Skip to main content

Advertisement

Log in

Three-phase SEPIC PFC for three-phase IM drive under unbalanced and distorted voltage supply

  • Original Paper
  • Published:
Electrical Engineering Aims and scope Submit manuscript

Abstract

This paper proposes a three-phase power factor correction (PFC) for a three-phase induction motor (IM) drive under normal and abnormal supply voltage conditions. A new technique of PFC based on a positive sequence components method is introduced. The PFC circuit uses a SEPIC converter with a single switch, which needs only one control signal. The PFC control method with the proposed technique provides nearly sinusoidal supply currents maintaining a high power factor under different supply voltage conditions. Furthermore, the PFC method maintains DC bus voltage at the desired value. The regulated DC voltage feeds a four-switch inverter of the three-phase IM drive system. Mathematical analysis of the equivalent circuits based on operation modes of the SEPIC converter is introduced. The performance of the proposed technique is evaluated under ideal and non-ideal supply voltage conditions. The results are analyzed in terms of reduction in the THD of supply currents and improvement of power factor. System validation performed in simulation and experiment has shown the effectiveness of the proposed system under different supply voltage conditions.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 16
Fig. 17
Fig. 18
Fig. 19
Fig. 20
Fig. 21

Similar content being viewed by others

References

  1. Kim K, Parlos AG, Bharadwaj AG (2003) Sensorless fault diagnosis of induction motors. IEEE Trans Ind Electron 50(5):1038–1051

    Article  Google Scholar 

  2. Azazi HZ, El-Kholy EE, Mahmoud SA, Shokralla SS (2014) Power factor correction using predictive current control for three phase induction motor drive system. Electr Power Compon Syst 42(2):190–202

    Article  Google Scholar 

  3. Estima JO, Cardoso AJM (2013) A new algorithm for real-time multiple open-circuit fault diagnosis in voltage-fed PWM motor drives by the reference current errors. IEEE Trans Ind Electron 60(8):3496–3505

    Article  Google Scholar 

  4. Bhim S, Bhuvaneswari G, Garg V (2006) Power-quality improvements in vector-controlled induction motor drive employing pulse multiplication in AC–DC converters. IEEE Trans Power Deliv 21(3):1578–1586

    Article  Google Scholar 

  5. Takeuchi N, Matsui K, Ueda F, Mori H (2008) A novel PFC circuit using ladder type filter employing only passive devices. In: Proceedings of the IEEE APEC conference, pp 1005–1009

  6. Ahmed OA, Bleijs JAM (2008) Three phase passive bridge rectifier with low distortion input current and boosted DC output voltage. In: Proceedings of the UPEC conference, pp 1–5

  7. Bhuvaneswari G, Singh B, Madishetti S (2012) Three-phase, two-switch PFC rectifier fed three-level VSI based FOC of induction motor drive. In: IEEE fifth power India conference

  8. Al-Ali AR, Negm MM, Kassas M (2000) A PLC based power factor controller for a 3-phase induction motor. In: IEEE industry applications conference

  9. N. Zabihi, R. Gouws, “Improving Energy Consumption of an Induction Motor by Design of a Power Factor Correction System and Estimation of it’s saving on a Large Scale,” IEEE International Conference on Industrial and Commercial Use of Energy (ICUE), 2014.‏

  10. Baek J et al (2018) A new standby structure integrated with boost PFC converter for server power supply. IEEE Trans Power Electron 36(6):5283–5293

    Article  Google Scholar 

  11. Gonzalez-Ramirez M, Cruz-Villar CA (2017) Variable speed drive with PFC front-end for three-phase induction motor. IET Electron Lett 53(16):1139–1140

    Article  Google Scholar 

  12. Kamnarn U, Chunkag V (2009) Analysis and design of a modular three-phase AC-to-DC converter using CUK rectifier module with nearly unity power factor and fast dynamic response. IEEE Trans Power Electron 24(8):2000–2012

    Article  Google Scholar 

  13. Chiang HC, Lin FJ, Chang JK, Chen KF, Chen YL, Liu KC (2016) Control method for improving the response of single-phase continuous conduction mode boost power factor correction converter. IET Power Electron 9(9):1792–1800

    Article  Google Scholar 

  14. Crisbin P, Sasikumar M (2016) Analysis of PFC cuk and PFC sepic converter based intelligent controller fed BLDC motor drive. In: Second international conference on science technology engineering and management (ICONSTEM). IEEE

  15. Deshpande P, Mopari SS, Swami PS (2019) Power factor correction and power quality improvement in BLDC motor drive using SEPIC converter. In: IEEE international conference on electrical, computer and communication technologies (ICECCT)

