, P., Influence of Bi2O3 additive on the electrical conductivity of calcia, J. Eur. Ceram. Soc., 2015, vol. 35, no. 5, pp. 1485–1493.
Flegler, A.J., Burye, T.E., Yang, Q., and Nicholas, J.D., Cubic yttria stabilized zirconia sintering additive impacts: a comparative study, Ceram. Int., 2014, vol. 40, no. 10, pp. 16323–16335.
Smirnov, V.V., Krylov, A.I., Smirnov, S.V., Goldberg, M.A., Antonova, O.S., Shvorneva, L.I., and Barinov, S.M., Study of liquid-phase sintering of materials based on zirconium dioxide containing alumina, Inorg. Mater.: Appl. Res., 2017, vol. 8, no. 1, pp. 81–83.
Galakhov, F.Ya., Diagrammy sostoyaniya sistem tugoplavkikh oksidov. Chast’ 1. Dvoinye sistemy (Diagrams of the State of Systems of Refractory Oxides, Part 1: Binary Systems), Leningrad: Nauka, 1985.
Flegler, A.J., et al., Cubic yttria stabilized zirconia sintering additive impacts: a comparative study, Ceram. Int., 2014, vol. 40, no. 10, pp. 16323–16335.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © V.V. Smirnov, T.O. Obolkina, A.I. Krylov, S.V. Smirnov, M.A. Gol’dberg, O.S. Antonova, D.D. Titov, S.M. Barinov, 2017, published in Materialovedenie, 2017, No. 7, pp. 45–48.
Rights and permissions
About this article
Cite this article
Smirnov, V.V., Obolkina, T.O., Krylov, A.I. et al. Agglomeration and Properties of Ceramics Based on Partially Stabilized Zirconium Dioxide Containing Oxides of Aluminum and Iron. Inorg. Mater. Appl. Res. 9, 121–124 (2018). https://doi.org/10.1134/S2075113318010252
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S2075113318010252