Abstract
The hardness values of samples of ferritic–martensitic steel Eurofer 97 in the initial state and after irradiation with 5.6 MeV Fe2+ ions up to a fluence of 1 × 1016 cm–2 at a temperature of 300°C are compared. The mechanical properties are tested by the method of instrumental indentation using the dynamic mechanical analysis technique. To correct the obtained hardness values, the geometry of the plastic imprints is measured by the method of atomic force microscopy. Irradiation with heavy ions gives rise to an increase in the hardness value in comparison with the initial sample. This indicates a radiation-induced decrease in the plasticity of steel Eurofer 97, which should be taken into account in the case of using it as a construction material for new-generation fusion reactors.
Similar content being viewed by others
REFERENCES
J. Schlosser, Nucl. Fusion 45 (6), 512 (2005).
M. Channel, in Proc. Particle Accelerator Conference (Chicago, 2001).
E. Gaganidze, H.-C. Schneider, B. Dafferner, and J. Aktaa, J. Nucl. Mater. 355, 83 (2006).
S. V. Rogozhkin, A. A. Nikitin, and T. V. Kulevoi, Yad. Fiz. Inzhiniring 5 (7–8), 663 (2014).
W. C. Oliver and G. M. Pharr, J. Mater. Res. 7 (6), 1564 (1992).
A. C. Fischer-Cripps, Nanoindentation (Springer, New York, 2011).
GOST (State Standard) No. 9450-76 (ST SEV 1195-78): Measurements Microhardness by Diamond Instruments Indentation (Izd. Standartov, Moscow, 1996).
V. K. Grigorovich, Hardness and Microhardness of Metals (Nauka, Moscow, 1976) [in Russian].
G. N. Kropachev, V. B. Shishmarev, R. P. Kuibida, B. B. Chalykh, S. V. Plotnikov, S. V. Rogozhkin, A. A. Aleev, A. A. Nikitin, N. N. Orlov, D. N. Seleznev, et al., Yad. Fiz. Inzhiniring 2 (6), 538 (2011).
A. S. Useinov, K. S. Kravchuk, and I. I. Maslenikov, Nanoindustriya, No. 1, 34 (2014).
W. D. Nix and H. Gao, J. Mech. Phys. Solids 46 (3), 411 (1998).
I. Manika and J. Maniks, J. Phys. D: Appl. Phys. 41 (7) (2008).
C. Xu, L. Zhang, W. Qian, J. Mei, and X. Liu, Nucl. Eng. Technol. 48 (3), 758 (2016).
F. Zhang, Y. Huang, and K. C. Hwang, Acta Mech. Sin./Lixue Xuebao 22 (1), 1 (2006).
ACKNOWLEDGMENTS
This work was supported by the Russian Science Foundation, project no. 17-19-01696. The samples of steel Eurofer 97 were irradiated using the facilities of the Center for Collective Use KAMIKS (http:// kamiks.itep.ru/) of the National Research Center Kurchatov Institute–Institute of Theoretical and Experimental Physics. The mechanical properties were analyzed using equipment of the Center for Collective Use “Investigation of Nanostructured, Carbon, and Superhard Materials” (http://www.tisncm.ru/suec/) of the Technological Institute for Superhard and Novel Carbon Materials.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by O. Kadkin
Rights and permissions
About this article
Cite this article
Gladkikh, E.V., Kravchuk, K.S., Useinov, A.S. et al. A Study of the Effect of Ion Irradiation on the Mechanical Properties of Eurofer 97 Steel. J. Surf. Investig. 13, 48–52 (2019). https://doi.org/10.1134/S1027451019010075
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S1027451019010075