Skip to main content
Log in

Model test on development characteristics and displacement variation of water and mud inrush on tunnel in fault fracture zone

  • Original Paper
  • Published:
Natural Hazards Aims and scope Submit manuscript

Abstract

The fault fracture zone, featuring a variety of fault rocks and associated fissures, is a special area which bears the most concentrated stress when it forms and develops. It is always observed to reserve abundant underground water when buried deeply. Therefore, the tunnel under construction is subject to serious water and mud inrush when excavated through this area. In order to study the characteristics of that disaster, a three-dimensional geological model test system was established. Based on a large number of comparisons on materials and tests on mechanical performance, a set of new fault and common surrounding rock materials applicable to the fluid–solid coupling model test were developed. Then, the experimental data were compared with the actual data of the inrush disaster of fault F2 in Yonglian Tunnel, to explore the variation of characteristic parameters such as the location of the inrush, the mass of emission properties, displacement and settlement. As the results showed, the location of the initial inrush occurred at the spandrel of the tunnel face, the mass of emission properties increased with proceeding time, but there was a sudden saltation of the increasing rate when the disaster occurred. Besides, the shape of surface subsidence above the location of the inrush gradually transferred from “W” to “V,” and the subsidence area eventually showed a parabolic pattern. Finally, the conclusion of the model test may shed light on the catastrophic process and evolution law of the water and mud inrush in fault fracture zone.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Fig. 18
Fig. 19
Fig. 20
Fig. 21

Similar content being viewed by others

References

  • Berg SS, Skar T (2005) Controls on damage zone asymmetry of a normal fault zone: outcrop analyses of a segment of the Moab fault. J Struct Geol 27(10):1803–1822

    Article  Google Scholar 

  • Chen AM, Gu JC, Shen J, Ming ZQ, Gu LY, Lu ZY (2004) Application study on the geomechanical model experiment techniques. Chin J Rock Mech Eng 23(22):3785–3789 (in Chinese)

    Google Scholar 

  • Faulkner DR, Jackson CAL, Lunn RJ, Schlische RW, Shipton ZK, Wibberley CAJ, Withjack MO (2010) A review of recent developments concerning the structure, mechanics and fluid flow properties of fault zones. J Struct Geol 32(11):1557–1575

    Article  Google Scholar 

  • Fei WP, Zhang L, Zhang R (2010) Experimental study on a geo-mechanical model of a high arch dam. Int J Rock Mech Min Sci 47(2):299–306

    Article  Google Scholar 

  • Fumagalli E (1973) Statical and geomechanical models. Springer, New York, pp 152–180

    Book  Google Scholar 

  • Gudmundsson A, Simmenes TH, Larsen B, Philipp SL (2010) Effects of internal structure and local stresses on fracture propagation, deflection, and arrest in fault zones. J Struct Geol 32(11):1643–1655

    Article  Google Scholar 

  • He XQ, Liu ZX, Li XB, Chen HJ, Peng SQ (2010) Study of the simulated materials for liquid-solid coupling. Min Metall Eng 30(4):22–26 (in Chinese)

    Google Scholar 

  • Hou TX, Yang XG, Xing HG, Huang KX, Zhou JW (2016) Forecasting and prevention of water inrush during the excavation process of a diversion tunnel at the Jinping II Hydropower Station, China. SpringerPlus 5(1):700

    Article  Google Scholar 

  • Hu YQ, Zhao YS, Yang D (2007) Simulation theory and method of 3D solid-liquid couping. J Liaoning Tech Univ Nat Sci 26(2):204–206 (in Chinese)

    Google Scholar 

  • Knipe RJ, Lloyd GE (1994) Microstructural analysis of faulting in quartzite, Assynt, NW Scotland: implications for fault zone evolution. Pure Appl Geophys 143(1–3):229–254

    Article  Google Scholar 

  • Li LP (2009) Study on catastrophe evolution mechanism of karst water inrush and its engineering application of high risk karst tunnel. Ph.D.’s dissertation, Shandong University, Jinan (in Chinese)

