Skip to main content
Log in

Effect of sizing agent on properties of basalt fiber/blended resin matrix composites

  • Composites & nanocomposites
  • Published:
Journal of Materials Science Aims and scope Submit manuscript

Abstract

Basalt fiber composites are beneficial for electrical equipment because of their low weight, strong strength, high temperature resistance, and corrosion resistance. Three different sizing agents were developed to modify basalt fibers in order to improve the interface bonding state of basalt fiber composites. The morphology, composition, and surface energy of the modified fibers were characterized by SEM, FT-IR, contact angle analysis, and other methods. The findings demonstrated that the sizing agent can be well adsorbed on the fiber surface, and the modification effect was best at a polyurethane lotion concentration of 1wt%. The mechanical properties of the composite, including flexural strength, flexural modulus, tensile strength, and interlaminar shear strength, were increased by 21.05%, 31.46%, 13.89%, and 41.46%, respectively. In terms of insulation performance, the breakdown strength can be increased by 31.73%, and the leakage current and dielectric loss factor can be reduced by 22.76% and 12.32%, respectively. The maximum decomposition rate and storage modulus of the composites dropped, while the glass transition temperature rose, according to the TGA and DMA data following the sizing agent treatment.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10

Similar content being viewed by others

Data and code availability

Not applicable.

References

  1. Chang XJ, Wang ZX, Quan S, Xu YC, Jiang ZX, Shao L (2014) Exploring the synergetic effects of graphene oxide (GO) and polyvinylpyrrodione (PVP) on poly (vinylylidenefluoride) (PVDF) ultrafiltration membrane performance. Appl Surf Sci 316:537–548. https://doi.org/10.1016/j.apsusc.2014.07.202

    Article  CAS  Google Scholar 

  2. Morova N (2013) Investigation of usability of basalt fibers in hot mix asphalt concrete. Constr Build Mater 47:175–180. https://doi.org/10.1016/j.conbuildmat.2013.04.048

    Article  Google Scholar 

  3. Lou K, Kang A, Xiao P, Wu Z, Li B, Wang X (2021) Effects of basalt fiber coated with different sizing agents on performance and microstructures of asphalt mixture. Constr Build Mater 266:121–155. https://doi.org/10.1016/j.conbuildmat.2020.121155

    Article  CAS  Google Scholar 

  4. Dhand V, Mittal G, Rhee KY, Park SJ, Hui D (2015) A short review on basalt fiber reinforced polymer composites. Compos Part B Eng 73:166–180. https://doi.org/10.1016/j.compositesb.2014.12.011

    Article  CAS  Google Scholar 

  5. Krasnovskih MP, Maksimovich NG, Vaisman YI, Ketov AA (2014) Thermal stability of mineral-wool heat-insulating materials. Rus J Appl Chem 87:1430–1434. https://doi.org/10.1134/S1070427214100061

    Article  CAS  Google Scholar 

  6. Liu H, Yu Y, Liu Y, Zhang M, Li L, Ma L, Sun Y, Wang W (2022) A Review on basalt fiber composites and their applications in clean energy sector and power grids. Polymers 14:2376. https://doi.org/10.3390/polym14122376

    Article  CAS  Google Scholar 

  7. Yang Z, Liu J, Feng X, Li S, Xu Y, Ren J (2018) Investigation on mechanical properties and failure mechanisms of basalt fiber reinforced aluminum matrix composites under different loading conditions. J Compos Mater 52:1907–1914. https://doi.org/10.1177/0021998317733807

    Article  CAS  Google Scholar 

  8. Balaji KV, Shirvanimoghaddam K, Rajan GS, Ellis AV, Naebe M (2020) Surface treatment of Basalt fiber for use in automotive composites. Mater Today Chem 17:100344. https://doi.org/10.1016/j.mtchem.2020.100334

    Article  CAS  Google Scholar 

  9. Hou Y, Li M, Gu Y, Yang Z, Li R, Zhang Z (2018) Gamma ray shielding property of tungsten powder modified continuous basalt fiber reinforced epoxy matrix composites. Polym Compos 39:2106–2115. https://doi.org/10.1002/pc.24469

    Article  CAS  Google Scholar 

  10. Blaznov AN, Atyasova EV, Shundrina IK, Samoilenko VV, Firsov VV, Zubkov AS (2017) Thermomechanical characterization of BFRP and GFRP with different degree of conversion. Polym Test 60:49–57. https://doi.org/10.1016/j.polymertesting.2017.03.011

    Article  CAS  Google Scholar 

  11. Wang Q, Ding Y, Randl N (2021) Investigation on the alkali resistance of basalt fiber and its textile in different alkaline environments. Constr Build Mater 272:121670. https://doi.org/10.1016/j.conbuildmat.2020.121670

    Article  CAS  Google Scholar 

  12. Arslan C, Dogan M (2018) The effects of silane coupling agents on the mechanical properties of basalt fiber reinforced poly (butylene terephthalate) composites. Compos B Eng 146:145–154. https://doi.org/10.1016/j.compositesb.2018.04.023

    Article  CAS  Google Scholar 

  13. Wang G, Liu Y, Guo Y, Zhang Z, Xu M, Yang Z (2007) Surface modification and characterizations of basalt fibers with non-thermal plasma. Surf Coat Technol 20:6565–6568. https://doi.org/10.1016/j.surfcoat.2006.09.069

