Abstract
In this paper, we present a cantilever-type silicon microheater operating at high temperature with low power consumption for the catalytic combustion methane sensor. The cantilever supported silicon microheaters were designed and fabricated with thick device silicon of silicon-on-insulator (SOI) wafer. The temperature dependence and electrical characteristic of the thick-silicon microheater resistor, including a key temperature corresponding to the twist point of temperature coefficient of resistance (TCR) were tested. A series of test microheaters was also designed in order to further investigate the influence of the length of support cantilever on power consumption. The twist point of TCR of the microheater was used as the reference point for the power evaluation. Experimental results demonstrated that the solid state heat conduction dominates the power losses and the total power consumption can be reduced to a satisfied minimum about 60 mW with the length-extension of the support cantilever for the thick silicon heater. Results also showed that the thick silicon heater is suitable for gas sensor operating at the high temperature with low power consumption, which is a particularly attractive quality for the use of battery-operated handheld methane gas monitoring.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Afridi MY, Suehle JS, Zaghloul ME, Berning DW, Hefner AR, Cavicchi RE, Semancik S, Montgomery CB, Taylor CJ (2002) A monolithic CMOS microhotplate-based gas sensor system. IEEE Sens J 2(6):644–655. doi:10.1109/jsen.2002.807780
Baker AR (1962) Combustible gas-detecting, electrically heatable element. UK patent, 892530
Baroncini M, Placidi P, Cardinali GC, Scorzoni A (2004) Thermal characterization of a microheater for micromachined gas sensors. Sens Actuators A: Phys 115(1):8–14. doi:10.1016/j.sna.2004.03.012
Briand D, Krauss A, van der Schoot B, Weimar U, Barsan N, Göpel W, de Rooij NF (2000) Design and fabrication of high-temperature micro-hotplates for drop-coated gas sensors. Sens Actuators B: Chem 68(1–3):223–233. doi:10.1016/s0925-4005(00)00433-0
Capone S, Forleo A, Francioso L, Rella R, Siciliano P, Spadavecchia J, Presicce DS, Taurino AM (2003) Solid state gas sensors: state of the art and future activities. J Optoelectron Adv Mater 5(5):1335–1348
Firth JG, Jones A, Jones TA (1973) The principles of the detection of flammable atmospheres by catalytic devices. Combust Flame 20:303–311
Götzl A, Gràcia I, Cané C, Lora-Tamayo E (1997) Thermal and mechanical aspects for designing micromachined low-power gas sensors. J Micromech Microeng 7(3):247. doi:10.1088/0960-1317/7/3/045
Graf M, Barrettino D, Zimmermann M, Hierlemann A, Baltes H, Hahn S, Bârsan N, Weimar U (2004) CMOS monolithic metal-oxide sensor system comprising a microhotplate and associated circuitry. IEEE Sens J 4(1):9–16. doi:10.1109/jsen.2003.820367
Guha PK, Ali SZ, Lee CCC, Udrea F, Milne WI, Iwaki T, Covington JA, Gardner JW (2007) Novel design and characterisation of SOI CMOS micro-hotplates for high temperature gas sensors. Sens Actuators B: Chem 127(1):260–266. doi:10.1016/j.snb.2007.07.047
Hongyu M, Lei W, Jing S, Weidong Z, Enjie D (2012) TCR sign variation of surface micromachined polysilicon resistor under Joule self-heating. Integr Ferroelectr 136(1):99–105. doi:10.1080/10584587.2012.686802
Hongyu M, Enjie D, Wenjuan W (2013) Power reduction with enhanced sensitivity for pellistor methane sensor by improved thermal insulation packaging. Sens Actuators B: Chem 187:221–226. doi:10.1016/j.snb.2012.10.121
Jones TA, Walsh PT (1988) Flammable gas detection. Platin Met Rev 32(2):50–60
Jun Y, Zhen’An T, Zhengxing H, Philip CHC (2008) Thermal crosstalk of micro hotplate arrays. Chin J Semicond-Chin Ed 29(8):1581–1584. doi:10.3321/j.issn:0253-4177.2008.08.033
Krebs P, Grisel A (1993) A low power integrated catalytic gas sensor. Sens Actuators B: Chem 13(1–3):155–158. doi:10.1016/0925-4005(93)85349-f
Lee J, King WP (2007) Microcantilever hotplates: design, fabrication, and characterization. Sens Actuators A 136(1):291–298. doi:10.1016/j.sna.2006.10.051
Lei X, Tie L, Xiuli G, Yuelin W (2011a) Development of a reliable micro-hotplate with low power consumption. IEEE Sens J 11(4):913–919. doi:10.1109/jsen.2010.2064765
Lei X, Tie L, Yuelin W (2011b) A novel three-dimensional microheater. IEEE Electron Device Lett 32(9):1284–1286. doi:10.1109/LED.2011.2160145
Lei X, Tie L, Xiuli G, Yuelin W (2012) A high-herformance three-dimensional microheater-based catalytic gas sensor. IEEE Electron Device Lett 33(2):284–286. doi:10.1109/led.2011.2177805
Moseley PT (1997) Solid state gas sensors. Meas Sci Technol 8(3):223. doi:10.1088/0957-0233/8/3/003
Pagonis DN, Kaltsas G, Nassiopoulou AG (2004) Fabrication and testing of an integrated thermal flow sensor employing thermal isolation by a porous silicon membrane over an air cavity. J Micromech Microeng 14(6):793. doi:10.1088/0960-1317/14/6/005
Rossi C, Scheid E, Estève D (1997) Theoretical and experimental study of silicon micromachined microheater with dielectric stacked membranes. Sens Actuators A 63(3):183–189. doi:10.1016/s0924-4247(97)80503-1
Rossi C, Temple-Boyer P, Estève D (1998) Realization and performance of thin SiO2/SiNx membrane for microheater applications. Sens Actuators A 64(3):241–245. doi:10.1016/s0924-4247(97)01627-0
Santra S, Udrea F, Guha PK, Ali SZ, Haneef I (2010) Ultra-high temperature (>300°C) suspended thermodiode in SOI CMOS technology. Microelectron J 41(9):540–546. doi:10.1016/j.mejo.2009.12.005
Sberveglieri G, Hellmich W, Müller G (1997) Silicon hotplates for metal oxide gas sensor elements. Microsyst Technol 3(4):183–190. doi:10.1007/s005420050078
Zhang FT, Tang Z, Yu J, Jin RC (2006) A micro-Pirani vacuum gauge based on micro-hotplate technology. Sens Actuators A 126(2):300–305. doi:10.1016/j.sna.2005.10.016
Acknowledgments
This research project was sponsored by the Jiangsu Provincial Natural Science Foundation (No. BK2012565), the Projects in the National Science and Technology Pillar Program of China (No. 2012BAH12B01, 2012BAH12B02), and the Fundamental Research Funds for the Central Universities (No. 2011QNB22). The authors wish to thank Mr. Jie He, Mrs. Liling Sun of the GermanTech Co., Ltd. and Prof. and Dr. Tao Wu of the University of Nottingham Ningbo China for their measurement help. The authors are also grateful for the insightful comments and critical analysis provided by the anonymous reviewers.
Conflict of interest
The authors declare no conflict of interest.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Ma, H., Wang, W., Ding, E. et al. Cantilever-type microheater fabricated with thick silicon. Microsyst Technol 21, 801–807 (2015). https://doi.org/10.1007/s00542-014-2288-3
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00542-014-2288-3