Abstract
Grouting techniques have been extensively and effectively implemented to prevent water bursts originating from limestone aquifers in underground mining. Using widely employed grout with time-varying viscosity, promoting the effective propagation of slurry in fractures, especially fractures with narrow apertures, and improving the grouting efficiency (GE) are critical issues that remain unsolved. In this study, an experimental investigation of the fracture GE was conducted considering the dynamically changing injection pressure for viscosity--time-dependent grout using a fracture model constructed from acrylic glass. Three grouting pressure adjustment schemes (periodic-increasing pressure, constant pressure and periodic-reducing pressure) and two narrow hydraulic apertures (200 and 250 μm) were selected for testing. Each trial utilizing the fracture replica was filmed, allowing the advancing slurry to be analyzed versus the propagation distance over time. The measured penetration lengths and fracture GE were then compared with the simulation data. The measured penetration length versus time curves agreed well with the theoretical data. Moreover, the pressure adjustment mode and grout rheology significantly impacted the GE. In general, the periodic increases in pressure reduced the GE, which decreased by 4.16% and 10.19% for the slow- and rapid-growth viscosity grouts (G1 and G2), respectively. However, phase reduction of the pressure considerably enhanced the GE. Relative grouting efficiency (RGE) was increased by 3.18% and 10.08% for G1 and G2, respectively, indicating that a step-by-step reduction in the injection pressure can effectively improve the GE for the remarkable rheological grout during the grouting process. Additionally, the tests suggested that the hydraulic aperture width has an unclear effect on the GE of microfissures.
Similar content being viewed by others
References
Agapoulaki GI, Papadimitriou AG (2018) Rheological properties of colloidal silica grout for passive stabilization against liquefaction. J Mater Civil Eng 30(10):04018251
Amadei B, Savage WZ (2001) An analytical solution for transient flow of Bingham viscoplastic materials in rock fractures. Int J Rock Mech Min Sci 38(2):285–296
Axelsson M, Gustafson G, Fransson Å (2009) Stop mechanism for cementitious grouts at different water-to-cement ratios. Tunn Undergr Sp Tech 24(4):390–397
Cheng JL, Sun XY, Zheng G, Gao F, Kong XR, Zhou J (2013) Numerical simulations of water-inrush induced by fault activation during deep coal mining based on fluid-solid coupling interaction. Disaster Adv 6(11):10–14
Dai G, Bird RB (1981) Radial flow of a Bingham fluid between two fixed circular disks. J Non-newton Fluid Mech 8(3):349–355
Funehag J, Fransson A (2006) Sealing narrow fractures with a Newtonian fluid: model prediction for grouting verified by field study. Tunn Undergr Sp Tech 21(5):492–498
Funehag J, Gustafson G (2008a) Design of grouting with silica sol in hard rock—new methods for calculation of penetration length, part I. Tunn Undergr Sp Tech 23(1):1–8
Funehag J, Gustafson G (2008b) Design of grouting with silica sol in hard rock—new design criteria tested in the field, part II. Tunn Undergr Sp Tech 23(1):9–17
Funehag J, Thorn J (2018) Radial penetration of cementitious grout: Laboratory verification of grout spread in a fracture model. Tunn Undergr Sp Tech 72(2018):228–232
Guo WJ, Wang HL, Chen SJ (2016) Coal pillar safety and surface deformation characteristics of wide strip pillar mining in deep mine. Arab J Geosci 9(2):137
