Abstract
Concrete is a common traditional material used by the construction industry. Depending on the demand, concrete grades like M10, M20, M30, M40, M50, M60, and M70 were commonly used in building construction. Concrete of a higher grade requires cement with good quality characteristics. Cement production generates a significant quantity of carbon emissions. By replacing some of the virgin cement with pozzolanic materials or industrial wastes, it is possible to reduce CO2 emissions. A variety of industrial wastes, including tannery waste, paper pulp, and electroplating waste, were utilized in the current experiment. An analysis of the waste materials is carried out for determining its fundamental qualities. M20 concrete grade was used for the present study and concrete cubes with standard dimensions of 150 × 150 × 150 mm were made using cement, and cubes were also made using the industrial waste as partial replacement for cement. The cubes were evaluated on 7, 14, and 28th days for its compressive strength and tensile strength. The outcome of the study reflects electroplating sludge (also known as chrome waste) had a higher compressive strength and tensile strength when compared to paper pulp and tannery waste.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
Kaish ABMA, Odimegwu TC, Zakaria I, Abood MM (2021) Effects of different industrial waste materials as partial replacement of fine aggregate on strength and microstructure properties of concrete. J Build Eng 35:102092. https://doi.org/10.1016/j.jobe.2020.102092
Singh S, Siddique R (2016) Effect of coal bottom ash as partial replacement of sand on workability and strength properties of concrete. J Clean Prod 112(1):620–630. https://doi.org/10.1016/j.jclepro.2015.08.001
Aggarwal Y, Siddique R (2014) Microstructure, and properties of concrete using bottom ash and waste foundry sand as partial replacement of fine aggregates. Constr Build Mater 54:210–223. https://doi.org/10.1016/j.conbuildmat.2013.12.051
Boukhelkhal A, Azzouz L, Belaïdi ASE, Benabed B (2016) Effects of marble powder as a partial replacement of cement on some engineering properties of self-compacting concrete. J Adhes Sci Technol 30:2405–2419. https://doi.org/10.1080/01694243.2016.1184402
Singh M, Srivastava A, Bhunia D (2017) An investigation on the effect of partial replacement of cement by waste marble slurry. Constr Build Mater 134:471–488. https://doi.org/10.1016/j.conbuildmat.2016.12.155
Pal S, Singh A, Pramanik T, Kumar S, Kisku N (2016) Effects of partial replacement of cement with marble dust powder on properties of concrete. Int J Innov Res Sci Technol 3:41–45. https://doi.org/10.17577/IJERTV3IS030812
John UE, Jeferson I, Boardman DI, Ghataora GS, Hills CD (2011) Leaching evaluation of cement stabilization/solidification treated kaolin clay. Eng Geol 123(4):315–323. https://doi.org/10.1016/j.enggeo.2011.09.004
Mohammed BS, Fang OC (2011) Mechanical and durability properties of concretes containing paper mill residuals and fly ash. Constr Build Mater 25:717–725. https://doi.org/10.1016/j.conbuildmat.2010.07.015
Vegas I, Urreta J, Frías M, García R (2009) Freeze-thaw resistance of blended cement containing calcined paper sludge. Constr Build Mater 23(8). https://doi.org/10.1016/j.conbuildmat.2009.02.034
Houshyar Z, Khoshfetrat AB, Fatehifar E (2012) Influence of ozonization process on characteristics of pre-alkalized tannery effluents. Chem Eng J 191:59–65. https://doi.org/10.1016/j.cej.2012.02.053
Kiliç E, Puig R, Baquero G, Font J, Çolak S, Gürler D (2011) Environmental optimization of chromium recovery from tannery sludge using a life cycle assessment approach. J Hazard Mater 192:393–401. https://doi.org/10.1016/j.jhazmat.2011.05.040
Shakir L, Ejaz S, Ashraf M, Qureshi NA, Anjum AA, Iltaj I, Javeed A (2012) Ecotoxicological risks associated with tannery effluent wastewater. Environ Toxicol Phar 34:180–191. https://doi.org/10.1016/j.etap.2012.03.002
Torras J, Buj I, Rovira M, de Pablo J (2012) Chromium recovery from exhausted baths generated in plating processes and its reuse in the tanning industry. J Hazard Mater 209–210:343–347. https://doi.org/10.1016/j.jhazmat.2012.01.036
Krishnamoorthy G, Sadulla S, Sehgal PK, Mandal AB (2012) Green chemistry approaches the leather tanning process for making chrome-free leather with unnatural amino acids. J Hazard Mater 215–216, 173–182. https://doi.org/10.1016/j.jhazmat.2012.02.046
Nashy ESHA, Al-Ashkar E, Moez AA (2012) Optical and spectroscopic studies on tannery wastes as a possible source of organic semiconductors. Spectrochim Acta A 86:33–38. https://doi.org/10.1016/j.saa.2011.09.052
Sundarapandiyan S, Brutto PE, Siddhartha G, Ramesh R, Ramanaiah B, Saravanan P, Mandal AB (2011) Enhancement of chromium uptake in tanning using oxazolidine. J Hazard Mater 190:802–809. https://doi.org/10.1016/j.jhazmat.2011.03.117.
