Abstract
In recent years, reducing the cost of energy production and transmitting electricity in remote areas of the distribution network have attracted many researchers’ attention. One of the methods to fulfill these objectives is using a gas micro-turbine cycle. In this paper, a two-stage micro-turbine with an intercooler was used to produce electricity and heat simultaneously. In this system, the impacts of the effective input parameters, such as compressor pressure ratio, bypass ratio, and re-cooperator yield on cycle performance were studied given that the values obtained from cycle modeling were not continuous, and using GMDH-type neural system (as one of the most widely used neural networks with high potential to model complex data), the desired objective functions were estimated and then simultaneous optimization of the objective functions were implemented. It was shown that the maximum electrical exergy efficiency is 58 % and maximum thermal exergy efficiency is 18 %.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
AmirAlipour M, Khanmohammadi S (2014) Multi-objective exergy economic optimization of a 300kw micro-turbine using GMDH type neural network and evolutionary algorithm. A paper presented at international conferences of clean energy-Istanbul-Turkey, 8–12 May 2014
Ehyaei MA, Bahadori MN (2007) Selection of micro turbines to meet electrical and thermal energy needs of residential building in Iran. Int J Energy Build 39:1227–1234
Hao X, Zhang G, Chen Y, Zhou J (2006) Thermodynamic model and numerical simulation of single-shaft micro turbine performances. J HVAC Technol Energy Effi IV-10-1:1–7 (2006)
Jurado F (2005) Non-linear modeling of micro-turbines using NARX structures on the distribution feeder. Int Energy Convers Manage 46:385–401
Khanmohammadi S, Azimian AR, Khanmohammadi S (2013) Exergy and exergo-economic evaluation of Isfahan steam power plant. Int J Exergy 12(2):249–272
Khanmohammadi S, Atashkari K, Kouhikamali R (2015) Exergoeconomic multi-objective optimization of an externally fired gas turbine integrated with a biomass gasifier. Appl Therm Eng 91:848–859
Khanmohammadi S, Atashkari K, Kouhikamali R (2016) Modeling and assessment of a biomass gasification integrated system for multigeneration purpose. Int J Chem Eng 2016:11
Labinov SD, Zaltash A, Rizy DT, Fairchild PD, Devault RC, Vineyard EA (2002) Predictive Algorithms for microturbine performance for BCHP systems. J ASHRAE Trans 108:670–681
Nariman-Zadeh N, Atashkari K, Jamali A, Pilechi A (2005) Inverse modeling of multi objective Thermodynamically optimized turbojet engines using GMDH-type neural networks and evolutionary algorithms. Eng Optim 37:437
Sadeghi S, Ghofrani MH, Khaledi AF (2005) Analysis of micro-turbine cycle with heat recovery by energy and exergy method. PSC
Toffolo A, Benini E (2003) Genetic diversity as objective in multi-objective evolutionary algorithms. Evol Comput 11(2):151–167
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2016 Springer International Publishing Switzerland
About this chapter
Cite this chapter
AmirAlipour, M., Khanmohammadi, S., Atashkari, K., KouhiKamali, R. (2016). Multi-objective Optimization of a Two-Stage Micro-turbine for Combined Heat and Power Production. In: Karakoc, T., Ozerdem, M., Sogut, M., Colpan, C., Altuntas, O., Açıkkalp, E. (eds) Sustainable Aviation. Springer, Cham. https://doi.org/10.1007/978-3-319-34181-1_13
Download citation
DOI: https://doi.org/10.1007/978-3-319-34181-1_13
Published:
Publisher Name: Springer, Cham
Print ISBN: 978-3-319-34179-8
Online ISBN: 978-3-319-34181-1
eBook Packages: EnergyEnergy (R0)