Abstract
A pilot-scale multi-layer system was developed for the adsorption of SO2/NOx/Hg from flue gas (real flue gases of an heating boiler house) at various operating conditions, including operating temperature and activated carbon materials. Excellent SO2/NOx/Hg removal efficiency was achieved with the multi- layer design with carbons pellets. The SO2 removal efficiency achieved with the first layer adsorption bed clearly decreased as the operating temperature was increased due to the decrease of physisorption performance. The NOx removal efficiency measured at the second layer adsorption bed was very higher when the particle carbon impregnated with NH3. The higher amounts of Hg absorbed by cotton-seed-skin activated carbon (CSAC) were mainly contributed by chlorinated congeners content. The simultaneously removal of SO2/NOx/Hg was optimization characterized with different carbon layer functions. Overall, The alkali function group and chloride content in CSAC impelled not only the outstanding physisorption but also better chemisorptions. The system for simultaneously removal of multi-pollutant-gas with biomass activated carbon pellets in multi-layer reactor was achieved and the removal results indicated was strongly depended on the activated carbon material and operating temperature.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Similar content being viewed by others
References
Iannacone MM, Castle JW, Rodgers Jr JH. Characterization of flue gas desulfurization particulates in equalization basins. Fuel. 2009;88:1580–7.
Alam HG, Moghaddam AZ, Omidkhah MR. The influence of process parameters on desulfurization of Mezino coal by HNO3/HCl leaching. Fuel Process Technol. 2009;90:1–7.
Chen DJZ, MacQuarrie KTB. Numerical simulation of organic carbon, nitrate, and nitrogen isotope behavior during denitrification in a riparian zone. J Hydrol. 2004;293:235–54.
Sheng-Jie Y, Yung-Pin T, Ru-Yi H. Effect of heavy metals on nitrification performance in different activated sludge processes. J Hazard Mater. 2009;165:987–94.
Schneider RM, Cavalin CF, Barros MASD, Tavares CRG. Adsorption of chromium ions in activated carbon. Chem Eng J. 2007;132:355–62.
Choi HK, Lee SH, Kim SS. The effect of activated carbon injection rate on the removal of elemental mercury in a particulate collector with fabric filters. Fuel Process Technol. 2009;90:107–12.
Li K, Ling L, Lu C, Qiao W, Liu Z, Liu L, Mochida I. Catalytic removal of SO2 over ammonia-activated carbon fibers. Carbon. 2001;39:1803–8.
Chandrasekara Pillai K, Chung SJ. Experimental aspects of associated NOx and SO2 removal from flue-gas mixture in an integrated wet scrubber-electrochemical cell system. Chemosphere. 2009;76:657–64.
Zhu JL, Wang YH, Zhang JC, Ma RY. Experimental investigation of adsorption of NO and SO2 on modified activated carbon sorbent from flue gases. Energy Convers Manag. 2005;46:2173–84.
Pavlish JH, Sondreal EA, Mann MD, Olson ES, Galbreath KC, Laudal DL, Benson SA. Status review of mercury control options for coal-fired power plants. Fuel Process Technol. 2003;82:89–165.
Izquierdo MT, Rubio B, Mayoral C, Andrés JM. Low cost coal-based carbons for associated SO2 and NO removal from exhaust gas. Fuel. 2003;82:147–51.
Hung PC, Lo WC, Chi KH, Chang SH, Chang MB. Reduction of dioxin emission by a multi-layer reactor with bead-shaped activated carbon in simulated gas stream and real flue gas of a sinter plant. Chemosphere. 2011;82:72–7.
Leea SJ, Seoa YC, Jurng J, et al. Removal of gas phase elemental mercury by iodine and chlorine impregnated activated carbons. Atmos Environ. 2004;38:4887–93.
Pudasainee D, Lee SJ, Lee S-H, Kim J-H, Jang H-N, Cho S-J, Seo Y-C. Effect of selective catalytic reactor on oxidation and enhanced removal of mercury in coal-fired power plants. Fuel. 2010;89:804–9.
Changxing Hu, Zhou J, He S, Luo Z, Cen K. Effect of chemical activation of an activated carbon using zinc chloride on elemental mercury adsorption. Fuel Process Technol. 2009;90:812–7.
Ma X, Zhang M. Total mass transfer coefficient and dynamics research of H2S adsorption on modified activated carbon. Chem Eng J. 1993;21:60–5.
Graydon JW, Zhang X, Kirk DW, Jia CQ. Sorption and stability of mercury on activated carbon for emission control. J Hazard Mater. 2009;168:978–82.
Zhuang Y, Thompson JS. Impact of calcium chloride addition on mercury transformations and control in coal flue gas. Fuel. 2007;86:2351–9.
Hancai Z, Feng J, Jia G. Removal of elemental mercury from coal combustion flue gas by chloride- impregnated activated carbon. Fuel. 2004;83:143–6.
Acknowledgements
This author was grateful for the financial support of the Special Funds of State Key Projects for Fundamental Research of China (Grant NO. 2006CB200305-5); by Natural Science Foundation of Shandong Province (NO. ZR2010EM004); grateful for Shandong Province Colleges and Universities Outstanding Young Teachers in Visiting Scholars Project.
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2013 Springer-Verlag Berlin Heidelberg & Tsinghua University Press
About this paper
Cite this paper
Wang, C., Yuan, W., Qi, H. (2013). Study on the Associated Removal of Pollutants from Coal-Firing Flue Gas Using Biomass Activated Carbon Pellets. In: Qi, H., Zhao, B. (eds) Cleaner Combustion and Sustainable World. ISCC 2011. Springer, Berlin, Heidelberg. https://doi.org/10.1007/978-3-642-30445-3_61
Download citation
DOI: https://doi.org/10.1007/978-3-642-30445-3_61
Published:
Publisher Name: Springer, Berlin, Heidelberg
Print ISBN: 978-3-642-30444-6
Online ISBN: 978-3-642-30445-3
eBook Packages: EnergyEnergy (R0)