Skip to main content
Log in

Experimental characterization of novel SiC foam corrugated structured packing with varied pore size and corrugation angle

  • Published:
Journal of Engineering Thermophysics Aims and scope

Abstract

In our study, SiC foam material has been applied to produce corrugated structured packing in distillation. Three kinds of novel packing with different pore size and corrugation angle have been developed and tested in pilot scale, respectively, to investigate the influence of structural parameters on the performance of SiC foam corrugated structured packing. Hydraulic parameters including pressure drop for dry and wet packing and flooding velocity are determined in an organic glass tower of 600 mm internal diameter, using gas–water. Mass transfer efficiency (HETP) is measured by total reflux experiments in a column with a 310 mm diameter at atmospheric pressure, using a mixture of n-heptane and cyclohexane. The experimental results indicate that SFP-500YD3 with a smaller pore size has higher dry and wet pressure drop, lower flooding velocity and higher mass transfer efficiency compared with SFP-500Y-D5. SFP-500X-D3 with a 30° corrugation angle exhibits lowest pressure drop and highest separation efficiency among all three packings. This study reveals the influence of structural characteristics of SiC foam corrugated structured packing on its performance.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  1. Dai, C., Xiang, Y., and Lei, Z., Mass Transfer and Hydraulic Performance of CO2 Absorption by Ionic Liquids over Structured Packings, CIESC J., 2015, vol. 66, pp. 2953–2961.

    Google Scholar 

  2. Cong, H., Wang, C., Gao, X., Li, X., Li, H., and Pavlenko, A.N., Pressure Drop Simulation of Structured Corrugation Foam Packing by Computational Fluid Dynamics, J. Eng. Therm., 2016, vol. 25, pp. 301–313.

    Article  Google Scholar 

  3. Olujić, Ž., Kaibel, B., Jansen, H., Rietfort, T., and Zich, E., Fractionation Research Inc. Test Data and Modeling of a High-Performance Structured Packing, Ind. Eng. Chem. Res., 2013, vol. 52, pp. 4888–4894.

    Article  Google Scholar 

  4. Li, Q., Wang, T., Dai, C., and Lei, Z., Hydrodynamics of Novel Structured Packings: An Experimental and Multi-Scale CFD Study, Chem. Eng. Sci., 2016, vol. 143, pp. 23–35.

    Article  Google Scholar 

  5. Jing, W., Hua, W., Zhenzhen, H., and Jinyu, H., Electrodeposited Porous Pb Electrode with Improved Electrocatalytic Performance for the Electroreduction of CO2 to Formic Acid, Front.Chem. Sci. Eng., 2015, vol. 9, pp. 57–63.

    Article  Google Scholar 

  6. Masson, R., Keller, V., and Keller, N., β-SiC Alveolar Foams as a Structured Photocatalytic Support for the Gas Phase Photocatalytic Degradation of Methylethylketone, Appl. Catal., B, 2015, vols. 170/171, pp. 301–311.

    Article  Google Scholar 

  7. Labuschagne, J., Meyer, R., Chonco, Z.H., Botha, J.M., and Moodley, D.J., Application of Water-Tolerant Co/β-SiC Catalysts in Slurry Phase Fischer–Tropsch Synthesis, Catal. Today, 2016, vol. 275, pp. 2–10.

    Article  Google Scholar 

  8. Elamin, M.M., Muraza, O., Malaibari, Z., Ba, H., Nhut, J.-M., and Pham-Huu, C., Microwave Assisted Growth of SAPO-34 on β-SiC Foams for Methanol Dehydration to Dimethyl Ether, Chem. Eng. J., 2015, vol. 274, pp. 113–122.

    Article  Google Scholar 

  9. Sun, M., Chen, C., Chen, L., and Su, B., Hierarchically Porous Materials: Synthesis Strategies and Emerging Applications, Front. Chem. Sci. Eng., 2016, vol. 10, pp. 301–347.

    Article  Google Scholar 

  10. Li, X., Yan, P., Li, H., and Gao, X., Fabrication of Tunable, Stable, and Predictable Superhydrophobic Coatings on Foam CeramicMaterials, Ind. Eng. Chem. Res., 2016, vol. 55, pp. 10095–10103.

    Google Scholar 

  11. Xu, Z., Lu, Y., and Xie, Y., Hydrodynamic and Heat andMass Transfer Performances of Novel Ceramic Foam Packing to Humidification Tower, Appl. Therm. Eng., 2015, vol. 87, pp. 707–713.

    Article  Google Scholar 

  12. Lévêque, J., Rouzineau, D., Prévost, M., and Meyer, M., Hydrodynamic and Mass Transfer Efficiency of Ceramic Foam Packing Applied to Distillation, Chem. Eng. Sci., 2009, vol. 64, pp. 2607–2616.

    Article  Google Scholar 

  13. Lacroix, M., Nguyen, P., Schweich, D., Huu, C.P., Savin-Poncet, S., and Edouard, D., Pressure Drop Measurements and Modeling on SiC Foams, Chem. Eng. Sci., 2007, vol. 62, pp. 3259–3267.

    Article  Google Scholar 

  14. Grosse, J. and Kind, M., Hydrodynamics of Ceramic Sponges in Countercurrent Flow, Ind. Eng. Chem. Res., 2011, vol. 50, pp. 4631–4640.

