Skip to main content
Log in

Cross-calibration of DXA equipment: Upgrading from a hologic QDR 1000/W to a QDR 2000

  • Clinical Investigations
  • Published:
Calcified Tissue International Aims and scope Submit manuscript

Summary

In this study, the cross-calibration of a fan beam DXA system (Hologic QDR-2000) to a pencil beam scanner from the same manufacturer (Hologic QDR-1000/W) is described. The scanners were calibrated by the manufacturer using the same anthropomorphic spine phantom at installation. To verify consistent machine calibration, a group of 69 female subjects, aged 46–75, had anteroposterior (AP) spine and proximal femur scans on the QDR-1000/W followed by pencil and array scans of the same sites on the QDR-2000 during the same visit. Many of the subjects had bilateral examinations of the proximal femur for a total of 123 hip scans. Pencil and array area, bone mineral content (BMC), and bone mineral density (BMD) from the QDR-2000 were compared with the values obtained on the QDR-1000/W, and linear regression equations were derived for relating the two instruments. At the spine, no differences were found between the QDR-1000/W BMD values and the QDR-2000 array BMD values. A slight difference between pencil beam modes was detected but was not deemed clinically significant. Linear regression models relating the QDR-2000 and QDR-1000/W AP spine BMD measurements showed correlation coefficients greater than 0.99, with slopes of 1.00, intercepts equivalent to zero, and small root mean square errors. Comparisons at the proximal femur showed equivalency at the femoral neck and trochanter regions for the two machines in pencil mode, but slight increases in BMC and BMD at the other femoral sites on the QDR-2000 in both pencil and array mode. Correlation coefficients were 0.97–0.99 for all measurement regions except for Ward's. Regression slopes relating the BMD for the femoral regions were 1.00–1.04, with intercepts not significantly different from zero and small residual errors. As with the spine, the differences were small enough that they were not of clinical significance. However, in longitudinal drug trials requiring highly precise determination of spinal and femoral BMD changes, these differences may be important.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  1. Lilley J, Walters BG, Heath DA, Drolc Z (1991) In vivo and in vitro precision of bone density measured by dual-energy x-ray absorption. Osteoporosis Int 1: 141–146

    Google Scholar 

  2. Glüer CC, Steiger P, Selvidge R, Elliesen-Kliefoth K, Hayashi C, Genant HK (1990) Comparative assessment of dual-photonabsorptiometry and dual-energy-radiography. Radiology 174: 223–228

    Google Scholar 

  3. Sartoris DJ, Resnick D (1989) Dual energy radiographic absorptiometry for bone densitometry: current status and perspective. AJR 152: 241–246

    Google Scholar 

  4. Steiger P, von Stetten E, Weiss H, Stein JA (1991) Paired AP and lateral supine dual x-ray absorptiometry of the spine: initial results with a 32 detector system. Osteoporosis Int 1(3): 190

    Google Scholar 

  5. Pommet R, Chambellan D, Reverchon P, Pare C, Lecluse A, Panissier P (1991) Array multidetector bone densitometer for supine vertebral measurement in lateral projection. Osteoporosis Int 1(3): 190

    Google Scholar 

  6. Stein JA, Lazewatsky JL, Hochberg AM (1987) Dual energy x-ray bone densitometer incorporating an internal reference system. Radiology 165(P): 313

    Google Scholar 

  7. von Stetten EC, Steiger S, Steiger P, Kelly TL (1992) Cross-calibration of dual energy x-ray absorptiometry (DXA) bone densitometry systems. In: Proceedings of the 3rd Bath Conference on Osteoporosis and Bone Mineral Measurement, Bath, UK

Download references

Author information

Authors and Affiliations

Authors

Rights and permissions

Reprints and permissions

About this article

Cite this article

Faulkner, K.G., Glüer, CC., Estilo, M. et al. Cross-calibration of DXA equipment: Upgrading from a hologic QDR 1000/W to a QDR 2000. Calcif Tissue Int 52, 79–84 (1993). https://doi.org/10.1007/BF00308312

Download citation

  • Received:

  • Revised:

  • Issue Date:

  • DOI: https://doi.org/10.1007/BF00308312

Key words

Navigation