Abstract
Recent high ambient concentration of particulate matter (PM), such as air pollutants, has its multimodal effects on the environment and human health especially for the least developing countries because of the high cost associated with monitoring it. The aim of this study is to introduce a low-cost air quality monitoring (AQM) sensor to assess human exposure to support the health impact assessment and environmental policy formulation. A low-cost AQM sensor using light scattering technology, AirVisual (AV) pro was used in four sites in Dhaka city of Bangladesh in a period of five and a half months spreading from Feb 2019 to Aug 2019. Validation of the equipment was done comparing it with two equivalent equipment-HIM-6000 portable air quality monitor and BAM-1020 continuous particulate monitor. The correlations between the AV pro and BAM-1020 were found fairly strong (R2 = 0.77) at the US Embassy in Dhaka. The correlations between the AV pro and HIM-6000 were found also very strong (R2 = 0.91) at Mirpur Cantonment. This study defines the four heterogeneous environments in Mirpur–12, Mirpur Cantonment, Baridhara, and Darus Salam to conduct extensive statistical analysis of spatial, seasonal, diurnal, and temporal variations of air pollution. The results showed that Mirpur–12 to be the most polluted zone (mean PM2.5 = 122.62 µg/m3, mean PM10 = 186.84 µg/m3) after application of low-cost AQM sensor. It also revealed changes in PM concentrations in terms of time, meteorological condition, and place. Maximum PM concentration occurs when the traffic volume is high in the morning and evening and reduces from pre-monsoon to monsoon. This paper also highlights the utility and vulnerability of a low-cost monitoring sensor like AV pro to measure the PM concentration. With the above analysis, further studies are needed to prove the relationship between health impact assessment and human exposure to PM2.5 and PM10 concentration via low-cost sensors.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Similar content being viewed by others
References
Dhammapala R (2019) Analysis of fine particle pollution data measured at 29 US diplomatic posts worldwide. Atmos Environ 213:367–376. https://doi.org/10.1016/j.atmosenv.2019.05.070
Han I, Symanski E, Stock TH (2016) Feasibility of using low-cost portable particle monitors for measurement of fine and coarse particulate matter in urban ambient air. J Air Waste Manag Assoc 67(3):330–340. https://doi.org/10.1080/10962247.2016.1241195
Hasan MR, Hossain MA, Sarjana U, Hasan MR (2016) Status of air quality and survey of particle matter pollution in Pabna city, Bangladesh. Am J Eng Res 5(11):1
IQAir Air visual. (n.d.). Retrieved November 6, 2019, from https://www.airvisual.com/air-quality-monitor
Khan R, Konishi S, Ng CFS, Umezaki M, Kabir AF, Tasmin S, Watanabe C (2019) Association between short-term exposure to fine particulate matter and daily emergency room visits at a cardiovascular hospital in Dhaka, Bangladesh. Sci Total Environ 646:1030–1036. https://doi.org/10.1016/j.scitotenv.2018.07.288
Ngo NS, Asseko SVJ, Ebanega MO, Alloo SMA, Hystad P (2019) The relationship among PM2.5, traffic emissions, and socioeconomic status: Evidence from Gabon using low-cost, portable air quality monitors. Transp Res Part D Transp Environ 68:1–2. https://doi.org/10.1016/j.trd.2018.01.029
Northcross AL, Edwards RJ, Johnson MA, Wang Z-M, Zhu K, Allen T, Smith K R. (2013) A low-cost particle counter as a realtime fine-particle mass monitor. Environ Sci Processes Impacts 15(2):433–439. https://doi.org/10.1039/c2em30568b
Occhipinti L, Oluwasanya P (2017) Particulate matter monitoring: past, present and future. Int J Earth Environ Sci 2(2). https://doi.org/10.15344/2456-351x/2017/144
Rai AC, Kumar P (2017) Summary of air quality sensors and recommendations for application. Summary of air quality sensors and recommendations for application. iSCAPE, pp 1–10
Rana MM, Sulaiman N, Sivertsen B, Khan MF, Nasreen S (2016) Trends in atmospheric particulate matter in Dhaka, Bangladesh, and the vicinity. Environ Sci Pollut Res 23(17):17393–17403. https://doi.org/10.1007/s11356-016-6950-4
Steinle S, Reis S, Sabel CE, Semple S, Twigg MM, Braban CF, Leeson, S.R., Heal MR, Harrison D, Lin C, Wu H (2014) Personal exposure monitoring of PM2.5 in indoor and outdoor microenvironments. Sci Total Environ 1–2. https://doi.org/10.1016/j_scitotenv.2014.12.003
Tunno BJ, Shields KN, Lioy P, Chu N, Kadane JB, Parmanto B, Zora J, Davidson C, Holguin F, Clougherty JE (2012) Understanding intra-neighborhood patterns in PM2.5 and PM10 using mobile monitoring in Braddock, PA. Environ Health 11(1):1–3. https://doi.org/10.1186/1476-069x-11-76
Xu G, Jiao L, Zhao S, Cheng J (2016) Spatial and temporal variability of PM2.5 concentration in China. Wuhan Univ J Natural Sci 21(4):358–368. https://doi.org/10.1007/s11859-016-1182-5
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2021 Springer Nature Singapore Pte Ltd.
About this paper
Cite this paper
Noman Munshi, M., Nihab Ahsan, S.M., Shafinur Rahman, M., Tauhid Ur Rahman, M. (2021). Application of Low-Cost Air Quality Monitoring Sensor to Assess the Exposure of Ambient Air Pollution Due to PM2.5 and PM10. In: Kumar, S., Kalamdhad, A., Ghangrekar, M. (eds) Sustainability in Environmental Engineering and Science. Lecture Notes in Civil Engineering, vol 93. Springer, Singapore. https://doi.org/10.1007/978-981-15-6887-9_16
Download citation
DOI: https://doi.org/10.1007/978-981-15-6887-9_16
Published:
Publisher Name: Springer, Singapore
Print ISBN: 978-981-15-6886-2
Online ISBN: 978-981-15-6887-9
eBook Packages: EngineeringEngineering (R0)