Abstract.
The flash method is the most used technique to measure the thermal diffusivity of solids. It consists of heating the front face of an opaque slab by a short light pulse and detecting the temperature evolution at its rear surface, from which the thermal diffusivity is retrieved. In this paper we extend the classical flash method to be used with rods and tubes. First, the temperature evolution of the surface temperature of solid and hollow cylinders is calculated. Then, experimental measurements of a set of stainless steel samples using an infrared camera confirm the validity of the method.
Similar content being viewed by others
References
W.J. Parker, R.J. Jenkins, C.P. Butler, G.L. Abbott, J. Appl. Phys. 32, 1679 (1961)
A. Salazar, F. Garrido, R. Celorrio, J. Appl. Phys. 99, 066116 (2006)
F.P. Incropera, D.P. DeWitt, Fundamentals of Heat and Mass Transfer, 4th edn. (Wiley, New York, 1996)
Web site: www.matls.com
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Salazar, A., Apiñaniz, E., Massot, M. et al. Application of the flash method to rods and tubes. Eur. Phys. J. Spec. Top. 153, 83–86 (2008). https://doi.org/10.1140/epjst/e2008-00398-3
Issue Date:
DOI: https://doi.org/10.1140/epjst/e2008-00398-3