Abstract
Underground cross-linking profile control and water shutoff and deep fluid flow to chemical agent system are usually composed of main agent, cross-linking agent and additives. The cost of cross-linking agent and additives generally accounts for 30–50% of the total cost of the system. Many inorganic salt ions are widely used as cross-linking agent or additives. In this paper, using Ca2+ and Mg2+ scale forming ion source in CaCl2 water type oilfield high salinity formation water (as water injection) as crosslinking agent, cross-linking of original inorganic microgel is carried out to reduce the cost of steering agent. The formation of nano microscale inorganic microgel with density similar to that of environmental water source can be formed by cross-linking of the steering agent with scale forming ions in formation water. The microgel can be dispersed or suspended in water, and gradually adsorbed on the rock skeleton of the dominant channel such as hole or crack to form a micro gel coating in order to narrow the flow dominant channel and form resistance to flow. The passage of plugging does not die, achieving the purpose of adjusting the dominant channel, expanding the volume and improving the efficiency of water flooding. At the same time, the particle size of the micro gel can prevent it from entering the low permeability matrix to contaminate the oil layer. The diversion agent has the characteristics of rapid dissolution, temperature resistance, salt resistance, environmental protection, long-term effectiveness and no construction risk. Field tests of deep profile control and flooding have been carried out in reservoirs with different temperature and salinity at home and abroad. After profile control diversion in test blocks or well groups, the effect of improving water flooding is good. The average increase of water injection pressure is 2–3 MPa, and the effective rate of increasing oil production and precipitation in oil wells is more than 80%, and the validity period is less than one year up.
Copyright 2019, IFEDC Organizing Committee.
This paper was prepared for presentation at the 2019 International Field Exploration and Development Conference in Xi’an, China, 16–18 October, 2019.
This paper was selected for presentation by the IFEDC Committee following review of information contained in an abstract submitted by the author(s). Contents of the paper, as presented, have not been reviewed by the IFEDC Technical Team and are subject to correction by the author(s). The material does not necessarily reflect any position of the IFEDC Technical Committee its members. Papers presented at the Conference are subject to publication review by Professional Team of IFEDC Technical Committee. Electronic reproduction, distribution, or storage of any part of this paper for commercial purposes without the written consent of IFEDC Organizing Committee is prohibited. Permission to reproduce in print is restricted to an abstract of not more than 300 words; illustrations may not be copied. The abstract must contain conspicuous acknowledgment of IFEDC. Contact email: paper@ifedc.org.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
Yu, Q., Yu, H., Wang, Y.: Research progress of deep profile control technology in domestic oilfields. Fault Block Oil Gas Fields 16(4), 68–71 (2009)
Liu, Y., Xiong, C., Luo, J., et al.: Study on deep fluid flow steering technology in high water cut oilfields. Oilfield Chem. 23(3), 248–251 (2006)
Lu, X., Wang, S., Wang, R., et al.: Study on adaptability of deep fluid flow diversion agent to reservoir: taking Daqing Lamadian Oilfield as an example. Pet. Explor. Dev. 38(5), 576–582 (2011)
Wu, Y.F., Tang, T.J., Bai, B.J., et al.: An experimental study of interaction between surfactant and particle hydrogels. Polymer 52(2), 452–460 (2011)
Zhang, H., Challar, R.S., Bai, B.J., et al.: Using screening test results to predict the effective viscosity of swollen superabsorbent polymer particles extrusion through an open fracture. Ind. Eng. Chem. Res. 49(23), 12284–12293 (2010)
Stavland, A., Jonsbrten, H.C., Vikane, O.: In-depth water diversion using sodium silicate on snorre-factors control in-depth placement. SPE 143836-MS (2011)
Vasquez, J., Miranda, C.: Profile modification in injection wells through relative permeability modifiers: laboratory validation and reservoir simulation. SPE 135107-MS (2010)
Tang, X., Yang, L., et al.: New inorganic gel coating deep fluid diversion agent, 2012.2. Pet. Explor. Dev. 39(1), 76–80 (2012)
Tang, X.F., Liu, Y.Z., Qin, H., et al.: A new method of in-depth profile modification for high-temperature and high-salinity reservoir. SPE 88468-MS (2004)
Tang, X., Liu, Y., et al.: Laboratory study of inorganic coating profile control agent suitable for high temperature and high salinity formation. Pet. Explor. Dev. 31(6), 92–94 (2004)
Acknowledgments
The project is supported by China’s major national project, “High-efficiency deep fluid flow steering and profile control and fine layer injection-production technology” (project number 2011vx05010-003).
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2020 Springer Nature Singapore Pte Ltd.
About this paper
Cite this paper
Shao, Lm., Fang, Pl., Wei, Fl., Dai, Ml., Li, Wt. (2020). New Technology for Improving Water Flooding Efficiency by Adjusting Advantage Channels. In: Lin, J. (eds) Proceedings of the International Field Exploration and Development Conference 2019. IFEDC 2019. Springer Series in Geomechanics and Geoengineering. Springer, Singapore. https://doi.org/10.1007/978-981-15-2485-1_289
Download citation
DOI: https://doi.org/10.1007/978-981-15-2485-1_289
Published:
Publisher Name: Springer, Singapore
Print ISBN: 978-981-15-2484-4
Online ISBN: 978-981-15-2485-1
eBook Packages: EngineeringEngineering (R0)