Abstract
This review paper includes different coating methods with different nanocoating material for enhancing the surface properties. Due to surface properties (wettability, surface contact angle, roughness, porosity, etc.) and thickness of nanocoating, heat transfer rate increases. Nucleate boiling heat transfer and critical heat flux are major factors which decides the heat transfer rate. So if these factors are controlled, then heat transfer rate automatically controlled. Future scope in this field is also presented in this paper. Coating methods, by which non-metal material coated on metal are also listed below.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
N. Shiro, The maximum and minimum values of the heat q transmitted from metal to boiling water under atmospheric pressure. Int. J. Heat Mass Transf. 27(7), 959–970 (1984)
C. Pais, R.L. Webb, Literature survey of pool boiling on enhanced surfaces. ASHRAE Trans. 16(pt 1), 79–89 (1991)
L.H. Chien, R.L. Webb, A nucleate boiling model for structured enhanced surfaces. Int. J. Heat Mass Transf. 41(14), 2183–2195 (1998)
Milton, Heat exchange system. Foreign Aff. 91(5), 1689–1699 (1968)
J.Y. Chang, S.M. You, Boiling heat transfer phenomena from micro-porous and porous surfaces in saturated FC-72. Int. J. Heat Mass Transf. 40(18), 4437–4447 (1997)
T.W.S.S.M. You, Enhance Boiling Heat Transfer with application to cooling of electonic equipment.Pdf. (1992)
J.Y. Chang, S.M. You, Enhanced boiling heat transfer from micro-porous surfaces: Effects of a coating composition and method. Int. J. Heat Mass Transf. 40(18), 4449–4460 (1997)
R.W. Bowring, Physical Model, Based on Bubble Detachment, and Calculation of Steam Yoidage in the Sub cooled Region of a Heated Channel, pp. 135–142 (1962)
S.G. Liter, M. Kaviany, Pool-boiling CHF enhancement by modulated porous-layer coating: Theory and experiment. Int. J. Heat Mass Transf. 44(22), 4287–4311 (2001)
Y. Haramura, Y. Katto, A new hydrodynamic model of critical heat flux, applicable widely to both pool and forced convection boiling on submerged bodies in saturated liquids. Int. J. Heat Mass Transf. 26(3), 389–399 (1983)
S.G. Kandlikar, A theoretical model to predict pool boiling CHF incorporating effects of contact angle and orientation. J. Heat Transf. 123(6), 1071–1079 (2001)
S.J. Kim, I.C. Bang, J. Buongiorno, L.W. Hu, Surface wettability change during pool boiling of nanofluids and its effect on critical heat flux. Int. J. Heat Mass Transf. 50(19–20), 4105–4116 (2007)
S.D. Park et al., Effects of nanofluids containing graphene/graphene-oxide nanosheets on critical heat flux. Appl. Phys. Lett. 97(2) (2010)
J.W. Westwater, Boiling Heat Transf. 101(5), 370–377 (1959)
S.M. You, J.H. Kim, K.H. Kim, Effect of nanoparticles on critical heat flux of water in pool boiling heat transfer. Appl. Phys. Lett. 83(16), 3374–3376 (2003)
N. Zuber, Hydrodynamic Aspects Of Boiling Heat Transfer (Thesis) (1959)
J.A. Eastman, S.U.S. Choi, S. Li, W. Yu, L.J. Thompson, Anomalously increased effective thermal conductivities of ethylene glycol-based nanofluids containing copper nanoparticles. Appl. Phys. Lett. 78(6), 718–720 (2001)
H. Kim, J. Kim, M.H. Kim, Effect of nanoparticles on CHF enhancement in pool boiling of nano-fluids. Int. J. Heat Mass Transf. 49(25–26), 5070–5074 (2006)
P. Vassallo, R. Kumar, S. D’Amico, Pool boiling heat transfer experiments in silica-water nano-fluids. Int. J. Heat Mass Transf. 47(2), 407–411 (2004)
S.J. Kim, I.C. Bang, J. Buongiorno, L.W. Hu, Effects of nanoparticle deposition on surface wettability influencing boiling heat transfer in nanofluids. Appl. Phys. Lett. 89(15) (2006)
I.C. Bang, S. Heung Chang, Boiling heat transfer performance and phenomena of Al2O3-water nano-fluids from a plain surface in a pool. Int. J. Heat Mass Transf. 48(12), 2407–2419 (2005)
H.D. Kim, J. Kim, M.H. Kim, Experimental studies on CHF characteristics of nano-fluids at pool boiling. Int. J. Multiph. Flow 33(7), 691–706 (2007)
H. Kim, M. Kim, Experimental study of the characteristics and mechanism of pool boiling CHF enhancement using nanofluids. Heat Mass Transf. Und Stoffuebertragung 45(7), 991–998 (2009)
M. Chopkar, A.K. Das, I. Manna, P.K. Das, Pool boiling heat transfer characteristics of ZrO2-water nanofluids from a flat surface in a pool. Heat Mass Transf. Und Stoffuebertragung 44(8), 999–1004 (2008)
