The measuring area of a magnetic dipole moment transducer was analyzed. The transducer was constructed based on coaxial receiver loop antennas. Transformation functions were found for a point source of an alternating magnetic field, depending on the disposition of the source in the measuring area. The optimum ratio of the geometrical sizes of the transducer for obtaining the minimum non-uniformity of measuring area was defined.
Similar content being viewed by others
References
S. R. Trout, “Use of Helmholtz coils for magnetic measurements,” IEEE T. Magn., 24, No. 4, 2108–2111 (1988).
P. N. Dobrodeyev and S. A. Volokhov, “Helmholtz coils for measurement of magnetic moments,” Prib. Metody Izmer., No. 2 (7). 22–27 (2013).
F. M. Greene, “The near-zone magnetic field of a small circular-loop antenna,” J. Res. NBS C Eng. Inst., 71 C, No. 4, 319–326 (1967).
J. Jackson. Classical Electrodynamics [Russian translation], Mir, Moscow (1965).
J. R. Bergervoet and H. Van Veen, “A large-loop antenna for magnetic field measurements,” Proc. 8th Int. Zurich Symposium on EMC, March, 1989, ETH Zentrum – IKT, Zurich, Switzerland (1989), pp. 29–34.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Izmeritel’naya Tekhnika, No. 10, pp. 55–57, October, 2017.
Rights and permissions
About this article
Cite this article
Tishchenko, V.A., Luk’yanov, V.I. & Shammasov, R.R. Analysis of the Measuring Area of a Magnetic Dipole Moment Transducer. Meas Tech 60, 1046–1050 (2018). https://doi.org/10.1007/s11018-018-1316-6
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11018-018-1316-6