Abstract
The present study involves fabrication and steady state experimental testing of double-pipe heat exchanger (DPHE) with turbulator. A helical wire has been inserted inside the inner tube of DPHE for creating extra turbulence to the flow through it. The effect of turbulator on heat transfer performance is studied. The working fluid used in the inner pipe and outer pipe is hot water and cold water, respectively. The test runs are performed at mass flow rates of hot and cold water ranging between 0.01 and 0.09 kg/s and between 0.01 and 0.04 kg/s, respectively. And the test is carried out in two separate modes, without using turbulator and with turbulator. Correlations and equations for flow properties and heat transfer characteristics were collected from various literature works involving flow through DPHE. The Nusselt number calculated from experiment values of the heat exchanger without turbulator is validated with the Dittus-Boelters equation for the pipe flow. A significant increase in the overall heat transfer coefficient is observed by using the turbulator in the inner pipe of the heat exchanger. Obviously, the increase in the performance comes with the cost of extra pressure drop. The reasons behind the enhancement of overall heat transfer coefficient and pressure drop of the DPHE using helical wire as turbulator were discussed. Dimensionless exergy analysis is carried out to study the changes by using the turbulator. In conclusion, for enhancing heat transfer performance, the helical wire turbulator can be employed in the heat exchanger.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
Panahi D, Zamzamian K (2016) Heat transfer enhancement of shell-and-coiled tube heat exchanger utilizing helical wire turbulator. Appl Therm Eng 2016(12):128
Yildiz C, Bicer Y, Pehlivan D (1997) Heat transfer and pressure drop in a heat exchanger with a helical pipe containing inside springs. Energy Convers Manag 38(6):619–624
Mahdi QS, Fattah SA, Jasim OM (2014) Experimental and numerical investigation to enhance the performance of helical coiled tube heat exchanger by Using turbulators. J Eng Devel 18(6). ISSN 1813-7822
Jung YN, Wen CH, Chang A (2015) Experimental investigation on heat transfer and fluid friction correlations for circular tubes with coiled-wire inserts. Int Commun Heat Mass Transfer 65:8–14
Akpinar EK, Bicer Y (2005) Investigation of heat transfer and exergy loss in a concentric double pipe exchanger equipped with swirl generators. Int J Therm Sci 44:598–607
Taborek J (1997) Double-pipe and multi tube heat exchangers with plain and longitudinal finned tubes. Heat Transfer Eng 18:34–45
Syed K, Ishaq M, Iqbal Z, Hassan A (2015) Numerical study of an innovative design of a finned double-pipe heat exchanger with variable fin-tip thickness. Energy Convers Manage 98:69–80
Kahalerras H, Targui N (2008) Numerical analysis of heat transfer enhancement in a double pipe heat exchanger with porous fins. Int J Numer Meth Heat Fluid Flow 18:593–617
Khorasani S, Dadvand A (2017) Effect of air bubble injection on the performance of a horizontal shell and coiled tube heat exchanger: an experimental study. Appl Therm Eng (8):676. ISSN:1359-4311
Dizaji HS, Jafarmadar S, Abbasalizadeh M, Khorasani S (2015) Experiments on air bubbles injection into a vertical shell and coiled tube heat exchanger; exergy and NTU analysis. Energ Conv Mang 103:973–980
Durmus A (2002) Heat transfer and energy loss in a concentric heat exchanger with snail entrance. Int Commun Heat Mass Transfer 29:303–312
Akpinar EK (2006) Evaluation of heat transfer and exergy loss in a concentric double pipe exchanger equipped with helical wires. Energy Convers Manage 47:34733486
Naphon P (2006) Effect of coil-wire insert on heat transfer enhancement and pressure drop of the horizontal concentric tubes. Int Commun Heat Mass Transfer 33:753763
Choudhari SS, Taji S (2013) Experimental studies on effect of coil wire insert on heat transfer enhancement and friction factor of double pipe heat exchanger. Int J Comput Eng Res 3:3239
Zohir A, Habib M, Nemitallah M (2015) Heat transfer characteristics in a double pipe heat exchanger equipped with coiled circular wires. Exp Heat Transfer 28:531545
Omidi M, Farhadi M, Jafari M A comprehensive review on double pipe heat exchangers. Appl Therm Eng
Dizaji HS, Jafarmadar S (2014) Heat transfer enhancement due to air bubble injection into a horizontal double pipe heat exchanger. Int J Automot Eng 4:902–910
Saeedinia M, Akhavan-Behabadi MA, Nasr M (2012) Experimental study on heat transfer and pressure drop of nanofluid flow in a horizontal coiled wire inserted tube under constant heat flux. Exp Thermal Fluid Sci 36:158–168
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2020 Springer Nature Singapore Pte Ltd.
About this paper
Cite this paper
Jithin, K.V., Pradeep, A. (2020). Heat Transfer Enhancement of Concentric Double-Pipe Heat Exchanger Utilizing Helical Wire Turbulator. In: Suryan, A., Doh, D., Yaga, M., Zhang, G. (eds) Recent Asian Research on Thermal and Fluid Sciences. Lecture Notes in Mechanical Engineering. Springer, Singapore. https://doi.org/10.1007/978-981-15-1892-8_26
Download citation
DOI: https://doi.org/10.1007/978-981-15-1892-8_26
Published:
Publisher Name: Springer, Singapore
Print ISBN: 978-981-15-1891-1
Online ISBN: 978-981-15-1892-8
eBook Packages: EngineeringEngineering (R0)