Guo WJ, Zhao JH, Yin LM, Kong DZ (2017) Simulating research on pressure distribution of floor pore water based on fluid-solid coupling. Arab J Geosci 10(1):5
Gustafson G, Stille H (1996) Prediction of groutability from grout properties and hydrogeological data. Tunn Undergr Sp Tech 11(3):325–332
Hassler L, Hakansson U, Stille H (1992) Computer-simulated flow of grouts in jointed rock. Tunn Undergr Sp Tech 7(4):441–446
Huang WP, Li C, Zhang LW, Yuan Q, Zheng YS, Liu Y (2018) In situ identification of water-permeable fractured zone in overlying composite strata. Int J Rock Mech Min 105:85–97
Li SC, Han WW, Zhang QS, Liu RT, Weng XJ (2013) Research on time-dependent behavior of viscosity of fast curing grouts in underground construction grouting. Chin J Rock Mech Eng 32(1):1–7 (in Chinese)
Li SC, Zhang WJ, Zhang QS, Zhang X, Liu RT, Pan GM, Li ZP, Che ZY (2014) Research on advantage-fracture grouting mechanism and controlled grouting method in water-rich fault zone. Chin J Rock Mech Eng 35(3):744–752 (in Chinese)
Li LY, Wei JC, Yin HY, Xie J, Ding YS, Shi SQ (2018a) Influence of sedimentary facies on reservoir quality and distribution of diagenetic features in the Funing Formation, Wanglongzhuang Oilfield, Subei Basin, Eastern China. Arab J Geosci 11(15):432
Li ZX, Wang DD, Lv DW, Li Y, Liu HY, Wang PL, Liu Y, Liu JQ, Li DD (2018b) The geologic settings of Chinese coal deposits. Int Geol Rev 60(5–6):548–578
Li H, Bai HB, Wu JJ, Meng QB, Ma K, Wu LY, Meng FF, Wang SJ (2019a) A Set of Methods to Predict Water Inrush from an Ordovician Karst Aquifer: a case study from the Chengzhuang Mine. China Mine Water Environ 38(1):39–48
Li WT, Yang N, Mei YC, Zhang YH, Wang L, Ma HY (2019b) Experimental investigation of the compression-bending property of the casing joints in a concrete filled steel tubular supporting arch for tunnel engineering. Tunn Undergr Sp Tech. https://doi.org/10.1016/j.tust.2019.103184
Littlejohn GS (1975) Acceptable water flows for rock anchor grouting. Ground Eng 8(2):46–48
Lu YL, Wang LG (2015) Numerical simulation of mining-induced fracture evolution and water flow in coal seam floor above a confined aquifer. Comput Geotech 67:157–171
Mohajerani S, Baghbanan A, Bagherpour R, Hashemolhosseini H (2015) Grout penetration in fractured rock mass using a new developed explicit algorithm. Int J Rock Mech Min Sci 80:412–417
Mohammed MH, Pusch R, Knutsson S (2015) Study of cement-grout penetration into fractures under static and oscillatory conditions. Tunn Undergr Sp Tech 45:10–19
Pedrotti M, Wong C, El Mountassir G, Lunn RJ (2017) An analytical model for the control of silica grout penetration in natural groundwater systems. Tunn Undergr Sp Tech 70:105–113
Shi SQ, Wei JC, Xie DL, Yin HY, Li LY (2019) Prediction analysis model for groundwater potential based on set pair analysis of a confined aquifer overlying a mining area. Arab J Geosci 12(4):115
Sui WH, Liu JY, Hu W, Qi JF, Zhan KY (2015) Experimental investigation on sealing efficiency of chemical grouting in rock fracture with flowing water. Tunn Undergr Sp Tech 50(1):239–249
Sun WJ, Wu Q, Liu HL, Jiao J (2015) Prediction and assessment of the disturbances of the coal mining in Kailuan to karst groundwater system. Phys Chem Earth Parts A/B/C 89–90:136–144
Sun ZZ, Yan X, Liu RT, Xu ZH, Li SC, Zhang YM (2018) Transient analysis of grout penetration with time-dependent viscosity Inside 3D fractured rock mass by unified pipe-network method. Water 10(9):1122
