Abstract
A method to produce a technically suitable, hard-magnetic material of composition Fe–26% Cr–16% Co–2% Mo–2% W from a powder raw material was proposed. A distinguishing feature of the method is a reduced temperature of sintering of powder compacts (1200°C). The sintered samples are subjected to hot rolling. The magnetic and strength characteristics of the thus obtained magnetic material are on the level of those of alloys produced by powder metallurgy at a sintering temperature of about 1400°C and their cast analogs. Data on the magnetic hysteresis and strength properties of the synthesized material were presented.
Similar content being viewed by others
References
Szymura, S. and Sojka, L., J. Mater. Sci., 1979, no. 14, pp. 1890–1892.
Belyatskaya, I.S., Dokl. Akad. Nauk SSSR, 1982, vol. 266, no. 2, pp. 331–334.
Kubota, T., Wakui, G., and Itakagi, M., IEEE Trans. Magn., 1998, vol. 34, no. 6, pp. 3888–3896.
Artamonov, E.V., Libman, M.A., and Rudanovskii, N.N., Steel Transl., 2007, vol. 37, no. 6, pp. 547–551.
Libman, M.A., Materialovedenie, 2010, no. 9, pp. 58–64.
Zhen Liang, Sun Xue-yin, Xu Cheng-yan, et al. Trans. Non-Ferrous Met. Soc. China, 2007, vol. 17, pp. 346–350.
Belozerov, E.V., Mushnikov, N.V., Ivanova, G.V., et al., Phys. Met. Metallogr., 2012, vol. 113, no. 4, pp. 319–325.
Green, M.L., Sherwood, R.C., and Wong, C.C., J. Appl. Phys., 1982, vol. 53, no. 3, pp. 2398–2400.
Shatsov, A.A., Met. Sci. Heat Treat., 2004, vol. 46, pp. 152–155.
Alymov, M.I., Ankudinov, A.B., Zelenskii, V.A., Milyaev, I.M., Yusupov, V.S., and Ustyukhin, A.S., Fiz. Khim. Obrab. Mater., 2011, no. 3, pp. 34–38.
Schiller, S., Heisig, U., and Panzer, S., Electron Beam Technology, New York: Wiley, 1982.
Ustyukhin, A.S., Alymov, M.I., and Milyaev, I.M., Pis’ma o Mater., 2014, vol. 4, no. 1, pp. 59–61.
Ustyukhin, A.S., Alymov, M.I., Krishenik, P.M., Levinskii, Yu.V., and Rogachev, S.A., Fiz. Khim. Obrab. Mater., 2016, no. 3, pp. 46–51.
Schastlivtsev, V.M., Mirzaev, D.A., Yakovleva, I.L., Tereshchenko, N.A., and Tabatchikova, T.I., Dokl. Phys., 2010, vol. 55, no. 7, pp. 334–337.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Ustyukhin, A.S., Ankudinov, A.B., Zelenskii, V.A. et al. Improvement of magnetic properties by hot rolling of sintered powder alloy in the Fe–Cr–Co system. Dokl Phys Chem 476, 193–196 (2017). https://doi.org/10.1134/S0012501617100074
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S0012501617100074