Skip to main content
SpringerLink
Log in

Geometric Design Consistency Model for Evaluating Safety at Horizontal Curves on Two-Lane Rural Highways Under Mixed Traffic Conditions

  • ORIGINAL CONTRIBUTION
  • Published:
Journal of The Institution of Engineers (India): Series A Aims and scope Submit manuscript

Abstract

Horizontal curves are considered critical sections, where traffic safety is of at most concern due to sight distance restriction. In this study, the free flow speed data of each vehicle type were collected on multiple zones along 18 horizontal curves for which sight distance was restricted. A trap length of 15 m was marked in the field at five zones along each curve, and by using videographic survey, each vehicle was traced on these five zones and free flow speed data were extracted. A total of 3042 free-flowing vehicles (i.e. headway > 8 s) speeds were extracted and used in the analysis. The 85th percentile speed reduction model for each vehicle type from tangent section to curved sections is developed for evaluating design consistency as a surrogate measure of safety. Results show that the significant parameters obtained are radius, 85th percentile tangent speed, and minimum available sight distance. This study also suggested the procedure to adopt variable safe speed limits for each vehicle type based on design consistency model developed, which can be used as a prior warning information to enhance safety on horizontal curves.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8

Similar content being viewed by others

References

  1. S.K.S. Abbas, M.A. Adnan, I.R. Endut, Exploration of 85th percentile operating speed model on horizontal curve: a case study for two-lane rural highways. Proc. Soc. Behav. Sci. 16, 352–363 (2011)

    Article  Google Scholar 

  2. Al-Masaeid, H. R., Hamed, M., Aboul-Ela, M., & Ghannam, A. G. 1995. Consistency of horizontal alignment for different vehicle classes. Transportation Research Record, 1500

  3. American Association of State Highway and Transport Officials, Highway safety manual 2014 (AASHTO, Washington, 2014)

    Google Scholar 

  4. O. Carsten, Multiple perspectives, in Human factors for highway engineers. ed. by R. Fuller, J.A. Santos (Elsevier, New York, 2002), pp.11–22

    Google Scholar 

  5. P.M. Chaudhari, J. Goyani, S. Arkatkar, G. Joshi, S.M. Easa, Design consistency evaluation of two-lane rural highways in hilly terrains. Transp. Res. Proc. 62, 75–82 (2022)

    Google Scholar 

  6. K.L. Fink, R.A. Krammes, Tangent length and sight distance effects on accident rates at horizontal curves on rural two-lane highways. Transp. Res. Rec. 1500, 162–168 (1995)

    Google Scholar 

  7. G.M. Gibreel, S.M. Easa, Y. Hassan, I.A. El-Dimeery, State of the art of highway geometric design consistency. J. Transp. Eng. 125(4), 305–313 (1999)

    Article  Google Scholar 

  8. D.T. Godumula, K.V.R. Ravi Shankar, Safety evaluation of horizontal curves on two lane rural highways using machine learning algorithms: a priority-based study for sight distance improvements. Traffic Inj. Prev. 24(4), 331–337 (2023)

    Article  Google Scholar 

  9. IRC:38-1988.1989. Guidelines for design of horizontal curves for highways and design tables. New Delhi, India: Indian Road Congress.

  10. A. Jacob, M.V.L.R. Anjaneyulu, Operating speed of different classes of vehicles at horizontal curves on two-lane rural highways. J. Transp. Eng. 139(3), 287–294 (2013)

    Article  Google Scholar 

  11. A. Jacob, R. Dhanya, M.V.L.R. Anjaneyulu, Geometric design consistency of multiple horizontal curves on two-lane rural highways. Proc. Soc. Behav. Sci. 104, 1068–1077 (2013)

    Article  Google Scholar 

  12. N.M. Jesna, M.V.L.R. Anjaneyulu, Reliability analysis of horizontal curves on two lane highways. Transp. Res. Proc. 17, 107–115 (2016)

    Google Scholar 

  13. R.A. Krammes, Interactive highway safety design model: M. Public Roads 61, 47 (1997)

    Google Scholar 

  14. R. Lamm, B. Psarianos, T. Mailaender, Highway design and traffic safety engineering handbook (McGraw-Hill Companies Inc, New York, 1999)

    Google Scholar 

  15. A. Maji, A. Tyagi, Speed prediction models for car and sports utility vehicle at locations along four-lane median divided horizontal curves. J. Mod. Transp. 26(4), 278–284 (2018)

    Article  Google Scholar 

  16. V. Malaghan, D.S. Pawar, H. Dia, Modeling operating speed using continuous speed profiles on two-lane rural highways in India. J. Transp. Eng. Part A: Syst. 146(11), 04020124 (2020)

