Volume 29, issue 3, May 2016
23 articles in this issue
-
-
Force control compensation method with variable load stiffness and damping of the hydraulic drive unit force control system
Authors (first, second and last of 6)
-
Simple PID parameter tuning method based on outputs of the closed loop system
Authors (first, second and last of 4)
-
A novel pre-control method of vehicle dynamics stability based on critical stable velocity during transient steering maneuvering
Authors (first, second and last of 6)
-
Direct yaw moment control for distributed drive electric vehicle handling performance improvement
Authors (first, second and last of 5)
-
Theoretical research and experimental validation of elastic dynamic load spectra on bogie frame of high-speed train
Authors (first, second and last of 4)
-
Influence analysis of secondary O-ring seals in dynamic behavior of spiral groove gas face seals
Authors (first, second and last of 4)
-
Friction and wear properties of high-velocity oxygen fuel sprayed WC-17Co coating under rotational fretting conditions
Authors (first, second and last of 5)
-
Non-linear dynamics of inlet film thickness during unsteady rolling process
Authors (first, second and last of 5)
-
-
-
-
Low cycle fatigue and strengthening mechanism of cold extruded large diameter internal thread of Q460 steel
Authors (first, second and last of 6)
-
Characteristics and formation mechanism for stainless steel fiber with periodic micro-fins
Authors (first, second and last of 4)
-
-
-
-
-
Parameter tuning method for dither compensation of a pneumatic proportional valve with friction
Authors (first, second and last of 4)
-
Theoretical calculations and experimental verification for the pumping effect caused by the dynamic micro-tapered angle
Authors (first, second and last of 5)
-
-
-