Abstract
In this study, the physical foundations of the combined acoustic-electric method are examined for testing layered materials, as well as materials with defects in the form of solid inclusions. The numerical simulation results of the electromagnetic signals excited in a test material via pulsed acoustic impact are presented. The effect of sample layering on the electromagnetic response parameters under a determined acoustic impact is shown. Possible changes in the electromagnetic signals parameters with different charge states of dielectric defect structures, as well as changes in the parameters of electromagnetic signals at different amplitudes of acoustic exposure to a defective structure with a constant charge, are revealed. It is shown that the amplitude-frequency parameters of the emitted electromagnetic signals are directly related to the characteristics of the determined acoustic impact and the charge state of layered and defective structures. It was found that the change in the amplitude of electromagnetic signals linearly depends on the magnitude of the defect plates charge, as well as on the magnitude of the exciting acoustic pulse at a constant charge state of the defect. A research set-up and the model samples with solid-state inclusions in the form of layers and volume defects are described. The duration of the exciting acoustic pulse at the base was 50 μs, and its energy was varied within (8–15) mJ. The sensitivity at the input of the electromagnetic receiver was 0.5 mV, and the output gain was 10 or 100 selectively. The operating frequency range was 1–100 kHz. As a result of experimental studies, the correspondence of the amplitudes of electromagnetic responses to the distribution calculated in time and space of mechanical stresses arising in a layered or defective system during the propagation of an acoustic pulse was established. It is shown that the electromagnetic signals parameters, as well as the distribution of the acoustic pulse, are significantly affected by the difference between the sample and inclusion acoustic impedances.
Similar content being viewed by others
References
Mason, W.P. (ed.): Physical acoustics, vol. 1. Part A, p. 532. Academic Press, New York (1964)
Brazhnikov, I.N.: Physical and physico-chemical methods of control of the composition and properties of the substance//Ultrasonic methods, p. 248. Energia, Moscow (1965). (in Russia)
Blitz, J.: Electrical and magnetic methods of non-destructive testing, p. 261. Springer, New York (1997)
Ida, N.: Numerical modeling for electromagnetic non-destructive evaluation, p. 511. Chapman & Hall edition, London (1995)
Mikheev, M.N., Gorkunov, E.S.: Magnetic methods of structural analysis and non-destructive testing, p. 252. Nauka, Moscow (1993). (in Russia)
Ficilli, F.: Non-destructive testing by magnetic techniques, p. 140. Lambert Academic Publishing, Germany (2012)
Rumyantsev, S.V.: Radiation flaw detection, p. 510. Atomizdat, Moscow (1974)
Sukhorukov, V.V. (ed.): Nondestructive testing, Book 4, p. 321. Moscow, Higher School (1992). (in Russia)
Klyuev, V.V.: Non-destructive testing: Reference book in 8 volumes. Mashinostroenie, Moscow (2008). (in Russia)
Bespal’ko, A.A., Gol’d, R.M., Yavorovich, L.V., Datsko, D.I.: Excitation of electromagnetic radiation in laminated rocks under acoustic influence. J. Min. Sci. 39(2), 112–117 (2003). https://doi.org/10.1023/B:JOMI.0000008455.54729.30
Koktavy P., Pavelka J., and Sikula J. Characterization of acoustic and electromagnetic emission sources / Measurement Science and Technology, (2004) No 15: 973–977.
Fursa, T.V., Dann, D.D., Petrov, M.V., Lykov, A.E.: Evaluation of damage in concrete under uniaxial compression by measuring electric response to mechanical impact. J. Nondestr. Eval. 36(2), 30 (2017). https://doi.org/10.1007/s10921-017-0411-y
Bespalko, A.A., Shtirts, V.A., Fedotov, P.I., Chulkov, A.O., Yavorovich, L.V.: Modelling of infrared glow in rock holes. J. Nondestr. Eval. 38(1), 31 (2019). https://doi.org/10.1007/s10921-019-0570-0
Zhurkov, S.N.: Kinetic concept of strength of solids. Int. J. FractureMech. 1, 311–323 (1965) (in Russia)
Regel, V.R., Slutsker, A.I., Tomashevsky, E.E.: Kinetic nature of the strength of solids, p. 560. Nauka, Moscow (1974).(in Russia)
Lindley, T.C., Palmer, I.G., Richard, C.E.: Acoustic emission monitoring of fatigue crack growth. Mater. Sci. Eng. 32, 1–15 (1978)
Bolotin, Yu.I., Maslov, L.A., Polunin, V.I.: Establishing a correlation between the crack size and the amplitude of acoustic emission pulses. Sov. J. Nondestruct. Test. 11(4), 119–122 (1975) (in Russia)
Landau, L.D., Lifshits, E.M.: electrodynamics of continuous media, p. 620. Nauka, Moscow (1982). (in Russia)
Vishnevskaya, N.L., Zawinski, L.A.: Calculation of the tension of self-consistent electric field arising in the dielectric under mechanical stress. Izvestiya VUZov. Physics 5, 71–74 (1977)