Tan YL, Ning JG, Li HT (2012) In situ explorations on zonal disintegration of roof strata in deep coalmines. Int J Rock Mech Min Sci 49:113–124
Tan YL, Zhao TB, Xiao YX (2010) In situ investigations of failure zone of floor strata in mining close distance coal seams. Int J Rock Mech Min 47(5):865–870
Wang DD, Shi LQ (2019) Source identification of mine water inrush: a discussion on the application of hydrochemical method. Arab J Geosci 12(2):58
Wang G, Han W, Jiang YJ, Luan HJ, Wang K (2019) Coupling analysis for rock mass supported with CMC or CFC rockbolts based on viscoelastic method. Rock Mech Rock Eng 52:4565–4588
Wang G, Wu MM, Wang R, Xu H, Song X (2017) Height of the mining-induced fractured zone above a coal face. Eng Geol 216:140–152
Wang X, Meng FB (2018) Statistical analysis of large accidents in China’s coal mines in 2016. Nat Hazards 92(1):311–325
Wei JC, Han CH, Zhang WJ, Xie C, Zhang LZ, Li XP, Zhang CR, Jiang JG (2019) Mechanism of fissure grouting based on step-wise calculation method. Rock and Soil Mech 40(3):913–925 (in Chinese)
Wu Q, Liu YZ, Liu DH, Zhou WF (2011) Prediction of floor water inrush: the application of GIS-based AHP vulnerable index method to Donghuantuo Coal Mine. China Rock Mech Rock Eng 44(5):591–600
Yao QL, Li XH, Zhou J, Qu QD, Cao SG (2013) Technology of coal seam floor grouting for disaster prevention and control while mining above a confined water body. Disaster Adv 6:216–227
Yin HY, Wei JC, Lefticariu L, Guo JB, Xie DL, Li ZL, Zhao P (2016) Numerical simulation of water flow from the coal seam floor in a deep longwall mine in china. Mine Water Environ 35(2):1–10
Yin HY, Zhao H, Xie DL, Sang SZ, Shi YL, Tian MH (2019) Mechanism of mine water inrush from overlying porous aquifer in Quaternary: a case study in Xinhe Coal Mine of Shandong Province. Arab J Geosci 12(5):163
Yin HY, Zhou WF, LaMoreaux JW (2018) Water inrush conceptual site models for coal mines of China. Environ Earth Sci 77:746
Yu B, Zhao J, Xiao HT (2017) Case study on overburden fracturing during longwall top coal caving using microseismic monitoring. Rock Mech Rock Eng 50(2):507–511
Zhang SC, Guo WJ, Li YY (2017a) Experimental simulation of water-inrush disaster from the floor of mine and its mechanism investigation. Arab J Geosci 10(22):503
Zhang QS, Zhang LZ, Liu RT, Li SC, Zhang QQ (2017b) Grouting mechanism of quick setting slurry in rock fissure with consideration of viscosity variation with space. Tunn Undergr Sp Tech 70:262–273
Zhang WJ, Li SC, Wei JC, Zhang QS, Liu RT, Zhang X, Yin HY (2018) Grouting rock fractures with cement and sodium silicate grout. Carbonate Evaporite 33(2):211–222
Zeng YF, Wu Q, Liu SQ, Zhai YL, Zhang W, Liu YZ (2016) Vulnerability assessment of water bursting from Ordovician limestone into coal mines of China. Environ Earth Sci 75:1431
Acknowledgements
The research was supported by the Scientific Research Foundation of Shandong University of Science and Technology for Recruited Talents (No. 2017RCJJ030), the National Natural Science Foundation of China (No. 51509148) and the Shandong Provincial Natural Science Foundation of China (No.BS2015NJ010).
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Han, C., Zhang, W., Zhou, W. et al. Experimental investigation of the fracture grouting efficiency with consideration of the viscosity variation under dynamic pressure conditions. Carbonates Evaporites 35, 30 (2020). https://doi.org/10.1007/s13146-020-00568-7
Accepted:
Published:
DOI: https://doi.org/10.1007/s13146-020-00568-7