  • Li XZ, Luo GY, Chen ZS (2002) The mechanism of deformation and water conduction of fault due to excavation in water inrush in underground engineering. Chin J Geotech Eng 24(6):695–700 (in Chinese)

    Google Scholar 

  • Li SC, Liu Q, Li LP, Zhao Y, Wang HP, Zhao Y, Yuan XS (2011) Development of large-scale geomechanical model test system for tunnel construction and its application. Chin J Rock Mech Eng 30(7):1368–1374 (in Chinese)

    Google Scholar 

  • Li SC, Zhou Y, Li LP, Zhang Q, Song SG, Li JL, Wang K, Wang QH (2012) Development and application of a new similar material for underground engineering fluid-solid coupling model test. Chin J Rock Mech Eng 31(6):1128–1137 (in Chinese)

    Google Scholar 

  • Liang DX, Jiang ZQ, Zhu SY, Sun Q, Qian ZW (2016) Experimental research on water inrush in tunnel construction. Nat Hazards 81(1):467–480

    Article  Google Scholar 

  • Ni XD, Wang Y, Lu NG (2010) Study of meso-mechanism of seepage failure in tunnel excavation process. Chin J Rock Mech Eng 29(S2):4194–4201 (in Chinese)

    Google Scholar 

  • Shi L, Singh RN (2001) Study of mine water in rush from floor strata through faults. Mine Water Environ 20(3):140–147

    Article  Google Scholar 

  • Sibson RH (2000) Fluid involvement in normal faulting. J Geodyn 29(3–5):469–499

    Article  Google Scholar 

  • Wang Y, Lu YG, Ni XD, Li DT (2011) Study on mechanism of water burst and mud burst in deep tunnel excavation. J Hydraul Eng 42(5):595–601

    Google Scholar 

  • Wang LZ, Chen ZQ, Kong HL, Ni XY (2014) An experimental study of the influence of seepage pressure and initial porosity on variable mass seepage for broken mudstone. J Min Saf Eng 31(3):462–475 (in Chinese)

    Google Scholar 

  • Weng XJ (2014) Study on inrush of water and mud mechanism and grouting control technology in water-rich fault fracture zone of tunnel. Master’s dissertation, Shandong University, Jinan (in Chinese)

  • Xu D, Wu AQ, Sun WJ (2010) Simulation of sudden blow in diversion tunnel of some hydropower station. J Yangtze River Sci Res Inst 27(08):44–49 (in Chinese)

    Google Scholar 

  • Yang TH, Chen SK, Zhu WP, Meng ZP, Gao YF (2008) Water inrush mechanism in mines and nonlinear flow model for fractured rocks. Chin J Rock Mech Eng 27(7):1411–1416 (in Chinese)

    Google Scholar 

  • Zhang X, Sanderson DJ, Barker AJ (2002) Numerical study of fluid flow of deforming fractured rocks using dual permeability model. Geophys J Int 151(2):452–468

    Article  Google Scholar 

  • Zhao Y, Li PF, Tian SM (2013) Prevention and treatment technologies of railway tunnel water inrush and mud gushing in China. Chin J Rock Mech Eng 5(6):468–477

    Google Scholar 

Download references

Acknowledgements

This work was financially supported by National Natural Science Foundation of China (No. U1706223), and Natural Science Foundation of Shandong Province (No. ZR2017MEE070). The authors are grateful to Yanan Liu, Honglu Yang and Haojie Liu for their assistance during the tests, and the authors would also like to thank the editors and peer reviewers for their valuable comments on this paper.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Qingsong Zhang.

Additional information

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Zhang, Q., Jiang, Q., Zhang, X. et al. Model test on development characteristics and displacement variation of water and mud inrush on tunnel in fault fracture zone. Nat Hazards 99, 467–492 (2019). https://doi.org/10.1007/s11069-019-03753-7

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11069-019-03753-7

Keywords

Navigation