    Article  CAS  Google Scholar 

  14. Zhu M, Ma J (2019) Basalt fiber modified with lanthanum-ethylenediaminetetraacetic acid as potential reinforcement of cyanate matrix composites. Appl Surf Sci 464:636–643. https://doi.org/10.1016/j.apsusc.2018.09.129

    Article  CAS  Google Scholar 

  15. Berg J, Jones FR (1998) The role of sizing resins, coupling agents and their blends on the formation of the interphase in glass fiber composites. Compos A: Appl Sci Manuf 29:1261–1272. https://doi.org/10.1016/S1359-835X(98)00091-8

    Article  Google Scholar 

  16. Xing D, Xi X, Qi M, Zheng Q, Ma P (2020) Optimization on the formulation of sizing to enhance the mechanical properties of basalt fiber. J Text Inst 112:515–525. https://doi.org/10.1080/00405000.2020.1771078

    Article  CAS  Google Scholar 

  17. Guo X, Lu Y, Sun Y, Wang J, Li H, Yang C (2018) Effect of sizing on interfacial adhesion property of glass fiber-reinforced polyurethane composites. J Reinf Plast Compos 37:321–330. https://doi.org/10.1177/0731684417744664

    Article  CAS  Google Scholar 

  18. Wei B, Cao H, Song S (2010) Tensile behavior contrast of basalt and glass fibers after chemical treatment. Mater Des 31:4244–4250. https://doi.org/10.1016/j.matdes.2010.04.009

    Article  CAS  Google Scholar 

  19. Wang Z, Luo H, Zhang J, Chen H, Zhang L, Wu L, Jiang H (2021) Water-soluble polysiloxane sizing for improved heat resistance of basalt fiber. Mater Chem Phys 272:125024. https://doi.org/10.1016/j.matchemphys.2021.125024

    Article  CAS  Google Scholar 

  20. Chen Z, Huang Y (2021) Preparation and performance of fumed silica-stabilized epoxy resin pickering emulsion for basalt fiber-sizing agents. Adv Compos Hybrid Mater 4:1205–1214. https://doi.org/10.1007/s42114-021-00210-7

    Article  CAS  Google Scholar 

  21. Liu Y, Wang W, Liu H, Zhang M, Liu J, Qi J (2022) Blending modification of alicyclic resin and bisphenol a epoxy resin to enhance salt aging resistance for composite core rods. Polymers 14(12):2394. https://doi.org/10.3390/polym14122394

    Article  CAS  Google Scholar 

  22. Shi F, Dai Z, Zhang B (2010) Characterization of the surface tension and solubility parameter of epoxy resin by using inverse gas chromatography. Se Pu 28:697–701. https://doi.org/10.3724/sp.j.1123.2010.00697

    Article  CAS  Google Scholar 

  23. Sun Z, Zhang M, Zhang X, Liang C, Zhang H, Li Y, Ma MY (2021) Study on thermal stability of bisphenol⁃a⁃type epoxy matrix composites doped with nano glass powders. China Plastics 35:15–20. https://doi.org/10.19491/j.issn.1001-9278.2021.09.003

    Article  CAS  Google Scholar 

  24. Saeed A, Shabir G (2013) Synthesis of thermally stable high gloss water dispersible polyurethane/polyacrylate resins. Prog Org Coat 76:1135–1143. https://doi.org/10.1016/j.porgcoat.2013.03.009

    Article  CAS  Google Scholar 

  25. Liu Y, Zhang M, Liu H, Sun Y, Wang W, Liu J (2017) The influences of silane coupling agents on the heat and moisture resistance of basalt fibre-reinforced composites. High Volt 32:25–36. https://doi.org/10.1049/hve2.12217

    Article  Google Scholar 

  26. Sima WX, He JH, Sun PT, Yang M, Yin Z, Li C (2020) Novel nanostructure composite dielectric with high insulation performance: silica-based nanometer-sized porous composite insulating paper reinforced by ceramic fibers. Scr Mater 181:58–61. https://doi.org/10.1016/j.scriptamat.2020.02.016

    Article  CAS  Google Scholar 

  27. Li Z, Zhou W, Yang L, Chen P, Yan C, Cai C, Li H, Li L, Shi Y (2019) Glass fiber-reinforced phenol formaldehyde resin-based electrical insulating composites fabricated by selective laser sintering. Polymers 11(1):135. https://doi.org/10.3390/polym11010135

    Article  CAS  Google Scholar 

Download references

Acknowledgements

The authors acknowledge the financial support from the Fundamental Research Funds for the Central Universities (no. 20226934), and Science and technology project of China Southern Power Grid Co. (no. 073000KK52200014).

Author information

Authors and Affiliations

Authors

Contributions

HL was involved in conceptualization, methodology, validation, writing—review and editing, funding acquisition; YY contributed to software, investigation, data curation, writing—original draft preparation, project administration; MZ was involved in methodology, investigation, writing—review and editing, data curation; HY software, resources, data curation; LL contributed to visualization, supervision, methodology; YL was involved in resources, project administration, validation; HY contributed to formal analysis, visualization, resources; ZT was involved in visualization, supervision, project administration.

Corresponding author

Correspondence to Hechen Liu.

Ethics declarations

Conflict of interest

The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper.

Ethical approval

Not applicable.

Additional information

Handling Editor: Stephen Eichhorn.

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Liu, H., Yu, Y., Zhang, M. et al. Effect of sizing agent on properties of basalt fiber/blended resin matrix composites. J Mater Sci 58, 5642–5657 (2023). https://doi.org/10.1007/s10853-023-08373-y

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10853-023-08373-y

Navigation