Abstract
Bauxite residue, also known as red mud (RM), is a kind of industrial solid waste with high alkali content, complex composition and difficult utilization. In this study, a new type of RM-based adsorbent was prepared by using polyethylene glycol modified RM and was used to remove low concentration of COS in flue gas. The optimum preparation conditions of adsorbent and the optimum technological parameters of COS adsorption purification were investigated. Under the optimal conditions, the adsorption efficiency of the new adsorbent exceeds 95%, and the COS adsorption capacity reaches 63.56 mg/m3. The characterization results showed that the main active components of the adsorbent were active alkali, FeOOH and Fe3O4, and the main products were Na2S2O3, Na2SO4, FeS and FeS2.
Similar content being viewed by others
References
Cao Y, Zheng X, Du Z et al (2019) Low-temperature H2S removal from gas streams over γ-FeOOH, γ-Fe2O3, and α-Fe2O3: effects of the hydroxyl group, defect, and specific surface area. Ind Eng Chem Res 58(42):19353–19360. https://doi.org/10.1021/acs.iecr.9b03430
Chen S, Guo Y, Zhang J et al (2021) CuFe2O4/activated carbon adsorbents enhance H2S adsorption and catalytic oxidation from humidified air at room temperature. Chem Eng J. https://doi.org/10.1016/j.cej.2021.134097
Harnisch J, Borchers R, Fabian P, Kourtidis K (1995) Aluminium production as a source of atmospheric carbonyl sulfide (COS). Environ Sci Pollut Res 2(2):115. https://doi.org/10.1007/BF02987529
Laajalehto K, Kartio I, Suoninen E (1997) XPS and SR-XPS techniques applied to sulphide mineral surfaces. Int J Miner Process 51(1):163–170. https://doi.org/10.1016/S0301-7516(97)00029-X
Li Y, van Santen RA, Weber T (2008) High-temperature FeS–FeS2 solid-state transitions: reactions of solid mackinawite with gaseous H2S. J Solid State Chem 181(11):3151–3162. https://doi.org/10.1016/j.jssc.2008.08.024
Mayes WM, Jarvis AP, Burke IT et al (2011) Dispersal and attenuation of trace contaminants downstream of the Ajka Bauxite residue (red mud) depository failure, Hungary. Environ Sci Technol 45(12):5147–5155. https://doi.org/10.1021/es200850y
Qi X, Wang H, Huang C et al (2018) Analysis of bauxite residue components responsible for copper removal and related reaction products. Chemosphere 207:209–217. https://doi.org/10.1016/j.chemosphere.2018.05.041
Qi X, Wang H, Zhang L et al (2020) Removal of Cr (III) from aqueous solution by using bauxite residue (red mud): Identification of active components and column tests. Chemosphere 245:125560. https://doi.org/10.1016/j.chemosphere.2019.125560
Qiu J, Ning P, Wang X et al (2016) Removing carbonyl sulfide with metal-modified activated carbon. Front Environ Sci Eng 10(1):11–18. https://doi.org/10.1007/s11783-014-0714-5
Raabe T, Mehne M, Rasser H et al (2019) Study on iron-based adsorbents for alternating removal of H2S and O2 from natural gas and biogas. Chem Eng J 371:738–749. https://doi.org/10.1016/j.cej.2019.04.103
Shen M, Wen H, Hao T et al (2015) Deactivation mechanism of SO2 on Cu/SAPO-34 NH3-SCR catalysts: structure and active Cu2+. Catal Sci Technol 5(3):1741–1749. https://doi.org/10.1039/C4CY01129E
Shen L, Cao Y, Du Z et al (2017) Illuminate the active sites of γ-FeOOH for low-temperature desulfurization. Appl Surf Sci 425:212–219. https://doi.org/10.1016/j.apsusc.2017.06.295
Sparks DE, Morgan T, Patterson PM et al (2008) New sulfur adsorbents derived from layered double hydroxides. Appl Catal B 82(3–4):190–198. https://doi.org/10.1016/j.apcatb.2008.01.012
