Metallographic and x-ray phase analyses are used for metal-matrix composites Al – B4C and (Al – 12% Si) – B4C with a volume fraction of 60% boron carbide prepared by infiltrating a pressed workpiece with metal under pressure. It is shown that with introduction of 1 to 4% Mg into a metal matrix composite porosity is reduced from 7 to 1%.
Similar content being viewed by others
References
E. R. Sharifi, f. Karimzadeh, et al., “Fabrication and evaluation of mechanical and tribological properties of boron carbide reinforced aluminum matrix nanocomposites,” Mater Des., No. 32, 3263 – 3271 (2011).
R. Ipek, “Adhesive wear behavior of B4C and SiC reinforced 4147 Al matrix composites (Al/B4C–Al/SiC),” J. Mater. Proc. Technol., No. 162 – 163, 71 – 75 (2005).
F. Tang, X. Wu, et al, “Dry sliding friction and wear properties of B4C particulate-reinforced Al-5083 matrix composites,” Wear, No. 264, 555 – 561 (2008).
M. Alizadeh, R. Amini, et al., “Structural and mechanical properties of Al/B4C composites fabricated by wet attrition milling and hot extrusion,” J. Mater. Sci. Technol., No. 29(8), 725 – 730 (2013).
T. W. Clyne and P. J. Withers, An Introduction to Metal Matrix Composites, Cambridge University Press, Cambridge, UK (1993).
E. Candan, H. V. Atkinson, et al., “Wettability of aluminum-magnesium alloys on silicon carbide substrates,” J. Am. Ceram. Soc., No. 94(3), 867 – 874 (2011).
H. Wu, F. Zeng, et al., “Wettability of 2519Al on B4C at 1000 – 1250°C and mechanical properties of infiltrated B4C – 2519Al composites,” Ceram. Int., No. 40, 2073 – 2081 (2014).
K. Skuruman, S. G. K. Pillai, et al., “The effects of magnesium additions on the structure and properties of Al–7Si–10SiCp composites,” J. Mater. Sci., No. 30(6), 1469 – 1472 (1995).
E. Candan, “Effect of alloying elements to aluminium on the wettability of Al/SiC System,” Turkish J. Eng. Env. Sci., No. 26, 1 – 5 (2002).
F. Delennay, L. Froylen, et al., “The wetting of solids by molten metals and its relation to the preparation of metal matrix composites,” J. Mater. Sci., No. 22(1), 1 – 16 (1987).
H. Ahlatci, The Effect of Reinforcing Particle Size and Matrix Composition on the Mechanical Properties and Wear Behaviours of Aluminium-Silicon Carbide Composites, Author’s Abstract of Doctoral’s Thesis, İstanbul Technical University, June (2013).
H. Ahlatci, E. Candan, et al., “Abrasive wear behavior and mechanical properties of Al – Si/SiC composites,” Wear, No. 257, 625 – 632 (2004).
M. Eustathopoulos, M. G. Nicholas, et al., Wettability at High Temperatures, Pergamon, Tokyo (1999).
H. Ahlatci, E. Candan, et al., “Mechanical properties of Al – 60% SiCp composites alloyed with Mg,” Metal. Mater. Trans. A, No. 35, 2127 – 2141 (2004).
S. Ray, “Synthesis of cast metal matrix particulate composites,” J. Mater. Sci., No. 28, 5397 – 5413 (1993).
S. Y. Oh, J. A. Cornie, et al., “Particulate wetting and metal: Ceramic interface phenomena,” Ceram. Eng. Sci. Proc., No. 8, 912 – 936 (1987).
K. M. Shorowordi, T. Laoui, et al., “Microstructure and interface characteristics of B4C, SiC and Al2O3 reinforced Al matrix composites: a comparative study,” in: 4th International Conference on Mechanical Engineering (2001), No. VI, pp. 175 – 181.
Z. Zhang, K. Fortin, et al., “Fluidity and microstructure evolution of Al – 12% B4C composites containing magnesium,” Mater. Trans., No. 52(5), 928 – 933 (2011).
T. M. Liu, C. G. Chao, et al., “Effect of magnesium on mechanical properties of alumina-fiber-reinforced aluminum matrix composites formed by pressure infiltration casting,” Mater. Sci. Eng. A, No. 169, 79 – 84 (1993).
K. B. Lee, H. S. Sim, et al., “Reaction products of Al – Mg/B4C composite fabricated by pressureless infiltration technique,” Mater. Sci. Eng. A, No. 302, 227 – 234 (2001).
K. B. Lee, H. S. Sim, et al., “Reaction products of Al – Mg/B4C composite fabricated by pressureless infiltration technique,” Mater. Sci. Eng. A, No. 302, 227 – 234 (2012).
This research was carried out within the scope of a project KBÜ-BAP-13/2-DR-002, supported by Karabük University.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Metallovedenie i Termicheskaya Obrabotka Metallov, No. 6, pp. 46 – 50, June, 2016.
Rights and permissions
About this article
Cite this article
Çevik, E., Sun, Y., Ahlatci, H. et al. Effect of Magnesium Additions on Composites with Al and Al – 12% Si Matrices Strengthened with B4C and Prepared by Infiltration Under Pressure. Met Sci Heat Treat 58, 357–361 (2016). https://doi.org/10.1007/s11041-016-0017-5
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11041-016-0017-5