Skip to main content
SpringerLink
Log in

Effect of combined polymers on the loss of efficiency caused by mechanical degradation in drag reducing flows through straight tubes

  • Original Contribution
  • Published:
Rheologica Acta Aims and scope Submit manuscript

Abstract

The mechanical molecular degradation in drag reducing flows is a huge problem in the effort to improve the efficiency of drag reducers, which is clearly increased when a combination of materials is used. Here, we analyze mixtures of three kinds of water-soluble polymers: Poly (ethylene oxide) (PEO), Polyacrylamide (PAM), and Xanthan Gum (XG). Two kinds of mixtures are tested: (a) PAM and XG; (b) PEO and XG. The synergy between the polymers is clearly noticeable. The values of the drag reduction (DR) obtained by the polymer–polymer combination was larger than that observed for a single polymer in a solution with the same total concentration of the mixture. Our tests are conducted in straight tubes where the total pressure is fixed. The values of DR are computed step-by-step, as the total amount of solution pass through the system. In doing so, we carefully took into account the loss of efficiency caused by the turbulent flow in the straight tubes. It is quite clear that the degradation of the flexible polymers (PEO and PAM) is delayed in the mixtures. In other words, besides the increase in the DR, the flexible polymers are more resistant when in the presence of the rigid one (XG). Such observation is the main conclusion of this work.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13

Similar content being viewed by others

References

  • Andrade R.M., Pereira A.S., Soares E.J. (2014) Drag increase at the very start of drag reducing flows in a rotating cylindrical double gap device. J Non-Newtonian Fluid Mech 212:73–79

    Article  Google Scholar 

  • Andrade R.M., Pereira A.S., Soares E.J. (2016) Drag reduction in synthetic seawater by flexible and rigid polymer addition into a rotating cylindrical double gap device. ASME J Fluids Eng 138: 021101

    Article  Google Scholar 

  • Benzi R. (2010) A short review on drag reduction by polymers in wall bounded turbulence. Physical D 239:1338–1345

    Article  Google Scholar 

  • Berman N.S. (1978) Drag reduction by polymers. Annual Reviews of Fluid Mechanics 10:47–64

    Article  Google Scholar 

  • Burger E.D., Chorn L.G. (1980) Studies of drag reduction conducted over a broad range of pipeline conditions when flowing Prudhoe Bay crude oil. J. Rheology 24:603

    Article  Google Scholar 

  • Deutsch S., Fontaine A.A., Moeny M.J., Petrie H.L. (2006) Combined polymer and microbubble drag reduction on a large flat plate. J Fluid Mech 556:309–327

    Article  Google Scholar 

  • Dingilian G., Ruckenstein E. (1974) Positive and negative deviations from additivity in drag reduction of binary dilute polymer solutions. AIChE Journal 20(6):1222–1224

    Article  Google Scholar 

  • Dschagarowa E., Bochossian T. (1978) Drag reduction in polymer mixtures. Rheologica Acta 17:426–432

    Article  Google Scholar 

  • Dubief Y., Terrapon V.E., Soria J. (2013) On the mechanism of elasto-inertial turbulence. Phys Fluids 25:110817

    Article  Google Scholar 

  • Dubief Y., White C.M., Terrapon V.E., Shaqfeh E.S.G., Moin P., Lele S.K. (2004) On the coherent drag-reducing and turbulence-enhancing behaviour of polymers in wall flows. J. Fluid Mech 514:271–280

    Article  Google Scholar 

  • Fabula A.G. (1971) Fire-fighting benefits of polymeric friction reduction. Trans ASME J Basic Engng:93–453

  • Flory P.J. (1971) Principles of polymer chemistry Cornell university press. NY, Ithaca

    Google Scholar 

  • Forrest F., Grierson G.A. (1931) Friction losses in cast iron pipe carrying. Paper Trade Journal 92:39–41

    Google Scholar 

  • Greene H.L., Mostardi R.F., Nokes R.F. (1980) Effects of drag reducing polymers on initiation of atherosclerosis. Polym Engng Sci:20–449

  • Gyr A., Bewersdorff H.W. (1995) Drag reduction of turbulent flows by additives, vol 32. Kluwer Academic Publishers, Dordrecht. fluid mechanics and its application edition

    Book  Google Scholar 

  • Hunston D.L. (1974) Drag reduction in polymer mixtures and the effect of molecular weight distribution. Nature 251:697

    Article  Google Scholar 

  • Kameneva Marina V. (2012) Microrheological effects of drag-reducing polymers in vitro and in vivo. Int J Eng Sci 59:168–183

    Article  Google Scholar 

  • Lee W., Vaseleski R., Metzner A. (1974) Turbulent drag reduction in polymeric solutions containing suspended fibres. AIChE Journal 20:128–133