Perelman, M.E., Khatiashvili, N.G.: On radio emission during brittle destruction of dielectrics. DAN SSSR. 256(4), 824–833 (1981)
Rabinovitch, A., Shay, A., Liraz, R., Frid, V., Bahat, D.: Electromagnetic radiation emitted during friction process. Int. J. Fract. 131(2), 21–27 (2005)
Rabinovitch, A., Frid, V., Goldbaum, J., Bahat, D.: Polarization-depolarization process in glass during percussion drilling. Phil. Mag. 83(25), 2929–3011 (2003)
Frid, V., Rabinovitch, A., Bahat, D.: Fracture induced electromagnetic radiation. J. Phys. D-Appl. Phys. 36(13), 1620–1629 (2003)
Bespal’ko, A.A., Surzhikov, A.A., Yavorovich, L.V.: Study of mechanoelectrical transformation in rocks under dynamic impact. Russ. J. Non-Ferrous Metals 1, 9–11 (2007)
Bespal’ko, A., Surzhikov, A., Fedotov, P., Pomishin, E., Stary, O.: Polarization and electromagnetic emissions of natural crystalline structures upon acoustic excitation. Mater. Sci. Forum 970, 153–14 (2019). https://doi.org/10.4028/www.scientific.net/MSF.970.153
Miroshnichenko, M.I., Kuksenko, V.S.: Radiation of electromagnetic pulses during nucleation of cracks in solid dielectrics. Solid State Phys. 22(5), 1531–1534 (1980)
O’Keefe, S.G., Thiel, D.V.: A mechanism for the production of electromagnetic radiation during fracture of brittle materials. Phys. Earth Planet. Inter. 89(11), 127–129 (1995)
Petrenko, V.F.: On the nature of electrical polarization of materials caused by cracks, application to ice. Philos. Mag. B 67(3), 301–315 (1993). https://doi.org/10.1080/13642819308220134
Ogawa, T., Oike, К, Miura, T.: Electromagnetic radiations from rocks. J. Geophys. Res. 90, 6245–6255 (1985). https://doi.org/10.1029/JD090iD04p06245
Gordeev, V.F., Lasukov, V.V.: Physics of electromagnetic emission method of quality control of materials and its prospects. Russ. Phys. J. 44(7), 84–88 (2001)
Bespal’ko, A.A., Gol’d, R.M., Yavorovich, L.V.: Influence of calcite electrification on parameters of electromagnetic signals under pulsed acoustic influence. Phys. Mesomech. 7(5), 95–5 (2004)
Bespal’ko, A.A., Yavorovich, L.V., Fedotov, P.I.: Mechanoelectrical transformations in quartz and quartz-bearing rocks under acoustic action. J. Min. Sci. 43, 472–5 (2006). https://doi.org/10.1007/s10913-007-0049-8
Yavorovich, L.V., Bespal’ko, A.A., Fedotov, P.I., Baksht, R.B.: Electromagnetic radiation generated by acoustic excitation of rock samples. Acta Geophysica 64(5), 1446–16 (2016). https://doi.org/10.1515/acgeo-2016-0081
Installation guide BNC-2120 [Electronic resource]. Access mode: https://rsreu.ru›en/component/docman/doc_download…bnc-2120.html.
Virtual oscilloscope Velleman PCS-500 [Electronic resource]. – Access mode: http:// monitor.espec.ws› Measurement instrumentation›topic36466.html.
Segerlind, L.J.: Applied Finite element analysis, p. 392. Wiley, New York (1976)
Hairer, E., Norsett, S.P., Wanner, G.: Solving Ordinary Differential Equations I: Nonstiff Problems, p. 480. Springer-Verlag, Berlin (1987) https://doi.org/10.1007/978-3-540-78862-1
Ivanov G.V., Volchkov Yu.M., Bogulsky I.O., Anisimov S.A., Kurguzov V.D. Numerical solution of dynamic problems of elastic-plastic deformation of solids. Novosibirsk: Sib.University. ed., (2002). 352 p. (in Russia)
Lyukshin, B.A., Gerasimov, A.V., Krektuleva, R.A., Lyukshin, P.A.: Modeling of physical and mechanical processes in inhomogeneous structures, p. 272. SB RAS publishing House, Novosibirsk (2001). (in Russia)
Bamberger, A., Chalinder, B., Joly, P., Roberts, J.E., Teron, J.L.: Absorbing boundary conditions for Rayleigh waves//SIAM. J. Sci. Stat. Comput. 9(6), 1016–1049 (1988)
Perel’man, M., Khatiashvili, N.: Generation of electromagnetic radiation under vibration of double electric layers. Dok. Akad. Nauk USSR 271(1), 80–5 (1983) (in Russia)
D’Ambrosio, R., Jackiewicz, Z.: Continuous two-step Runge-Kutta methods for ordinary differential equations. Numer. Algorithms 54(2), 169–193 (2010). https://doi.org/10.1007/s11075-009-9329-5
Bespal’ko, A.A., Isaev, Y.N., Yavorovich, L.V.: Transformation of acoustic pulses into electromagnetic response in stratified and damaged structures. J. Min. Sci. 52(2), 279–286 (2016). https://doi.org/10.1134/S1062739116020418
X-ray flat panel detector PerkinElmer XRD 0822 [Electronic resource]. Access mode: www.perkinelmer.com
Acknowledgements
The work was supported by the Russian Science Foundation, Project No. 19-19-00178 (TPU—5.2053.RNF.2019).
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Alekseevich, B.A., Niyazbekovich, I.Y., Dmitrievich, D.D. et al. Transformation of Acoustic Pulses into Electromagnetic Signals in Defective Structures. J Nondestruct Eval 39, 82 (2020). https://doi.org/10.1007/s10921-020-00727-9
Received:
Accepted:
Published:
DOI: https://doi.org/10.1007/s10921-020-00727-9