Abstract
This paper presents the experimental results of bond and anchorage behaviours under Steel Strap Tensioning Technique (SSTT) confined high-strength concrete (HSC). The experimental tests consisted of pull-out test with short bond length and pull-out test with long bond length were performed to determine the bonding and anchorage capacity of SSTT-confined HSC. A total 36 specimens with short bond length and 16 specimens with long bond length were tested in this study. Three batches of concrete with compressive strength of 30 MPa, 60 MPa and 90 MPa were tested. Other parameter in this study was rebar diameter of 12 mm and 16 mm and different SSTT confinement ratios ranging from 0 to 0.2. To determine the effects of confinement on development bond and anchorage, an analytical expression was developed based on the parameters tested in this study. The equation is then verified with the bond strength proposed by the existing bond equations. The results from conducted tests indicated that the application of SSTT as an external confinement can increase the bond strength of confined concrete by up to 50%.
Similar content being viewed by others
References
Lv X, Yu Z, Shan Z (2021) Bond stress-slip model for rebar-concrete interface under monotonic and cyclic loading. Structures 34:498–506. https://doi.org/10.1016/j.istruc.2021.07.093
Torre-Casanova A, Jason L, Davenne L, Pinelli X (2013) Confinement effects on the steel–concrete bond strength and pull-out failure. Eng Fract Mech 97:92–104. https://doi.org/10.1016/j.engfracmech.2012.10.013
ACI 408, ACI R408-03 (2003) Bond and development of straight reinforcing bars in tension. American Concrete Institute, Farmington Hills
Choi E, Chung Y-S, Park C, Kim DJ (2013) Seismic performance of circular RC columns retrofitted with prefabricated steel wrapping jackets. Mag Concr Res 65(23):1429–1440. https://doi.org/10.1680/macr.13.00177
Bamonte PF, Gambarova PG (2007) High-bond bars in NSC and HPC: study on size effect and on the local bond stress-slip law. J Struct Eng 133(2):225–234. https://doi.org/10.1061/(ASCE)0733-9445(2007)133:2(225)
Yang Y, Xue Y, Wang N, Yu Y (2019) Experimental and numerical study on seismic performance of deficient interior RC joints retrofitted with prestressed high-strength steel strips. Eng Struct 190:306–318. https://doi.org/10.1016/j.engstruct.2019.03.096
Zhang D, Li N, Li Z-X, Xie L (2020) Experimental investigation and confinement model of composite confined concrete using steel jacket and prestressed steel hoop. Constr Build Mater 256:119399. https://doi.org/10.1016/j.conbuildmat.2020.119399
Janwaen W, Barros JA, Costa IG (2019) A new strengthening technique for increasing the load carrying capacity of rectangular reinforced concrete columns subjected to axial compressive loading. Compos B Eng 158:67–81. https://doi.org/10.1016/j.compositesb.2018.09.045
Sulaiman MF, Ma C-K, Apandi NM, Chin S, Awang AZ, Mansur SA, Omar W (2017) A review on bond and anchorage of confined high-strength concrete. Structures 11:97–109. https://doi.org/10.1016/j.istruc.2017.04.004
Lin H, Zhao Y, Ozbolt J, Feng P, Jiang C, Eligehausen R (2019) Analytical model for the bond stress-slip relationship of deformed bars in normal strength concrete. Constr Build Mater 198:570–586. https://doi.org/10.1016/j.conbuildmat.2018.11.258
Tastani SP, Pantazopoulou SJ (2010) Direct tension pullout bond test: experimental results. J Struct Eng 136(6):731–743. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000159
Frangou M, Pilakoutas K, Dritsos S (1995) Structural repair/strengthening of RC columns. Constr Build Mater 9(5):259–266. https://doi.org/10.1016/0950-0618(95)00013-6
Awang AZ (2013) Stress-strain behaviour of high-strength concrete with lateral pre-tensioning confinement. Universiti Teknologi Malaysia, Johor Bahru
Ma C-K, Awang AZ, Garcia R, Omar W, Pilakoutas K (2016) Behaviour of over-reinforced high-strength concrete beams confined with post-tensioned steel straps—an experimental investigation. Struct Concr 17(5):768–777. https://doi.org/10.1002/suco.201500062
Chen Q, Shin M, Andrawes B (2014) Experimental study of non-circular concrete elements actively confined with shape memory alloy wires. Constr Build Mater 61:303–311. https://doi.org/10.1016/j.conbuildmat.2014.02.076
Chin C-L, Ma C-K, Awang AZ, Tan J-Y, Ong C-B, Omar W (2019) Confining stress path dependent stress-strain model for pre-tensioned steel-confined concrete. Eng Struct 201:109769. https://doi.org/10.1016/j.engstruct.2019.109769
Apandi N, Ma C-K, Awang AZ, Omar W (2021) Structural behaviour of pre-damaged RC columns immediate repaired employing pre-tensioned steel straps. Structures 34:964–978. https://doi.org/10.1016/j.istruc.2021.08.039
Ma C-K, Awang AZ, Omar W (2018) Eccentricity-based design procedure of confined columns under compression and in-plane bending moment. Measurement 129:11–19. https://doi.org/10.1016/j.measurement.2018.07.012
Moghaddam H, Samadi M, Pilakoutas K, Mohebbi S (2010) Axial compressive behavior of concrete actively confined by metal strips; part A: experimental study. Mater Struct 43(10):1369–1381. https://doi.org/10.1617/s11527-010-9588-6
Awang AZ, Omar W, Ma C, Liang M (2013) Design of short SSTT-confined circular HSC columns. Int J Res Eng Technol 2(8):331–336
Ma C-K, Awang AZ, Omar W, Maybelle L (2014) Experimental tests on SSTT-confined HSC columns. Mag Concr Res 66(21):1084–1094
Helal Y, Garcia R, Pilakoutas K, Guadagnini M, Hajirasouliha I (2016) Strengthening of short splices in RC beams using post-tensioned metal straps. Mater Struct 49(1):133–147. https://doi.org/10.1617/s11527-014-0481-6
British Standards Institution, BS EN 12390-3:2009. Testing hardened concrete. Part 3: Compressive strength of test specimens, BSI2009
ASTM E8/E8M-21 (2021) Standard test methods for tension testing of metallic materials. ASTM, West Conshohocken
Orangun CO, Jirsa JO, Breen JE (1977) A reevaulation of test data on development length and splices. ACI J Proc. https://doi.org/10.14359/10993
Darwin D, McCabe SL, Idun EK, Schoenekase SP (1992) Development length criteria: bars not confined by transverse reinforcement. ACI Struct J. https://doi.org/10.14359/4158
Esfahani MR, Rangan BV (1998) Local bond strength of reinforcing bars in normal strength and high-strength concrete (HSC). ACI Struct J. https://doi.org/10.14359/530
Acknowledgements
This work was funded by Fundamental Research Grant Scheme (FRGS) from Ministry of Higher Education, Malaysia [R.J130000.7851.5F176], UTMShine Grant [Q.J130000.2451.09G87], as well as GUP Grant [Q.J130000.2651.16J31].
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Sulaiman, M.F., Chin, CL., Ma, CK. et al. Pullout Behaviour of Bars in Concrete Confined with Post-tensioned Steel Straps. Int J Civ Eng 20, 709–720 (2022). https://doi.org/10.1007/s40999-021-00690-0
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s40999-021-00690-0