Abstract
In this paper, seismic analysis is performed for multi-storey buildings with soil structure–interaction considering pounding effect. Parameters including displacement, shear force, bending moment, and drift ratios are compared for various models. The nonlinear dynamic analysis, i.e. most accurate with time history, is performed on these building structures to compare their behaviour during different strong EQ ground motions. M20-grade concrete and Fe500 steel are used as material of RCC. The structure was assessed again and again for such properties of SSI and pounding. Further corrections are made to these frames so that it meets the minimum requirement possible to make it stiff and sufficient strong to sustain in strong EQ motion. It is observed that the building frames with different storey height exhibits 8% and 23% higher defection than building frames with same storey height at top and bottom levels, respectively. Reduction in moment is observed to be 41.63% for building frames spaced faraway that of closely spaced frames. Hence, the results shown here are for the worst situation possible under the action of SSI effect and pounding.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
Whittaker, A., Constantnou, M., & Tsopelas, P. (1998). Displacement estimates for performance based seismic design. Journal of Structural Division, ASCE, 124 (8), 905–912
Priestley, M. J. N. (2000). Performance based seismic design. Bulletin of the New Zealand Society for Earthquake Engineering, 33, 325–346.
Chopra, A. K., & Chintanapakdee, C. (2001). Comparing response of SDF systems to near-fault and far-fault earthquake motions in the context of spectral regions. Earthquake Engineering and Structural Dynamics, 30, 1769–1789.
Xue, Q. (2001). A direct displacement based seismic design procedure of inelastic structures. Engineering Structures, 23(11), 1453–1460.
Jankowski, R. (2004). Non-linear modelling of earthquake induced pounding of buildings’ published on ICTAM, August 15–21, 2004, Warsaw, Poland
Sayani, P. J., Erduran, E., & Ryan, K. L. (2011). Comparative response assessment of minimally compliant low-rise base isolated and conventional steel moment resisting frame buildings. Journal of Structural Engineering. ASCE, 137(10), 1118–1131.
Wankhade, R. L. (2014). Performance based design and estimation of forces for building frames with earthquake loading. In Paper 141, International conference on recent trends and challenges in civil engineering, December 12–14, 2014, MNNIT Allahabad, India.
Wankhade, R. L., & Landage, A. B. (2014). Static analysis for fixed base and base isolated building frame. In Proceedings of national conference on advances in civil and structural engineering (NCACSE-2014).
Wankhade, R. L., & Bajoria, K. M. (2015). Vibration of cantilever piezo laminated beam with extension and shear mode piezo actuators. In Proceeding of SPIE active and passive smart structures and integrated systems, Vol. 9431, p. 943122-1.
Wankhade, R. L., & Landage, A. B. (2016). Performance based analysis and design of building frames with earthquake loading. International Journal of Engineering Research, 5(1), 106–110.
Yesane, P. M., Ghugal, Y. M., & Wankhade, R. L. (2016). Study on soil–structure interaction: A review. Int. J. Eng. Res., 5(3), 737–741.
Wankhade, R. L. (2017). Performance analysis of RC moment resisting frames using different rubber bearing base isolation techniques. In International conference on innovations in concrete for infrastructure challenges Nagpur, India October 6–7.
Bendine, K., & Wankhade, R. L. (2016). Vibration control of FGM piezoelectric plate based on LQR genetic search. Open Journal of Civil Engineering, 6, 1–7.
Wankhade, R. L., & Bajoria, K. M. (2016). Shape control and vibration analysis of piezolaminated plates subjected to electro-mechanical loading, Open. Journal of Civil Engineering, 6, 335–345.
Wankhade, R. L., & Bajoria, K. M. (2017). Numerical optimization of piezolaminated beams under static and dynamic excitations. Journal of Science: Advanced Materials and Devices, 2(2), 255–262.
Bendine, K., & Wankhade, R. L. (2017). Optimal shape control of piezolaminated beams with different boundary condition and loading using genetic algorithm. International Journal of Advanced Structural Engineering, 9(4), 375–384.
Wankhade, R. L., & Bajoria, K. M. (2019). Vibration analysis of piezolaminated plates for sensing and actuating applications under dynamic excitation. International Journal of Structural Stability and Dynamics, 19 (10), 1950121.
Wankhade, R. L., & Niyogi, S. B. (2020). Buckling analysis of symmetric laminated composite plates for various thickness ratios and modes. Innovative Infrastructure Solution, 5, 65. https://doi.org/10.1007/s41062-020-00317-8
Wankhade, R. L., & Bajoria, K. M. (2021). Vibration attenuation and dynamic control of piezolaminated plates for sensing and actuating applications. Archive of Applied Mechanics, 91(1), 411–426.
Wankhade, R. L., Niyogi, S., Gajbhiye, P. (2021). Buckling analysis of laminated composites considering the effect of orthotropic material. IOP Science, Journal of Physics: Conference Series, 1706 (1) 012188.
Kouider, B., & Wankhade, R. L. (2021). Piezoelectric energy harvesting from a curved plate subjected to time-dependent loads using finite elements. IOP Science, Journal of Physics: Conference Series, 1706 (1), 012008.
Jia, H.-Y., Lan, X.-L., Luo, N., Yang, J., Zheng, S.-X., Zhang, C. (2019). Nonlinear pounding analysis of multispan and simply supported beam bridges subjected to strong ground motions. Shock and Vibration, 2019 (8759428) (Hindawi Publication). https://doi.org/10.1155/2019/8759428
Author information
Authors and Affiliations
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2022 Springer Nature Singapore Pte Ltd.
About this paper
Cite this paper
Wankhade, R.L., Sawarkar, A., Chandwani, A., Chavan, S., Malkar, P., Sawarkar, G. (2022). Seismic Fragility of Buildings Subjected to Pounding Effects with Soil–Structure Interaction. In: Gupta, A.K., Shukla, S.K., Azamathulla, H. (eds) Advances in Construction Materials and Sustainable Environment. Lecture Notes in Civil Engineering, vol 196. Springer, Singapore. https://doi.org/10.1007/978-981-16-6557-8_34
Download citation
DOI: https://doi.org/10.1007/978-981-16-6557-8_34
Published:
Publisher Name: Springer, Singapore
Print ISBN: 978-981-16-6556-1
Online ISBN: 978-981-16-6557-8
eBook Packages: EngineeringEngineering (R0)