Abstract
This study investigates the influence of waste tire rubber on fresh and hardened properties of self-compacting concrete (SCC). Seven different SCC mixtures were designed: the reference mixture was made with natural aggregate and six SCC mixtures made with 5%, 10%, 15%, 20%, 25% and 30% replacement level of total aggregate volume. Natural fine aggregates were replaced by recycled waste tire rubber with maximum grain size of 4 mm. Flowability, viscosity, passing ability and porosity of fresh SCC mixtures were determined by means of slump flow, L-box, J-ring and air content – pressure method. Mechanical properties of hardened SCC were evaluated by means of compressive strength, flexural strength and static modulus of elasticity, while durability was expressed with two SCC hardened state properties, water permeability and gas permeability. The test results reveal that waste tire rubber affects the fresh and hardened SCC properties. With a higher amount of waste tire rubber in concrete mixtures, degradation in SCC fresh and hardened properties was observed. However, the addition of waste tire rubber up to 10% of total aggregate volume shows that it is possible to implement recycled rubber in SCC and to successfully satisfy both fresh and hardened SCC properties.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
References
ETRMA (2015) End-of-life Tyre Report 2015
AbdelAleem BH, Hassan AAA (2018) Development of self-consolidating rubberized concrete incorporating silica fume. Constr Build Mater 161:389–397
Aslani F, Ma G, Yim Wan DL, Tran Le VX (2018) Experimental investigation into rubber granules and their effects on the fresh and hardened properties of self-compacting concrete. J Clean Prod 172:1835–1847
Najim KB, Hall MR (2012) Mechanical and dynamic properties of self-compacting crumb rubber modified concrete. Constr Build Mater 27(1):521–530
Bušić R, Miličević I, Šipoš T, Strukar K (2018) Recycled rubber as an aggregate replacement in self-compacting concrete—literature overview. Materials (Basel) 11(9):1729
Bjegović D, Baričević A, Serdar M (2011) Durability properties of concrete with recycled waste tyres. In: 12th international conference on durability of building materials and components Porto, Port., pp 1659–1667
Gupta T, Chaudhary S, Sharma RK (2016) Mechanical and durability properties of waste rubber fiber concrete with and without silica fume. J Clean Prod 112:702–711
Thomas BS, Gupta RC, Kalla P, Cseteneyi L (2014) Strength, abrasion and permeation characteristics of cement concrete containing discarded rubber fine aggregates. Constr Build Mater 59:204–212
EFNARC (2005) The European Guidelines for Self-Compacting Concrete
HRN EN 197-1:2012 Cement - Part 1: Composition, specifications and conformity criteria for common cements
HRN EN 13263-1:2009: Silica fume for concrete - Part 1: Definitions, requirements and conformity criteria
HRN EN 1008:2002 Mixing water for concrete – Specification for sampling, testing and assessing the suitability of water, including water recovered from processes in the concrete industry, as mixing water for concrete
ASTM (2011) C188-16, Standard Test Method for Density of Hydraulic Cement, vol 95, no Reapproved 2003, pp 37–39
HRN EN 933-1:2012: Tests for geometrical properties of aggregates – Part 1: Determination of particle size distribution – Sieving method
HRN EN 12350-8:2010: Testing fresh concrete - Part 8: Self-compacting concrete - Slump flow test
HRN EN 12350-10:2010: Testing fresh concrete - Part 10: Self-compacting concrete - L box test
HRN EN 12350-12:2010: Testing fresh concrete - Part 12: Self-compacting concrete - J-ring test
HRN EN 12350-7:2009: Testing fresh concrete - Part 7: Air content – Pressure methods
HRN EN 12390-3:2009: Testing hardened concrete - Part 3: Compressive strength of test specimens
HRN EN 12390-5:2009: Testing hardened concrete - Part 5: Flexural strength of test specimens
HRN EN 12390-13:2013: Testing hardened concrete - Part 13: Determination of secant modulus of elasticity in compression
HRN EN 12390-8:2009: Testing hardened concrete - Part 8: Depth of penetration of water under pressure
RILEM TC 116-PCD: permeability of concrete as a criterion of its durability (1999) Determination of the capillary absorption of water of hardened concrete. Mater Struct Constr 32:174–179, April 1999
HRN EN 993-4:2008: Methods of test for dense shaped refractory products – Part 4: Determination of permeability to gases
Ismail MK, Hassan AAA (2016) Use of metakaolin on enhancing the mechanical properties of self-consolidating concrete containing high percentages of crumb rubber. J Clean Prod 125:282–295
Uygunoǧlu T, Topçu IB (2010) The role of scrap rubber particles on the drying shrinkage and mechanical properties of self-consolidating mortars. Constr Build Mater 24(7):1141–1150
Si R, Wang J, Guo S, Dai Q, Han S (2018) Evaluation of laboratory performance of self-consolidating concrete with recycled tire rubber. J Clean Prod 180:823–831
HRN 1128:2007: Concrete - Guidelines for the implementation of HRN EN 206-1
Acknowledgements
This paper was supported by the Croatian Science Foundation under the project name UIP-2017-05-7113 Development of Reinforced Concrete Elements and Systems with Waste Tire Powder – ReCoTiP.
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2020 RILEM
About this paper
Cite this paper
Bušić, R., Miličević, I. (2020). Influence of Waste Tire Rubber on Fresh and Hardened Properties of Self-Compacting Rubberized Concrete (SCRC). In: Mechtcherine, V., Khayat, K., Secrieru, E. (eds) Rheology and Processing of Construction Materials. RheoCon SCC 2019 2019. RILEM Bookseries, vol 23. Springer, Cham. https://doi.org/10.1007/978-3-030-22566-7_1
Download citation
DOI: https://doi.org/10.1007/978-3-030-22566-7_1
Published:
Publisher Name: Springer, Cham
Print ISBN: 978-3-030-22565-0
Online ISBN: 978-3-030-22566-7
eBook Packages: EngineeringEngineering (R0)