Abstract
A polypyrrole (PPy)/alumina composite filler prepared via in-situ polymerization of pyrrole on alumina particles was incorporated into Nafion® to improve the performance of ionic polymer-metal composite (IPMC) actuators. The IPMCs with the pristine PPy without alumina support did not show bending displacements superior to that of the bare Nafion-based IPMC, except at a high PPy content of 4 wt%. This result was attributed to the low redox efficiency of the PPy alone in the IPMC and may have also been related to the modulus of the IPMC. However, at the optimized filler contents, the cyclic displacement of the IPMCs bearing the PPy/alumina filler was 2.2 times larger than that of the bare Nafion-based IPMC under an applied AC potential of 3 V at 1 Hz. Even under a low AC potential of 1.5 V at 1 Hz, the displacement of the PPy/alumina-based IPMCs was a viable level of performance for actuator applications and was 2.7 times higher than that of the conventional Nafion-based IPMC. The generated blocking force was also improved with the PPy/alumina composite filler. The greatly enhanced performance and the low-voltage-operational characteristic of the IPMCs bearing the PPy/alumina filler were attributed to the synergic effects of the neighboring alumina moiety near the PPy moiety involving electrochemical redox reactions.
Similar content being viewed by others
References
M. Shahinpoor, Y. B. Cohen, J. O. Simpson, and J. Smith,Smart Mater. Struct.,7, R15 (1998).
A. J. Duncan, D. J. Leo, and T. E. Long,Macromolecules,41, 7765 (2008).
M. J. Han, J. H. Park, J. Y. Lee, and J. Y. Jho,Macromol. Rapid Commun.,27, 219 (2006).
J. D. Nam, H. R. Choi, Y. S. Tak, and K. J. Kim,Sensor Actuat. A-Phys.,105, 83 (2003).
V. K. Nguyen, J. W. Lee, and Y. T. Yoo,Sensor Actuat. BChem.,120, 529 (2007).
D. Y. Lee, M. H. Lee, K. J. Kim, S. Heo, B. Y. Kim, and S. J. Lee,Surf. Coat. Technol.,200, 1920 (2005).
B. J. Akle, M. D. Bennett, and D. J. Leo,Sensor Actuat. APhys.,126, 173 (2006).
M. Shahinpoor and K. J. Kim,Sensor Actuat. A-Phys.,96, 125 (2002).
C. K. Chung, P. K. Fung, Y. Z. Hong, M. S. Ju, C. K. Lin, and T. C. Wu,Sensor Actuat. B-Chem.,117, 367 (2006).
M. K. Song, Y. T. Kim, J. M. Fenton, H. R. Kunz, and H. W. Rhee,J. Power Sources,117, 14 (2003).
G. Y. Moon and J. W. Rhim,Macromol. Res.,15, 379 (2007).
G. Y. Moon and J. W. Rhim,Macromol. Res.,16, 524 (2008).
T. Uchikoshi, S. Furumi, T. S. Suzuki, and Y. Sakka,J. Ceram. Soc. Jpn.,114, 55 (2006).
X. Yang, T. Dai, and Y. Lu,Polymer,47, 441 (2006).
S. Skaarup, K. West, L. M. W. K. Gunaratne, K. P. Vidanapathirana, and M. A. Careem,Solid State Ionics,136–137, 577 (2000).
E. T. Enikov and G. S. Seo,Sensor Actuat. A-Phys.,122, 264 (2005).
C. Y. Chen, J. I. G. Rodriguez, M. C. Duke, R. F. D. Costa, A. L. Dicks, and J. C. D. Costa,J. Power Sources,166, 324 (2007).
Z. Jiang, X. Zheng, H. Wu, and F. Pan,J. Power Sources,185, 85 (2008).
S. C. Byun, Y. J. Jeong, J. W. Park, S. D. Kim, H. Y. Ha, and W. J. Kim,Solid State Ionics,177, 3233 (2006).
M. Shahinpoor and K. J. Kim,Smart Mater. Struct.,10, 819 (2001).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Lee, JW., Kim, JH., Chun, Y.S. et al. The performance of Nafion-based IPMC actuators containing polypyrrole/alumina composite fillers. Macromol. Res. 17, 1032–1038 (2009). https://doi.org/10.1007/BF03218653
Received:
Revised:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF03218653