Tian H, Wu J, Zhang W et al (2017) High performance of Fe nanoparticles/carbon aerogel sorbents for H2S removal. Chem Eng J 313:1051–1060. https://doi.org/10.1016/j.cej.2016.10.135
Vachon P, Tyagi RD, Auclair JC, Wilkinson KJ (1994) Chemical and biological leaching of aluminum from red mud. Environ Sci Technol 28(1):26–30. https://doi.org/10.1021/es00050a005
Wang M, Liu X (2021) Applications of red mud as an environmental remediation material: a review. J Hazard Mater 408:124420. https://doi.org/10.1016/j.jhazmat.2020.124420
Wang Y, Chen S, Chen H et al (2013) Removal of carbonyl sulfide from CO2 stream using AgNO3-modified NaZSM-5. J Energy Chem 22(6):902–906. https://doi.org/10.1016/S2095-4956(14)60270-9
Wang X, Ma Y, Ning P et al (2014) Adsorption of carbonyl sulfide on modified activated carbon under low-oxygen content conditions. Adsorption 20(4):623–630. https://doi.org/10.1007/s10450-014-9607-y
Wang T, Qian T, Huo L et al (2019) Immobilization of hexavalent chromium in soil and groundwater using synthetic pyrite particles. Environ Pollut 255:112992. https://doi.org/10.1016/j.envpol.2019.112992
Wynnyk KG, Hojjati B, Pirzadeh P, Marriott RA (2017) High-pressure sour gas adsorption on zeolite 4A. Adsorption. https://doi.org/10.1007/s10450-016-9841-6
Xi Y, Su C, Ottinger NA, Liu ZG (2021) Effects of hydrothermal aging on the sulfur poisoning of a Cu-SSZ-13 SCR catalyst. Appl Catal B 284:119749. https://doi.org/10.1016/j.apcatb.2020.119749
Xu J, Cao Z, Zhang Y et al (2018) A review of functionalized carbon nanotubes and graphene for heavy metal adsorption from water: preparation, application, and mechanism. Chemosphere 195:351–364. https://doi.org/10.1016/j.chemosphere.2017.12.061
Xue S, Liu Z, Fan J et al (2022) Insights into variations on dissolved organic matter of bauxite residue during soil-formation processes following 2-year column simulation. Environ Pollut 292:118326. https://doi.org/10.1016/j.envpol.2021.118326
Yan Y, Li R, Peng L et al (2019) Emission inventory of carbonyl sulfide (COS) from primary anthropogenic sources in China. Environ Pollut 247:745–751. https://doi.org/10.1016/j.envpol.2019.01.096
Zhang Y, Qian W, Zhou P et al (2021) Research on red mud-limestone modified desulfurization mechanism and engineering application. Sep Purif Technol 272:118867. https://doi.org/10.1016/j.seppur.2021.118867
Zhao S, Yi H, Tang X et al (2017) Adsorptive removal of carbonyl sulfide by Fe-modified activated carbon: experiments and DFT calculations. Adsorption 23(7–8):1013–1022. https://doi.org/10.1007/s10450-017-9910-5
Zhu L, Lv X, Tong S et al (2019) Modification of zeolite by metal and adsorption desulfurization of organic sulfide in natural gas. J Nat Gas Sci Eng 69:102941. https://doi.org/10.1016/j.jngse.2019.102941
Acknowledgements
This research was supported by the National Key Research and Development Program of China (2019YFC0214404), the National Natural Science Foundation of China (52060010) and the Natural Science Foundation of Yunnan Province (202001AT070088).
Author information
Authors and Affiliations
Corresponding authors
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Zhou, P., Qi, J., Yang, D. et al. Purification of Low-Concentration Carbonyl Sulfide by Red Mud-Based Adsorbent. Bull Environ Contam Toxicol 109, 194–201 (2022). https://doi.org/10.1007/s00128-022-03517-3
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00128-022-03517-3