Abstract
Numerical simulation is used to study the influence of corrosion damage in stiffened plates focusing on elastic buckling strength. Three-dimensional specta are used to simulate geometries of corroded surfaces and finite element method is employed for computing Euler stress of stiffened plates. The influence of corrosion patterns, amount of corrosion loss and roughness of surface are investigated. Ratio of Euler stress of corroded stiffened plate over Euler stress of un-corroded stiffened plate is used to characterize the effects of corrosion on reduction of buckling strength. Results show that reduction of buckling strength is very sensitive to the amount of corrosion loss and roughness of surface, but less sensitive to the location of corroded region. The potential for decrease in buckling strength as a consequence of corrosion is found to depend on the dominant buckling mode. Residual buckling strength is reduced by as much as 12% for the interaction of plate-web-torsional buckling mode, and by 2% for column buckling.
Similar content being viewed by others
References
ANSYS Version 5.6 1999 Canonsburg, PA, USA
Goda Y 1970 Numerical experiments on wave statistics with spectral simulation. Rep. Port Harbor Res. Inst. 9(3): 3–57
Guo J, Wang G, Ivanov L and Perakis N 2008 Time varying ultimate strength of aging tanker deck plate considering corrosion effect. Mar. Struct. 21: 402–419
Huang Y, Zhang Y, Liu G and Zhang Q 2010 Ultimate strength assessment of hull structural plate with pitting corrosion damnification under biaxial compression. Ocean Eng. 37: 1503–1512
Nakai T, Matsushita H and Yamamoto N 2006 Effect of pitting corrosion on the ultimate strength of steel plates subjected to in-plane compression and bending. J. Mar. Sci. Technol. 11(1): 52–64
Oszvald K and Dunai L 2010 Effect of corrosion on the buckling of steel angle elements. 8th fib PhD Symposium in Kgs. Lyngby, Denmark
Rahbar-Ranji A 2001 Stress analysis of a randomly undulated plate due to corrosion in marine structures. Ph.D. Thesis, Yokohama National University, Department of Naval Architecture, Japan
Rahbar-Ranji A 2012a Plastic collapse load of corroded steel plates. Sadhana—Academy Proceed. Eng. Sci. 37(3): 341–349
Rahbar-Ranji A 2012b Ultimate strength of corroded steel plates with irregular surfaces under in-plane compression. Ocean Eng. 54: 261–269
Rahbar-Ranji A 2012c Elastic buckling analysis of longitudinally stiffened plates with flat-bar stiffeners. Ocean Eng. 58: 48–59
Rahbar-Ranji A 2013a Elastic buckling strength of corroded steel plates. Sadhana—Academy Proceed. Eng. Sci. 38(1): 89–99
Rahbar-Ranji A 2013b Elastic coupled buckling analysis in stiffened plates with T-bar stiffeners. Proc. IMechE Part C: J. Mech. Eng. Sci. 227(6): 1135–1149 DOI:10.1177/0954406212458076
Rahbar-Ranji A 2014a Buckling Analysis of Partially Corroded Steel Plates with Irregular Surfaces. Sadhana—Academy Proceed. Eng. Sci. 39(2): 511–524
Rahbar-Ranji A 2014b Elastic tripping analysis of corroded stiffeners in stiffened plate with irregular surfaces. J. Mech. Sci. Technol. 28(9): 3629–3636 DOI:10.1007/s12206-014-0824-9
SSC-394 1997 Strength assessment of pitted plate panels, ship structural committee
Timoshenko S P and Gere J M 1961 Theory of elastic stability. 2nd ed, Eng. Societies Monograph NY: McGraw Hill
Wang G, Spencer J and Sun H 2005 Assessment of corrosion risks to aging ships using an experience database. J. Offshore Mech. Arctic Eng. 127(2): 167–174
Wang C L E, Grondin G Y and Elwi A E 2006 Interaction buckling failure of stiffened steel plates. University of Alberta Structural Engineering report No. 264
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
RAHBAR-RANJI, A. Elastic buckling analysis of corroded stiffened plates with irregular surfaces. Sadhana 40, 199–213 (2015). https://doi.org/10.1007/s12046-014-0296-8
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12046-014-0296-8