Basegio T, Beck Leão AP, Bernardes AM, Bergmann CP (2009) Vitrification: an alternative to minimize the environmental impact caused by leather industry wastes. J Hazard Mater 165:604–611. https://doi.org/10.1016/j.jhazmat.2008.10.045
Cassano A, Drioli E, Molinari R, Bertolutti C (1996) Quality improvement of recycled chromium in the tanning operation by membrane processes. Desalination 108:193–203. https://doi.org/10.1016/S0011-9164(97)00027-1
Chaudhari R, Malviya R (2006) Factors affecting hazardous waste solidification/stabilization: a review. J Hazard Mater 137(1):267–276. https://doi.org/10.1016/j.jhazmat.2006.01.065
Chen Y, Ko M, Lai Y, Chang J (2011) Hydration and leaching characteristics of cement paste made from electroplating sludges. Waste Manag 31(6):1257–1363. https://doi.org/10.12989/aer.2014.3.4.337
Shopia AC, Swaminathan K (2005) Assessment of the mechanical stability and chemical leachability of immobilized electroplating waste. Chemosphere 58(1):75–82. https://doi.org/10.1016/j.chemosphere.2004.09.006
Asavapisit S, Avapisit S, Chotkland D (2004) Solidification of electroplating sludge using alkali-activated pulverized fuel ash as cementitious binder. Cement Concrete Resour 34(2):349. https://doi.org/10.1016/j.cemconres.2003.08.012
Gollmann MA, Silva MM, Masuero AB, Santos JHZ (2010) Stabilization and solidification of Pb in cement matrices. J Hazard Mater 179(1–3):507–514. https://doi.org/10.1016/j.jhazmat.2010.03.032
APHA (2017) Standard methods for the examination of wastewater 20th edition by American Public Health Association. American Water Works Association, Water Environment Federation
IS 383:1970 Specifications for course and fine aggregates from natural sources for concrete. Bureau of Indian Standards, New Delhi. https://www.iitk.ac.in/ce/test/IS-codes/is.383.1970.pdf
IS 1489-1 (1991): Specification for portland pozzolana cement, Part 1: Fly ash based. [CED 2: Cement and Concrete]. https://law.resource.org/pub/in/bis/S03/is.1489.1.1991.pdf
ASTM D 3987:2006 Standard test method for shake extraction of solid waste with water. https://www.document-center.com/standards/show/ASTM-D3987/history/2006%20EDITION
NEPM (1999) National environment protection (assessment of site contamination) measure. https://www.legislation.gov.au/Details/F2013C00288
IS 1199:1959 Methods of sampling and analysis of concrete. Bureau of Indian Standards, New Delhi. https://www.iitk.ac.in/ce/test/IS-codes/is.1199.1959.pdf
IS 456:2000 Code of practice for plain and reinforced concrete. Bureau of Indian Standards, New Delhi. https://www.academia.edu/6262807/IS_456_2000
IS 10262 1981 IS method of mix design. Bureau of Indian Standards, New Delhi. https://www.ijsr.net/archive/v8i1/ART20194592.pdf
IS 516-1959 Methods of tests for the strength of concrete. Bureau of Indian Standards, New Delhi. https://www.iitk.ac.in/ce/test/IS-codes/is.516.1959.pdf
Acknowledgements
The Department of Civil Engineering at Annamalai University has provided the authors with laboratory support as well as other infrastructure facilities, for which the authors would like to express their heartfelt gratitude.
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2024 The Author(s), under exclusive license to Springer Nature Singapore Pte Ltd.
About this paper
Cite this paper
Ganapathy, S., Ravi, S., Subramanian, C. (2024). Investigation on Possible use of Industrial Waste as Partial Replacement of Cement in Concrete. In: Reddy, K.R., Ravichandran, P.T., Ayothiraman, R., Joseph, A. (eds) Recent Advances in Civil Engineering. ICC IDEA 2023. Lecture Notes in Civil Engineering, vol 398. Springer, Singapore. https://doi.org/10.1007/978-981-99-6229-7_26
Download citation
DOI: https://doi.org/10.1007/978-981-99-6229-7_26
Published:
Publisher Name: Springer, Singapore
Print ISBN: 978-981-99-6228-0
Online ISBN: 978-981-99-6229-7
eBook Packages: EngineeringEngineering (R0)