    Article  Google Scholar 

  • Lumley J.L. (1969) Drag reduction by additives. Ann Rev Fluid Mech 11:367–384

    Article  Google Scholar 

  • Malhotra J.P., Chatuverdi P.N., Singh R.P. (1988) Drag reduction by polymer-polymer mixtures. Jounal of Applied Polymer Science 36(4):837–858

    Article  Google Scholar 

  • Matras Z., Kopiczak B. (2015) Intensification of drag reduction effect by simultaneous addition of surfactant and high molecular polymer into the solvent. Chem Eng Res Des 96:35–42

    Article  Google Scholar 

  • Mohsenipou A.A. (2013) The role of surfactants in mechanical degradation of drag-reducing polymers. Ind Eng Chem Res 52:1291–1302

    Article  Google Scholar 

  • Mysels K.J. (1949) Flow of thickened fluid. December 27. US Patent 2(492):173

    Google Scholar 

  • Pereira A.S., Soares E.J. (2012) Polymer degradation of dilute solutions in turbulent drag reducing flows in a cylindrical double gap rheometer device. J Non-Newtonian Fluid Mech 179:9– 22

    Article  Google Scholar 

  • Pereira A.S., Andrade R.M., Soares E.J. (2013) Drag reduction induced by flexible and rigid molecules in a turbulent flow into a rotating cylindrical double gap device: Comparison between Poly (ethylene oxide), Polyacrylamide, and Xanthan Gum. J Non-Newt Fluid Mech 202:72–87

    Article  Google Scholar 

  • Reddy G.V., Singh R.P. (1985) Drag reduction effectiveness and shear stability of polymer-polymer and polymer-fibre mixtures in recirculatory turbulent flow of water. Rheol Acta 24:296–311

    Article  Google Scholar 

  • Sellin R.H.J., Hoyt J.W., Poliert J., Scrivener O. (1982) The effect of drag reducing additives on fluid flows and there industrial applications part II: present applications and futures proposals. J Hydraul Res 20:235–292

    Article  Google Scholar 

  • Shetty A.M., Solomon M.J. (2009) Aggregation in dilute solutions of high molar mass poly(ethylene) oxide and its effect on polymer turbulent drag reduction. Polymer 50:261–270

    Article  Google Scholar 

  • Soares E.J., Sandoval G.A.B., Silveira L., Pereira A.S., Trevelin R., Thomaz F. (2015) Loss of eciency of polymeric drag reducers induced by high Reynolds number ows in tubes with imposed pressure. Phys. Fluids 27:125105

    Article  Google Scholar 

  • Steele A., Bayer I.S., Loth E. (2014) Pipe flow drag reduction effects from carbon nanotube additives. Carbon 77:1183–1186

    Article  Google Scholar 

  • Tabor M., de Gennes P.G. (1986) A cascade theory of drag reduction. Europhysics Letter 7:519–522

    Article  Google Scholar 

  • Toms B.A. (1948) Some observations on the flow of linear polymer solutions through straight tubes at large Reynolds numbers. In: Proceedings of the International Congress of Rheology, Holland, North-Holland, Amsterdam, Section II, pp 135–141

  • Virk P.S. (1975) Drag reduction fundamentals. AIChE J 21:625– 656

    Article  Google Scholar 

  • White C.M., Mungal M.G. (2008) Mechanics and prediction of turbulent drag reduction whit polymer additives. Ann Rev Fluid Mech 40:235–256

    Article  Google Scholar 

  • Wyatt N.B., Gunther C.M., Liberatore M.W. (2011) Drag reduction effectiveness of dilute and entangled xanthan in turbulent pipe flow. J Non-Newtonian Fluid Mech 166:25–31

    Article  Google Scholar 

Download references

Acknowledgments

This research was partially funded by grants from CNPq (Conselho Nacional de Pesquisa e Desenvolvimento), ANP (Agência Nacional de Petróleo), and PETROBRAS.

Author information

Authors and Affiliations

  1. LABREO, Department of Mechanical Engineering, Universidade Federal do Espirito Santo, Avenida Fernando Ferrari, 514, Goiabeiras, Vitória, 29075-910, ES, Brazil

    Gustavo A. B. Sandoval & Edson J. Soares

Authors
  1. Gustavo A. B. Sandoval
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Edson J. Soares
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Edson J. Soares.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

B. Sandoval, G.A., Soares, E.J. Effect of combined polymers on the loss of efficiency caused by mechanical degradation in drag reducing flows through straight tubes. Rheol Acta 55, 559–569 (2016). https://doi.org/10.1007/s00397-016-0927-6

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s00397-016-0927-6

Keywords

Search

Navigation