Abstract
To study the transverse temperature uniformity with transverse flux induction heating (TFIH) during endless strip production (ESP) rolling, a coupled electromagnetic-thermal finite element model of transverse flux induction heating is established. The initial temperature distribution at the TFIH inlet is taken into consideration, which is the basis of subsequent numerical studies. Magnetic screens are designed to weaken the influence of edge overheating, and the influence of magnetic shielding amounts on temperature uniformity is discussed. Moreover, an evaluation criterion is provided to determine the temperature uniformity. Furthermore, the effect of different shielding amounts on the edge temperature is studied. An ideal temperature distribution at the TFIH outlet is obtained based on a model combining various shielding amounts, and the temperature standard deviation of this method is 2.01% lower than the traditional arrangement of magnetic shielding amounts. Actual data are collected to verify the results of the proposed model. The temperature deviation between the middle and edge is approximately 12°C, and the temperature uniformity is enhanced with the optimized combination of magnetic shielding amounts.
Similar content being viewed by others
References
Arvedi G, Mazzolari F, Siegl J, Hohenbichler G, Holleis G (2010) Arvedi ESP first thin slab endless casting and rolling results. Ironmak Steelmak 37(4):271–275
Zhang H, He X (2020) Status and analyses of equipment and technology for ultra- thin hot rolled strip, 716 (4) 1-7
Lucía O, Maussion P, Dede EJ, Burdío JM (2014) Induction heating technology and its applications: past developments, current technology and future challenges. IEEE Trans Ind Electron 61(5):2509–2520
Bao L, Wang B, You XP, Li HP, Gu Y, Liu WJ (2020) Numerical and experimental research on localized induction heating process for hot stamping steel sheets. Int J Heat Mass Transf 151:119422
Fu X, Wang B, Zhu X, Tang X, Ji H (2016) Numerical and experimental investigations on large-diameter gear rolling with local induction heating process. Int J Adv Manuf Technol 91(1-4):1–11
Cho KH (2012) Coupled electro-magneto-thermal model for induction heating process of a moving billet. Int J Therm Sci 60:195–204
Kranjc M, Zupanic A, Miklavcic D, Jarm T (2010) Numerical analysis and thermographic investigation of induction heating. Int J Heat Mass Transf 53:3585–3591
Han Y, Yu E, Zhao T (2016) Three-dimensional analysis of medium-frequency induction heating of steel pipes subject to motion factor. Int J Heat Mass Transf 101:452–460
Liu Y, Tani M, Kurata M, Watase C, Nishiyama M (2020) Study on I-shaped section steel braces partially strengthened by induction heating. Eng Struct 210:110341
Barba PD, Dughiero F, Savini A (2003) Multiobjective shape design of an inductor for transverse-flux heating of metal strips. IEEE Trans Magn 39(3):1519–1522
Aiello G, Alfonzetti S, Rizzo SA, Salerno N (2020) Optimization of the shape of an induction heating device in the presence of skin effect in the coils. COMPEL International Journal for Computation and Mathematics in Electrical and Electronic Engineering 39(2):525–531
Hou XG, Li J, Zhou YM (2016) Development of transverse flux induction heating for wide rang size strip. Baosteel Technology 3:7–15
Wang Z, Yang X, Wang Y, Yan W (2001) Eddy current and temperature field computation in transverse flux induction heating equipment for galvanizing line. IEEE Trans Magn 37(5):3437–3439
Mohring JU, Lemann HJ, Muhlbauer A, Nacke B (2007) Numerical and experimental investigations into transverse flux induction heating. European Transactions on Electrical Power 7(3):157–164
Tiberiu T, Fireteanu V (2008) Magneto-thermal-motion coupling in transverse flux heating. COMPEL International Journal for Computation and Mathematics in Electrical and Electronic Engineering 27(2):399–407
Dughiero F, Forzan M, Lupi S, Tasca M (1998) Numerical and experimental analysis of an electro-thermal coupled problem for transverse flux induction heating equipment. IEEE Trans Magn 34(5):3106–3109