    Article  Google Scholar 

  17. H. W. McGee, F. R. Hanscom, Low-cost treatments for horizontal curve safety (Publication No. FHWA-SA-07-002). Federal Highway Administration, US Department of Transportation, Washington, (2006)

  18. R.A. Memon, G.B. Khaskheli, M.A. Dahani, Estimation of operating speed on two lane two way roads along N-65 (SIBI–Quetta), (2012)

  19. Ministry of infrastructures and transports, 2001.Functional and geometrical guidelines for road construction M.D.

  20. Ministry of road transport & highways (MoRT&H). 2021. Road accidents in India 2021. New Delhi: Ministry of road transport & highways, Government of India

  21. C.M. Poe, J.P. Tarris, J.M. Mason Jr., Relationship of operating speed to roadway geometric design speed. Report FHWA-RD-96-024 (U.S Department of Transportation, Federal Highway Administration, Washington, 1996)

    Google Scholar 

  22. L. Richl, T. Sayed, Evaluating the safety risk of narrow medians using reliability analysis. J. Transp. Eng. 132(5), 366–375 (2006)

    Article  Google Scholar 

  23. R.D.K. Shallam, M.A. Ahmed, Operating speed models on horizontal curves for two-lane highways. Transp. Res. Proc. 17, 445–451 (2016)

    Google Scholar 

  24. A. Shariat-Mohaymany, A. Tavakoli-Kashani, H. Nosrati, A. Ranjbari, Identifying significant predictors of head-on conflicts on two-lane rural roads using inductive loop detectors data. Traffic Inj. Prev. 12(6), 636–641 (2011)

    Article  Google Scholar 

  25. G. Sil, A. Maji, S. Nama, A.K. Maurya, Operating speed prediction model as a tool for consistency based geometric design of four-lane divided highways. Transport 34(4), 425–436 (2019)

    Article  Google Scholar 

  26. R. Srinivasan, J. Baek, D.L. Carter, B. Persaud, C. Lyon, K.A. Eccles, N. Lefler, Safety evaluation of improved curve delineation (No. FHWA-HRT-09-045). United States. Federal Highway Administration, (2009)

  27. D.J. Torbic, D.W. Harwood, D.K. Gilmore, R. Pfefer, T.R. Neuman, K.L. Slack, K.K. Hardy, Guidance for implementation of the AASHTO strategic highway safety plan. Volume 7: A guide for reducing collisions on horizontal curves (No. Project G17-18 (3) FY’00), (2004)

  28. K.K. Tottadi, C. Varma, A. Mehar, Influence of horizontal curve geometry on operating speeds on four-lane divided highways under heterogeneous traffic conditions. J. Inst. Eng. (India) Ser. A 103(4), 1135–1145 (2022)

    Article  Google Scholar 

  29. P. Watters, M. O’Mahony, The relationship between geometric design consistency and safety on rural single carriageways in Ireland. In Proc., European Transport Conference. Leiden, Netherlands: Association for European Transport, London (2007)

  30. M.D. Wooldridge, K. Fitzpatrick, D.W. Harwood, I.B. Potts, L. Elefteriadou, D.J. Torbic, Geometric design consistency on high-speed rural two-lane roadways, Rep 502 (National Corporative Highway Research Program, Transportation Research Board, Washington, 2003)

    Google Scholar 

  31. K. You, L. Sun, W. Gu, Reliability-based risk analysis of roadway horizontal curves. J. Transp. Eng. 138(8), 1071–1081 (2012)

    Article  Google Scholar 

Download references

Funding

The authors have not disclosed any funding.

Author information

Authors and Affiliations

  1. Civil Engineering Department, National Institute of Technology Warangal, Warangal, India

    Dharma Teja Godumala & K. V. R. Ravi Shankar

Authors
  1. Dharma Teja Godumala
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. K. V. R. Ravi Shankar
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Dharma Teja Godumala.

Ethics declarations

Conflict of interest

The authors declare that they have no conflict of interest.

Additional information

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Godumala, D.T., Ravi Shankar, K.V.R. Geometric Design Consistency Model for Evaluating Safety at Horizontal Curves on Two-Lane Rural Highways Under Mixed Traffic Conditions. J. Inst. Eng. India Ser. A (2024). https://doi.org/10.1007/s40030-024-00794-5

Download citation

  • Received:

  • Accepted:

  • Published:

  • DOI: https://doi.org/10.1007/s40030-024-00794-5

Keywords

Search

Navigation