E. Forrest, E. Williamson, J. Buongiorno, L.W. Hu, M. Rubner, R. Cohen, Augmentation of nucleate boiling heat transfer and critical heat flux using nanoparticle thin-film coatings. Int. J. Heat Mass Transf. 53(1–3), 58–67 (2010)
D. Wen, M. Corr, X. Hu, G. Lin, Boiling heat transfer of nanofluids: The effect of heating surface modification. Int. J. Therm. Sci. 50(4), 480–485 (2011)
D. Wen, Influence of nanoparticles on boiling heat transfer. Appl. Therm. Eng. 41, 2–9 (2012)
M. Kole, T.K. Dey, Investigations on the pool boiling heat transfer and critical heat flux of ZnO-ethylene glycol nanofluids. Appl. Therm. Eng. 37, 112–119 (2012)
J.Y. Jung, E.S. Kim, Y.T. Kang, Stabilizer effect on CHF and boiling heat transfer coefficient of alumina/water nanofluids. Int. J. Heat Mass Transf. 55(7–8), 1941–1946 (2012)
J. Tehver, H. Sui, V. Temkina, Heat transfer and hysteresis phenomena in boiling on porous plasma-sprayed surface. Exp. Therm. Fluid Sci. 5(6), 714–727 (1992)
G.S. Hwang, M. Kaviany, Critical heat flux in thin, uniform particle coatings. Int. J. Heat Mass Transf. 49(5–6), 844–849 (2006)
C.H. Li et al., Comparison study of liquid replenishing impacts on critical heat flux and heat transfer coefficient of nucleate pool boiling on multiscale modulated porous structures. Int. J. Heat Mass Transf. 54(15–16), 3146–3155 (2011)
Y. Takata et al., Effect of surface wettability on boiling and evaporation. Energy 30(2–4), 209–220 (2005)
S. Vemuri, K.J. Kim, Pool boiling of saturated FC-72 on nano-porous surface. Int. Commun. Heat Mass Transf. 32(1–2), 27–31 (2005)
S.S. Hsieh, C.J. Weng, Nucleate pool boiling from coated surfaces in saturated R-134a and R-407c. Int. J. Heat Mass Transf. 40(3), 519–532 (1997)
J.H. Kim, K.N. Rainey, S.M. You, J.Y. Pak, Mechanism of nucleate boiling heat transfer enhancement from microporous surfaces in saturated FC-72. J. Heat Transfer 124(3), 500–506 (2002)
C. Li, Z. Wang, P.I. Wang, Y. Peles, N. Koratkar, G.P. Peterson, Nanostructured copper interfaces for enhanced boiling. Small 4(8), 1084–1088 (2008)
T.J. Hendricks, S. Krishnan, C. Choi, C. Chang, B. Paul, Enhancement of pool-boiling heat transfer using nanostructured surfaces on aluminum and copper. Int. J. Heat Mass Transf. 53(15–16), 3357–3365 (2010)
B. Feng, K. Weaver, G.P. Peterson, Enhancement of critical heat flux in pool boiling using atomic layer deposition of alumina. Appl. Phys. Lett. 100(5), 98–101 (2012)
Y. Wen-Jei, H. Takizawa, D.L. Vrable, Augmented boiling on copper-graphite composite surface. Int. J. Heat Mass Transf. 34(11), 2751–2758 (1991)
H.S. Liang, W.J. Yang, Nucleate pool boiling heat transfer in a highly wetting liquid on micro-graphite-fiber composite surfaces. Int. J. Heat Mass Transf. 41(13), 1993–2001 (1998)
M.S. El-genk, J.L. Parker, Pool Boiling in Saturated and Subcooled-7100 Dielectric Fluid from a Porous Graphite Surface, pp. 655–662 (2004)
J.L. Parker, M.S. El-Genk, Effect of surface orientation on nucleate boiling of FC-72 on porous graphite. J. Heat Transf. 128(11), 1159–1175 (2006)
H.S. Ahn, N. Sinha, M. Zhang, D. Banerjee, S. Fang, R.H. Baughman, Pool boiling experiments on multiwalled carbon nanotube (MWCNT) forests. J. Heat Transf. 128(12), 1335–1342 (2006)
X. Dai et al., Enhanced nucleate boiling on horizontal hydrophobic-hydrophilic carbon nanotube coatings. Appl. Phys. Lett. 102(16) (2013)
A.R. Betz, J. Xu, H. Qiu, D. Attinger, Do surfaces with mixed hydrophilic and hydrophobic areas enhance pool boiling? Appl. Phys. Lett. 97(14), 1–4 (2010)
A.R. Betz, J.R. Jenkins, C.J. Kim, D. Attinger, Significant boiling enhancement with surfaces combining superhydrophilic and superhydrophobic patterns, in Proceedings of IEEE International Conference on Micro Electro Mechanical Systems, pp. 1193–1196 (2011)
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2021 The Editor(s) (if applicable) and The Author(s), under exclusive license to Springer Nature Singapore Pte Ltd.
About this paper
Cite this paper
Das, S.P., Singh, R., Misra, R.D. (2021). Review on Pool Boiling Heat Transfer Enhancement by Surface Fabrication Using Various Surface Coating Methods. In: Pandey, K., Misra, R., Patowari, P., Dixit, U. (eds) Recent Advances in Mechanical Engineering. Lecture Notes in Mechanical Engineering. Springer, Singapore. https://doi.org/10.1007/978-981-15-7711-6_17
Download citation
DOI: https://doi.org/10.1007/978-981-15-7711-6_17
Published:
Publisher Name: Springer, Singapore
Print ISBN: 978-981-15-7710-9
Online ISBN: 978-981-15-7711-6
eBook Packages: EngineeringEngineering (R0)