Nerg J, Partanen J (2000) Numerical solution of 2D and 3D induction heating problems with nonlinear material properties taken into account. IEEE Trans Magn 36(5):3119–3121
Fireteanu V, Tudorache T (2000) Electromagnetic forces in transverse flux induction heating. IEEE Trans Magn 36(4):1792–1795
Zlobina M, Galunin S, Blinov Y, Nacke B, Nikanorov A, Schülbe H (2003) Numerical modelling of non-linear transverse flux heating systems. Stainless Steel 28(3):639–655
Virgiliu F, Monica P, Sorin P, Petrica T (2012) Transversal flux scanning induction heating of magnetic nonlinear steel sheets with temperature dependent properties. J Iron Steel Res Int 19:717–721
Wang YH, Li B, Yin LX, Wu JC, Wu SP, Liu CC (2019) Velocity-controlled particle swarm optimization (PSO) and its application to the optimization of transverse flux induction heating apparatus. Energies 12:487
Wu JC, Wang S, Wang YH, Liu CC (2020) Sensitivity analysis of design parameters in transverse flux induction heating device. IEEE Trans Appl Supercond 30(4):0600406
Huang MS, Huang YL (2010) Effect of multi-layered induction coils on efficiency and uniformity of surface heating. Int J Heat Mass Transf 53:2414–2423
Wang YH, Wang JH, Pang LL, Ho SL, Fu WN (2011, 07E511) An advanced double-layer combined windings transverse flux system for thin strip induction heating. J Appl Phys 109
Virgiliu F, Philippe R (2013) Finite element analysis of the transverse flux induction heating of moving magnetic steel sheets. International Symposium on Advanced Topics in Electrical Engineering, IEEE
Dughiero F, Lupi S, Müehlbauer A, Nikanorov A (2003) TFH - transverse flux induction heating of non-ferrous and precious metal strips Results of an EU research project. COMPEL 22(1):134–148
Pevzner MZ (2010) Temperature and property distribution over the width of a strip annealed in a transverse magnetic field. Met. Sci. Heat Treat. MET 52(7-8):382–387
Mei RB, Li CS, Han B, Liu XH (2008) Finite element analysis of slab steel in the process of induction heating. Mater Sci Forum 575-578:282–287
Tan Z, Guo GW (1994) Thermophysical properties of engineering alloys. Metallurgical Industry Press, Beijing
Wang YH, Wu JC, Liu CC, Chen L (2019) Simulation and analysis of eddy current field of strips during transverse flux continuous induction heating. Heat Treat Met 44(01):229–234
Zhao X, Kang Y, Liu X, Chen L, Lin H (2011) Numerical simulation of temperature field for the super long slab reheating of semi-endless rolling. J Iron Steel Res Int 23(8):16–20
Availability of data and material
The authors confirm that the data and material supporting the findings of this work are available within the article.
Funding
This work was financially supported by the National Natural Science Foundation of China (No. 51704067; 51774084; 52074085) and the Fundamental Research Funds for the Central Universities (No. N180704006; N170708020; N2004010).
Author information
Authors and Affiliations
Contributions
Wen Peng: conceptualization, methodology, supervision, validation, writing—reviewing and editing. Xiaorui Chen: investigation, methodology, visualization, data curation, writing—original draft preparation. Li Zhang: data curation. Xudong Li: investigation, validation. Jie Sun: methodology, supervision, writing—reviewing and editing. Dianhua Zhang: conceptualization, project administration, supervision, validation, writing—reviewing and editing
Corresponding author
Ethics declarations
Ethical approval
The article follows the guidelines of the Committee on Publication Ethics (COPE) and involves no studies on human or animal subjects.
Consent to participate
Not applicable.
Consent to publish
This work is approved by all authors for publication.
Conflict of interest
The authors declare no conflict competing interests.
Additional information
Publisher’s note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Peng, W., Chen, X., Zhang, L. et al. Finite element analysis of temperature uniformity in transverse induction heating process in ESP rolling. Int J Adv Manuf Technol 115, 3423–3439 (2021). https://doi.org/10.1007/s00170-021-07386-8
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00170-021-07386-8