Abstract
Basis of explosion’s responsive analysis and anti-explosion’s structure design is the relation among thin explosive mass, impulse and plate deformation. In this paper, the limitations of theoretical calculation and experimental methods are analyzed according to the relation between impulse loading and deformation of steel plate in thin explosive experiment. The time histories of deformation for the square steel plate under the impulse of thin explosive are calculated by the fluid-solid coupling method and the pressure loading method. The advantages of the pressure loading method and the fluid-solid coupling method are compared. The results show that the steel plate deformation can be estimated accurately using the fluid-solid coupling method when the explosive impulse is unknown, while the theoretical calculation and the pressure loading method provide quick and accurate prediction on the steel plate deformation when the explosive impulse is known.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
YUEN S C K, NURICK G N. Experimental and numerical studies on the response of quadrangular stiffened plates. Part I: Subjected to uniform blast load [J]. International Journal of Impact Engineering, 2005, 31: 55–83.
RUDRAPATNA N S, VAZIRI R, OLSON M D. Deformation and failure of blast-loaded stiffened plates [J]. International Journal of Impact Engineering, 2000, 24: 457–474.
PARK B W, CHO S R. Simple design formulae for predicting the residual damage of unstiffened and stiffened plates under explosion loadings [J]. International Journal of Impact Engineering, 2006, 32: 1721–1736.
JACOB N, YUEN S C K, NURICK G N, et al. Scaling aspects of quadrangular plates subjected to localised blast loads: Experiments and predictions [J]. International Journal of Impact Engineering, 2004, 30: 1179–1208.
LANGDON G S, ROSSITER I B, BALDEN V H, et al. Performance of mild steel perforated plates as a blast wave mitigation technique: Experimental and numerical investigation [J]. International Journal of Impact Engineering, 2010, 37: 1021–1036.
ZAKRISSON B, WIKMAN B, H¨AGGBLAD H. Numerical simulations of blast loads and structural deformation from near-field explosion in air [J]. International Journal of Impact Engineering, 2011, 38: 597–612.
CHEN A, LOUCA L A, ELGHAZOULI A Y. Blast assessment of steel switch boxes under detonation loading scenarios [J]. International Journal of Impact Engineering, 2015, 78: 51–63.
NURICK G N, MARTIN J B. Deformation of thin plates subjected to impulsive loading: A review. Part II: Experimental studies [J]. International Journal of Impact Engineering, 1989, 8: 171–186.
MOSTOFI T M, BABAEI H, ALITAVOLI M. Theoretical analysis on the effect of uniform and localized impulsive loading on the dynamic plastic behaviour of fully clamped thin quadrangular plates [J]. Thin-Walled Structure, 2016, 109: 367–376.
JONES N. Dynamic inelastic response of strain rate sensitive ductile plates due to large impact, dynamic pressure and explosive loadings [J]. International Journal of Impact Engineering, 2014, 74: 3–15.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Luo, F., Zhang, S. Calculation Method Study on Steel Plate Deformation Under Impulse Loading of Thin Explosive. J. Shanghai Jiaotong Univ. (Sci.) 24, 168–175 (2019). https://doi.org/10.1007/s12204-019-2049-7
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12204-019-2049-7