Skip to main content
Log in

Austenite formation during intercritical annealing in C-Mn cold-rolled dual phase steel

  • Published:
Journal of Central South University Aims and scope Submit manuscript

Abstract

Two different kinds of experimental techniques were used to in-situ study the austenite formation during intercritical annealing in C-Mn dual phase steel. The microstructure evolution was observed by confocal laser scanning microscope, and the austenite isothermal and non-isothermal transformation kinetics were studied by dilatometry. The results indicate that banded structure is produced for the reason of composition segregation and the competition between recrystallization and phase transformation. Austenite prefers to nucleate not only at ferrite/ferrite grain boundaries, but also inside the grains of ferrite. Furthermore, the austenitizing process is accomplished mainly via migration of the existing austenite/ferrite interface rather than nucleation of new grains. The incubation process can be divided into two stages which are controlled by carbon and manganese diffusion, respectively. During the incubation process, the nucleation rate of austenite decreases, and austenite growth changes from two-dimensional to one-dimensional. The partitioning coefficient, defined as the ratio of manganese content in the austenite to that in the adjacent ferrite, increases with increasing soaking time.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  1. KANG Yong-lin, HAN Qi-hang, ZHAO Xian-meng, CAI Ming-hui. Influence of nanoparticle reinforcements on the strengthening mechanisms of an ultrafine-grained dual phase steel containing titanium [J]. Materials and Design, 2013, 44:331–339.

    Article  Google Scholar 

  2. SPEICH G R, DEMAREST V A, MILLER R L. Formation of austenite during intercritical annealing of dual-phase steels [J]. Metallurgical Transactions A, 1981, 12:1419–1428.

    Article  Google Scholar 

  3. GARCIA C I, DEARDO A J. Formation of austenite in 1.5% Mn steels [J]. Metallurgical Transactions A, 1981, 12:521–530.

    Article  Google Scholar 

  4. SAVRAN V I, OFFERMAN S E, SIETSMA J. Austenite nucleation and growth observed on the level of individual grains by three-dimensional X-Ray diffraction microscopy [J]. Metallurgical and Materials Transactions A, 2010, 41:583–591.

    Article  Google Scholar 

  5. NOURI A, SAGHAFIAN H, KHEIRANDISH S. Effects of silicon content and intercritical annealing on manganese partitioning in dual phase steels [J]. Journal of Iron and Steel Research International, 2010, 17(5):44–50.

    Article  Google Scholar 

  6. RAJU S, GANESH B J, RAI A K, MYTHILI R, SAROJA S, RAJ B. A study on martensitic phase transformation in 9Cr-1W-0.23V-0.063Ta-0.56Mn-0.09C-0.02N (wt.%) reduced activation steel using differential scanning calorimetry [J]. Journal of Nuclear Materials, 2010, 405:59–69.

    Article  Google Scholar 

  7. MARTIN D S, van DIJK N H, BRÜCK E, van der ZWAAG S. The isothermal martensite formation in a maraging steel: A magnetic study [J]. Materials Science and Engineering A, 2008, 481/482:757–761.

    Article  Google Scholar 

  8. ANDRÉS C G, CABALLERO F G, CAPDEVILA C, ÁLVAREZ L F. Application of dilatometric analysis to the study of solid-solid phase transformations in steels [J]. Materials Characterization, 2002, 48:101–111.

    Article  Google Scholar 

  9. MARTIN D S, CASTILLO P E J R, ANDRÉS C G. In situ study of austenite formation by dilatometry in a low carbon microalloyed steel [J]. Scripta Materialia, 2008, 58:926–929.

    Article  Google Scholar 

  10. LIU L, YANG Z G, ZHANG C, LIU W B. An in situ study on austenite memory and austenitic spontaneous recrystallization of a martensitic steel [J]. Materials Science and Engineering A, 2010, 527:7204–7209.

    Article  Google Scholar 

  11. ZHANG D, TERASAKI H, KOMIZO Y. In situ observation of the formation of intragranular acicular ferrite at non-metallic inclusions in C-Mn steel [J]. Acta Materialia, 2010, 58:1369–1378.

    Article  Google Scholar 

  12. SCHMIDT E, SOLTESZ D, ROBERTS S, BEDNAR A, SRIDHAR S. The austenite/ferrite front migration rate during heating of IF steel [J]. ISIJ International, 2006, 46(10):1500–1509.

    Article  Google Scholar 

  13. OLIVEIRA F L G, ANDRADE M S, COTA A B. Kinetics of austenite formation during continuous heating in a low carbon steel [J]. Materials Characterization, 2007, 58:256–261.

    Article  Google Scholar 

  14. ZHANG Xue-hui, ZHU Guo-hui, MAO Wei-min. Effect of interaction between recrystallization and transformation on microstructure of dual phase steel [J]. Iron and Steel, 2009, 44(9):86–89. (in Chinese)

    MATH  Google Scholar 

  15. PERANIO N, LI Y J, ROTERS F, RAABE D. Microstructure and texture evolution in dual-phase steels: Competition between recovery, recrystallization, and phase transformation [J]. Materials Science and Engineering A, 2010, 527:4161–4168.

    Article  Google Scholar 

  16. CHEN H, GAMSJÄGER E, SCHIDER S, KHANBAREH H, van der ZWAAG S. In situ observation of austenite-ferrite interface migration in a lean Mn steel during cyclic partial phase transformations [J]. Acta Materialia, 2013, 61:2414–2424.

    Article  Google Scholar 

  17. ZHAO Xian-meng, KANG Yong-lin, HAN Qi-hang. Austenite isothermal transformation kinetics of a 1000 MPa grade cold rolled dual phase steel [J]. Transactions of Materials and Heat Treatment, 2013, 34:53–59. (in Chinese)

    Google Scholar 

  18. KUANG Shuang, KANG Yong-lin, YU Hao, LIU Ren-dong. Simulation of austenization during intercritical annealing for Fe-C-Mn cold rolling dual phase steel [J]. Journal of University of Science and Technology Beijing, 2008, 8:858–863. (in Chinese)

    Google Scholar 

  19. YONG Qi-long, LI Yong-fu, ZHAO Kun-yu. Isothermal transformation kinetics time exponent versus nucleation and growth mechanisms [J]. Journal of Yunnan Institute of Technology, 1990, 6(3):1–8. (in Chinese)

    Google Scholar 

  20. FARJAS J, ROURA P. Modification of the Kolmogorov-Johnson-Mehl-Avrami rate equation for non-isothermal experiments and its analytical solution [J]. Acta Materialia, 2006, 54:5573–5579.

    Article  Google Scholar 

  21. HILLERT M, AGREN J. On the definitions of paraequilibrium and orthoequilibrium [J]. Scripta Materialia, 2004, 50:697–699.

    Article  Google Scholar 

  22. SUN S, PUGH M. Manganese partitioning in dual-phase steel during annealing [J]. Materials Science and Engineering A, 2000, 276:167–174.

    Article  Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Yong-lin Kang  (康永林).

Additional information

Foundation item: Project(2013AA031601) supported by the National High Technology Research and Development Program of China; Project(2012BAF04B01) supported by the National Science and Technology Pillar Program During the 12th Five-year Plan Period of China

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Li, Sc., Kang, Yl., Zhu, Gm. et al. Austenite formation during intercritical annealing in C-Mn cold-rolled dual phase steel. J. Cent. South Univ. 22, 1203–1211 (2015). https://doi.org/10.1007/s11771-015-2634-3

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11771-015-2634-3

Key words

Navigation