Skip to main content
Log in

Phase Distribution Characteristics of Bubbly Flow in Mini Pipes Under Normal and Microgravity Conditions

  • Original Article
  • Published:
Microgravity Science and Technology Aims and scope Submit manuscript

Abstract

The axial development of the void fraction, interfacial area concentration and Sauter mean bubble diameter profiles of adiabatic air-water bubbly flows in 5.0 and 3.0 mm-diameter pipes were measured using a stereo image processing method under two gravity conditions, vertical upward (normal gravity) and microgravity. The flow measurements were performed at four axial locations. The axial distances from the pipe inlet (z) normalized by the pipe diameter (D) were z/D = 5.5, 34, 72 and 110 for 5.0 mm-diameter pipe and z/D = 15, 62, 120 and 188 for 3.0 mm-diameter pipe. Data were collected for superficial gas and liquid velocities respectively in the ranges of 0.00434–0.0500 m/s and 0.205–0.754 m/s. The effect of gravity on the radial distribution of bubbles and the axial development of two-phase flow parameters is discussed in detail, based on the obtained database. The phase distributions in pipe cross-sections were classified into 3 basic patterns: core peak, intermediate peak and wall peak distributions, based on two normalized parameters: a normalized void peak position and a normalized void peak intensity. Phase distribution pattern maps under normal and microgravity conditions were generated for bubbly flows in 5.0 and 3.0 mm-diameter pipes. The data obtained in the current experiment are expected to contribute to the benchmarking of CFD simulation of void fraction and interfacial area concentration distribution patterns in forced convective pipe flow under microgravity conditions.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Fig. 18
Fig. 19
Fig. 20
Fig. 21
Fig. 22
Fig. 23

Similar content being viewed by others

References

Download references

Acknowledgments

The authors are very thankful to Messrs. T. Kikuchi, Y. Takata, S. Watanabe, Y. Fukuhara and Mrs. Y. Ohkubo of Tokyo University of Marine Science and Technology for their assistance in the experiments. Part of this work was supported by the ground-based research program for space utilization promoted by the Japan Space Forum.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Tatsuya Hazuku.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Hazuku, T., Takamasa, T. & Hibiki, T. Phase Distribution Characteristics of Bubbly Flow in Mini Pipes Under Normal and Microgravity Conditions. Microgravity Sci. Technol. 27, 75–96 (2015). https://doi.org/10.1007/s12217-015-9412-6

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s12217-015-9412-6

Keywords

Navigation