Skip to main content
SpringerLink
Log in

A Method of Controlling the Parameters of a Sealed Cable Gland

  • Published:
Measurement Techniques Aims and scope

A methodology for timely monitoring of the electrophysical characteristics and parameters of a sealed cable gland based on inorganic materials is examined. The methodology is applied to assessing the quality of the status of the cable input during actual time of use of the cable line of nuclear physics facilities. The special features of connecting protective shielding systems (double shielding) of nuclear physics facilities are considered. A description of an experimental technique for using a gland for control cables is provided. The results of measuring wave resistance and the attenuation coefficient are analyzed using the quarter-wave short-circuit line method at the carrier frequency. It has been determined that the type of sealed cable gland that has been developed is stable with respect to electrophysical parameters under standard failure conditions and is applicable the input of control cables of nuclear physics facilities.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1.
Fig. 2.
Fig. 3.

Similar content being viewed by others

References

  1. S. L. Rogov, “Metrological provision of emergency protection subsystems within information-measurement and control systems,” Izmer. Tekhn., No. 11, 68–71, (2012).

  2. A. V. Sharkov, V. A. Korablev, D. S. Makarov, et al., “Measurement of high-density heat flux using an automated installation,” Izmer. Tekhn., No. 1, 46–48 (2016).

  3. S. D. Eastham, D. J. Coates, and G. T. Parks, “A novel method for rapid comparative quantitative analysis of nuclear fuel cycles,” Ann. Nucl. Energy, 42, 80–88 (2012).

    Article  Google Scholar 

  4. GOST R MEK 61508-1-2012, Functional Safety of Electrical, Electronic, Programmable Electronic, and Safety-Associated Systems. Part 1 (2012).

  5. R. L. Vollaro, L. Fontana, and A. Vallati, “Thermal analysis of underground electrical power cables buried in non-homogeneous soils,” Appl. Therm. Eng., 31 (5), 772–778 (2011).

    Article  Google Scholar 

  6. Y. Lin and Z. Xu, “Cable sheath loss reduction strategy research based on the coupled line model,” IEEE T. Power Deliver., 30, No. 5, 2303–2311 (2015).

    Article  MathSciNet  Google Scholar 

  7. S. A. Romanishina, D. Y. Katyuk, V. S. Deeva, and S. M. Slobodyan, “Dynamics layer of the sliding contact collector elements,” ELNANO 2015: Proc. IEEE 35th Int. Conf. on Electronics and Nanotechnology (2015), pp. 116–118.

  8. M. N. Sadiku, Elements of Electromagnetics, Oxford Univ. Press, New York (2015).

    Google Scholar 

  9. M. S. Slobodyan, “The probability factor of contact measurements,” Izmer. Tekhn., No. 1, 47–52 (2015).

  10. L. Zhang, X. Tian, S. A. Boggs, and E. J. Bartolucci, “Determination of total resistive loss in a multiple circuit, three-phase cable system,” IEEE T. Power Deliv., 26, No. 3, 1939–1945 (2011).

    Article  Google Scholar 

  11. P. Oclon, P. Cisek, M. Pilarczyk, and D. Taler, “Numerical simulation of heat dissipation processes in underground power cable system situated in thermal backfill and buried in a multilayered soil,” Energ. Convers. Manag., 95, 352–370 (2015).

    Article  Google Scholar 

  12. O. E. Gouda and A. A. Farag, “Factors affecting the sheath losses in single-core underground power cables with two-points bonding method,” Int. J. Elec. Comp. Eng., 2, No. 1, 7–16 (2012).

    Google Scholar 

  13. S. D. Kholodnyi, S. V. Serebryannikov, and M. A. Boev, Test Methods and Diagnostics in Electroinsulating and Cable Equipment, Izd. Dom MEI, Moscow (2009).

    Google Scholar 

  14. V. Deeva and S. Slobodyan, “Influence of gravity and thermodynamics on the sliding electrical contact,” Tribol. Int., 105, No. 1, 299–303 (2017).

    Article  Google Scholar 

  15. V. S. Deeva, S. M. Slobodyan, and V. S. Teterin, “Optimization of oil particles separation disperser parameters,” Mater. Sci. Forum, 870, 677–682 (2016).

    Article  Google Scholar 

  16. TU 7434-4740909-909-001-92E, VGKK Type Sealed Control Cable Glands for a Nuclear Power Plant.

  17. GOST 15963-79, Electrotechnical Units for Areas with Tropical Climate. General Technical Requirements and Test Methods.

Download references

This work was performed with the support of the Ministry of Education and Science of Russia within the implementation of the program “Research and Development in the Prioritized Development Goals of the Scientific and Technological Complex of Russia for 2014–2020” (Russian Foundation for Basic Research Grant No. 15-08-02265).

Author information

Authors and Affiliations

  1. Samara University, Samara, Russia

    S. P. Vashchuk & D. S. Vashchuk

  2. Tver State Technical University, Tver, Russia

    S. M. Slobodyan

Authors
  1. S. P. Vashchuk
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. S. M. Slobodyan
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. D. S. Vashchuk
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to S. P. Vashchuk.

Additional information

Translated from Izmeritel’naya Tekhnika, No. 11, pp. 54–58, November, 2017.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Vashchuk, S.P., Slobodyan, S.M. & Vashchuk, D.S. A Method of Controlling the Parameters of a Sealed Cable Gland. Meas Tech 60, 1148–1153 (2018). https://doi.org/10.1007/s11018-018-1332-6

Download citation

  • Received:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11018-018-1332-6

Keywords

Search

Navigation