    Article  Google Scholar 

  15. Pavlenko, A.N., Pecherkin, N.I., Chekhovich, V.Y., Zhukov, V.E., Sunder, S., and Houghton, Experimental Study of the Effect of Maldistribution at the Structured Packing Inlet on the Freon Mixture Separation Efficiency, Theor. Found. Chem. Eng., 2009, vol. 43, pp. 1–11.

    Article  Google Scholar 

  16. Stemmet, C., Bartelds, F., Van der Schaaf, J., Kuster, B., and Schouten, J., Influence of Liquid Viscosity and Surface Tension on the Gas–Liquid Mass Transfer Coefficient for Solid Foam Packings in Co-Current Two-Phase Flow, Chem. Eng. Res. Des., 2008, vol. 86, pp. 1094–1106.

    Article  Google Scholar 

  17. Stemmet, C., Jongmans, J., Van der Schaaf, J., Kuster, B., and Schouten, J., Hydrodynamics of Gas–Liquid Counter-Current Flow in Solid Foam Packings, Chem. Eng. Sci., 2005, vol. 60, pp. 6422–6429.

    Article  Google Scholar 

  18. Chen, T., Lin, Q., Xiong, L., Lü, Q., and Fang, C., Preparation and Characterization of Carbon Foams from Cyanate EsterMixtures, J. Anal. Appl. Pyrol., 2015, vol. 113, pp. 539–544.

    Article  Google Scholar 

  19. Weng, X., Hu, H., Lai, Z., Zhuang, D., and Ding, G., Analysis of Influence of Pore Density on Heat Transfer and Pressure Drop Characteristics ofWet Air inMetal Foams, CIESC J., 2016, vol. 67, pp. 2218–2223.

    Google Scholar 

  20. Pavlenko, A., Zhukov, V., Pecherkin, N., Chekhovich, V., Volodin, O., Shilkin, A., et al., Investigation of Flow Parameters and Efficiency of Mixture Separation on a Structured Packing, AIChE J., 2014, vol. 60, pp. 690–705.

    Article  Google Scholar 

  21. Li, H., Wang, F., Wang, C., Gao, X., and Li, X., Liquid Flow Behavior Study in SiC Foam Corrugated Sheet Using a Novel Ultraviolet Fluorescence Technique Coupled with CFD Simulation, Chem. Eng. Sci., 2015, vol. 123, pp. 341–349.

    Article  Google Scholar 

  22. Li, X., Liu, Q., Li, H., and Gao, X., Experimental Study on Liquid Flow Behavior in the Holes of SiC Structured Corrugated Sheets, J. Taiwan Inst. Chem. Eng., 2016, vol. 64, pp. 39–46.

    Article  Google Scholar 

  23. Liu, Q., Li, H., Gao, X., and Li, X., Liquid Flow Characteristics of Structured Corrugation SiC-Foam Packing Sheets, CIESC J., 2016, vol. 67, pp. 3340–3346.

    Google Scholar 

  24. Li, X., Gao, G., Zhang, L., Sui, H., Li, H., Gao, X., et al., Multiscale Simulation and Experimental Study of Novel SiC Structured Packings, Ind. Eng. Chem. Res., 2011, vol. 51, pp. 915–924.

    Article  Google Scholar 

  25. Zhang, J., Tian, C., Yang, Z., Cao, X., Liu, Q., Li, X. et al., A Preparation Methods and Application of SiC Ceramic Foam Structured Corrugated Packing, Institute ofMetal Research, 2010.

    Google Scholar 

  26. Qiao, Y., Gao, X., Li, H., and Li, X., Life Cycle Cost Evaluation of Structured Corrugation SiC-Foam Packing, CIESC J., 2016, vol. 67, pp. 3459–3467.

    Google Scholar 

  27. Yao, Y., Pavlenko, A.N., and Volodin, O.A., Effects of Layers and Holes on Performance of Wire Mesh Packing, J. Eng. Therm., 2015, vol. 24, pp. 222–236.

    Article  Google Scholar 

  28. Amini, Y., Karimi-Sabet, J., and Esfahany, M.N., Characterization of New Wire Gauze High-Capacity Structured Packing with Varied Inclination Angle, Chem. Eng. Technol., 2017, vol. 40, pp. 581–587.

    Article  Google Scholar 

  29. Li, H., Yao, Y., Wang, F., Gao, X., and Li, X., Effect of Liquid Flow Behavior on Performance of Corrugated Structured Packing, CIESC J., 2014, vol. 65, pp. 4760–4766.

    Google Scholar 

  30. Olujić, Ž., Seibert, A.F., and Fair, J.R., Influence of Corrugation Geometry on the Performance of Structured Packings: An Experimental Study, Chem. Eng. Prog., 1991, vol. 39, pp. 335–342.

    Article  Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to X. Gao.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Li, X., Shi, Q., Li, H. et al. Experimental characterization of novel SiC foam corrugated structured packing with varied pore size and corrugation angle. J. Engin. Thermophys. 26, 452–465 (2017). https://doi.org/10.1134/S1810232817040026

Download citation

  • Received:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1134/S1810232817040026

Navigation