Abstract
Characterization of the engineering behavior of unsaturated soil is dependent on the soil–water characteristic curve (SWCC), a graphical representation of the relationship between water content or degree of saturation and soil suction. A reasonable description of the SWCC is thus important for the accurate prediction of unsaturated soil parameters. The measurement procedure for determining the SWCC, however, is difficult, expensive, and time-consuming. During the past few decades, researchers have laid a major focus on developing empirical equations for predicting the SWCC, with a large number of empirical models suggested. One of the most crucial questions is how precisely existing equations can represent the SWCC. As different models have different ranges of capability, it is essential to evaluate the precision of the SWCC models used for each particular soil type for better SWCC estimation. It is expected that better estimation of SWCC would be achieved via a thorough statistical consistency analysis of its applicability within a particular soil class. This paper evaluates the consistency and applicability of using four different SWCC equations for defining the relationship between water content and soil suction. Optimization techniques were used to obtain the best fit of the model parameters for three main soil classes: coarse-textured (i.e., sand), medium-textured (i.e., silt), and fine-textured (i.e., clay) soils. The four SWCC models were evaluated and computed for each sample. The results show that the Brooks and Corey model and modified Gardner model was the most consistent in describing the SWCC for sand soils and clay soils, respectively. Both model predictions also exhibit compatibility with samples ranging from low to high soil water content.
Similar content being viewed by others
References
Chiu C.F., Yan W.M., Yuen K.V.: Reliability analysis of soil-water characteristics curve and its application to slope stability analysis. Eng. Geol. 135(136), 83–91 (2012)
Bumb A.C., Murphy C.L., Everett L.G.: A comparison of three functional forms for representing soil moisture characteristics. Groundwater 30(2), 177–185 (1992)
Leij F.J., Russell W.B., Lesch S.M.: Closed-form expressions for water retention and conductivity data. Groundwater 35, 848–858 (1997)
Mace A., Rudolph D.L., Kachanoski R.G.: Suitability of parametric models to describe the hydraulic properties of an unsaturated coarse sand and gravel. Groundwater 36(3), 465–475 (1998)
Sillers W.S., Fredlund D.G.: Statistical assessment of soil-water characteristic curve models for geotechnical engineering. Can. Geotech. J. 38(6), 1297–1313 (2001)
Cornelis W.M., Khlosi M., Hartmann R., Van Meirvenne M., De Vos B.: Comparison of unimodal analytical expressions for the soil-water retention curve. Soil Sci. Soc. Am. J. 69(1), 1902–1911 (2005)
Khlosi M., Cornelis W.M., Douaik A., Van Genuchten M.T.: Performance evaluation of models that describe the soil-water retention curve between saturation and oven dryness. Vadose Zone J. 7, 87–96 (2008)
Van Genuchten M.T.: A closed-form equation for predicting the hydraulic conductivity of unsaturated soils. Soil Sci. Soc. Am. J. 44(5), 892–898 (1980)
Fredlund D.G., Xing A.: Equations for the soil-water characteristic curve. Can. Geotech. J. 31, 521–532 (1994)
Gardner, W.R.: Mathematics of isothermal water conduction in unsaturated soils. In: Highway Research Board Special Report 40 International Symposiums on Physico-Chemical Phenomenon in Soils, Washington, DC, pp. 78-87 (1956)
Akaike H.: New look at the statistical-model identification. IEEE Trans. Autom. Control 19, 667–673 (1974)
Kosugi K.: Lognormal distribution model for unsaturated soil hydraulic properties. Water Resour. Res. 32(9), 2697–2703 (1996)
Nimmo J.R., Herkelrath W.N., Laguna Luna A.M.: Physically based estimation of soil water retention from textural data: general framework, new models, and streamlined existing models. Vadose Zone J. 6(4), 766–773 (2007)
Leong E.C., Rahardjo H.: Review of soil water characteristic curve equations. J. Geotech. Geoenviron. Eng. 123(12), 1106–1117 (1997)
Brooks, R.; Corey, A.: Hydraulic properties of porous media. Hydrology Paper No. 3, Colorado State University (1964)
Nimmo J.R.: Comment on the treatment of residual water content in “A consistent set of parametric models for the two-phase flow of immiscible fluids in the subsurface” by L. Luckner et al. Water Resour. Res. 27(4), 661–662 (1991)
Rossi C., Nimmo J.R.: Modeling of soil water retention from saturation to oven dryness. Water Resour. Res. 30(3), 701–708 (1994)
Matlan, S.J.; Mukhlisin, M.; Taha, M.R.: Performance evaluation of four-parameter models of the soil-water characteristic curve. Sci. World J. Article ID 569851, 1–12 (2014). doi:10.1155/2014/569851
Sillers W.S., Fredlund D.G., Zakerzadeh N.: Mathematical attributes of some soil-water characteristic curve models. Geotech. Geol. Eng. 19(3-4), 243–283 (2001)
Nemes A., Schaap M.G., Leij F.J., Wosten J.H.M.: Description of the unsaturated soil hydraulic database UNSODA version 2.0. J. Hydrol. 251, 151–162 (2001)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Matlan, S.J., Taha, M.R. & Mukhlisin, M. Assessment of Model Consistency for Determination of Soil–Water Characteristic Curves. Arab J Sci Eng 41, 1233–1240 (2016). https://doi.org/10.1007/s13369-015-1888-2
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s13369-015-1888-2