  16. Liu Y, Sun Y, Mei S (2017) A control method for bridgeless Cuk/Sepic PFC rectifier to achieve power decoupling. IEEE Trans Ind Electron 64(9):7272–7276

    Article  Google Scholar 

  17. Wu D et al (2019) High performance active-clamped isolated SEPIC PFC converter with SiC devices and lossless diode clamp. IEEE J Emerg Sel Top Power Electron 8:567–577

    Article  Google Scholar 

  18. Patel US, Shiva Kumar S, Kommukuri VS (2019) Power factor correction using continuous conduction mode based bridgeless SEPIC converter for improved THD and voltage regulation. In: International conference on vision towards emerging trends in communication and networking (ViTECoN). IEEE

  19. Chomat M, Schreier L (2003) Power factor correction in voltage source inverter under unbalanced three-phase voltage supply conditions. In: IEEE international symposium on industrial electronics (Cat. No. 03TH8692), vol 1. IEEE

  20. Chomat M, Ludek S (2002) Compensation of unbalanced three-phase voltage supply in voltage source inverter. In: IEEE 2002 28th annual conference of the industrial electronics society. IECON 02, vol 2. IEEE, pp 950–955

  21. Baumann M, Kolar JW (2005) A novel control concept for reliable operation of a three-phase three-switch buck-type unity-power-factor rectifier with integrated boost output stage under heavily unbalanced mains condition. IEEE Trans Ind Electron 52(2):399–409

    Article  Google Scholar 

  22. Cichowlas M, Mariusz M, Kazmierkowski MP, Sobczuk DL, Rodríguez P, Pou J (2005) Active filtering function of three-phase PWM boost rectifier under different line voltage conditions. IEEE Trans Ind Electron 52(2):410–419

    Article  Google Scholar 

  23. Guo X, Ren H-P, Li J (2017) Robust model-predictive control for a compound active-clamp three-phase soft-switching PFC converter under unbalanced grid condition. IEEE Trans Ind Electron 65(3):2156–2166

    Article  Google Scholar 

  24. Sun D, Su J, Sun C, Nian H (2018) A simplified MPFC with capacitor voltage offset suppression for the four-switch three-phase inverter-fed PMSM drive. IEEE Trans Ind Electron 66(10):7633–7642

    Article  Google Scholar 

  25. Klima J (2006) Analytical investigation of an induction motor fed from four-switch VSI with a new space vector modulation strategy. IEEE Trans Energy Convers 21(4):832–838

    Article  Google Scholar 

  26. El Badsi B, Bouzidi B, Masmoudi A (2013) DTC scheme for a four-switch inverter-fed induction motor emulating the six-switch inverter operation. IEEE Trans Power Electron 28(7):3528–3538

    Article  Google Scholar 

  27. Dasgupta S, Mohan SN, Sahoo SK, Panda SK (2012) Application of four-switch-based three-phase grid-connected inverter to connect renewable energy source to a generalized unbalanced microgrid system. IEEE Trans Ind Electron 60(3):1204–1215

    Article  Google Scholar 

  28. Sajeev S, Mathew A (2013) Novel cost effective induction motor drive with bridgeless PFC and four switch inverter. In: International conference on emerging trends in communication, control, signal processing and computing applications (C2SPCA). IEEE, pp 1–6

  29. Azazi HZ, Ahmed SM, Lashine AE (2018) Single-stage three-phase boost power factor correction circuit for AC–DC converter. Int J Electron 105(1):30–41

    Article  Google Scholar 

  30. Basilio JC, Matos SR (2002) Design of PI and PID controllers with transient performance specification. IEEE Trans Educ 45(4):364–370

    Article  Google Scholar 

  31. Zaky MS, Touti E, Azazi HZ (2018) Two-degrees of freedom and variable structure controllers for induction motor drives. Adv Electr Comput Eng 18(1):71–80

    Article  Google Scholar 

  32. Zaky MS, Metwaly MK (2017) A performance investigation of a four-switch three-phase inverter-fed IM drives at low speeds using fuzzy logic and PI controllers. IEEE Trans Power Electron 32(5):3741–3753

    Article  Google Scholar 

Download references

Acknowledgements

This work was supported by the College of Engineering Scientific Research Center under the Deanship of Scientific Research of King Khalid University under Grant No. 276.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Z. M. Salem Elbarbary.

Additional information

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Appendix

Appendix

See Tables 1 and 2.

Table 1 IM parameters
Table 2 Parameters of SEPIC converter

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Al-Gahtani, S.F., Azazi, H.Z. & Elbarbary, Z.M.S. Three-phase SEPIC PFC for three-phase IM drive under unbalanced and distorted voltage supply. Electr Eng 103, 357–371 (2021). https://doi.org/10.1007/s00202-020-01085-5

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s00202-020-01085-5

Keywords

Navigation