Abstract
Sliding snow load on roofs is an important issue. Thus, a simulation method to calculate the sliding snow load on roofs is developed in this paper. Firstly, based on previous mass- and energy-balance models, a snowmelt model for building roofs, which focuses on the features of snowpack on roofs, is developed. Then, the sufficient condition proposed in the paper for snow sliding on roofs requires that the liquid water in the snow layer on roofs exceeds the maximum water-holding capacity of snow. The present method is used to simulate the sliding snow loads on roofs in several representative regions in China. These regions are selected because of their representative locations in China and the heavy snowfalls during winter. Moreover, the influences of the features of the climate, the shielding effect of neighboring buildings, and the heat gained from the inside of buildings are analyzed. The contributions of various energies to snow slide are presented quantitatively. The results indicate that the radiation has the greatest contribution to the melting of snow, followed by the sensible heat and the latent heat, as well as the energies caused by precipitation and heat transfer from the inside of buildings. Finally, a comparison between the simulated results and results from some load codes is made, and a simplified formula that can calculate the sliding snow load coefficient is given for the convenient application of structural engineers.
Similar content being viewed by others
References
American Society of Civil Engineers (2010) Minimum design loads for buildings and other structures (ASCE/SEI 7–10), USA
Anderson EA (1976) A point energy and mass balance model for a snow cover, NOAA Technical Report NWS 19. US Department of Commerce, USA
AnhuiNews (2008-2-18), http://365jia.cn/news/2008-02-18/F57FF95A359585F4.html. (in Chinese)
Bartelt P, Lehning M (2002) A physical SNOWPACK model for the Swiss avalanche warning Part I: numerical model. Cold Reg Sci Technol 35:123–145
Butke JT (1996) An evaluation of a point snow model and a mesoscale model for regional climate simulations. University of Delaware master thesis
Chiba T, Tomabechi T (2001) Study on the evaluation of snow load on pitched roof. J Struct Constr Eng Trans AIJ 539:37–42
Chiba T, Tomabechi T, Takahashi T (2012) Study on evaluation of snow load considering roof snow-slide on gable roofs. Snow Engineering VII, Fukui, pp 231–241
CNN (2010-12-12),http://articles.cnn.com/2010-12-12/us/winter.weather_1_flights-mateo-lleras-wreaks?_s=PM:US
Colbeck SC, Anderson EA (1982) The permeability of a melting snow cover. Water Resour Res 18(4):904–908
Dozier J (1989) Spectral signature of Alpine snow cover from the landsat thematic mapper. Remote Sens Environ 28:9–22
Elnahas MM, Williamson TJ (1997) An improvement of the CTTC model for predicting urban air temperatures. Energy Build 25:41–49
European Committee for Standardization (2003) Eurocode 1–Actions on Structures–Part 1–3: general actions—Snow Loads (EN1991-1-3:2003), London
Fernández A (1998) An energy balance model of seasonal snow evolution. Phys Chem Earth 23(5–6):661–666
Finsterwalder S, Schunk H (1887) Der Suldenferner. Zeitschrift des Deutschen und Oesterreichischen Alpenvereins. 18:72–89
Gustafsson D, Stähli M, Jansson PE (2001) The surface energy balance of a snow cover: comparing measurements to two different simulation models. Theoret Appl Climatol 70:81–96
Hock R (2003) Temperature index melt modeling in mountain areas. J Hydrol 282:104–115
International Organization for Standardization (1998) Bases for design of structures–Determination of snow loads on roofs (Second edition, ISO4355), Switzerland
Isyumov N, Mikitiuk M (2008) Sliding snow and ice from sloped building surfaces: its prediction, potential hazards and mitigation. The 6th snow engineering conference, Whistler B.C., Canada
Kobayashi T, Chiba T, Tomabechi T, Hoshiba S (2001) Study on the evaluation of snow load on roof of livestock buildings. J Agric Constr 32(2):15–23
Kustas WP, Rango A, Uijlenhoet R (1994) A simple energy budget algorithm for the snowmelt runoff model. Water Resour Res 30(5):1515–1527
Lehning M, Bartelt P, Brown B, Fierz C, Satyawali P (2002a) A physical SNOWPACK model for the Swiss avalanche warning Part II: snow microstructure. Cold Reg Sci Technol 35:147–167
Lehning M, Bartelt P, Brown B, Fierz C, Satyawali P (2002b) A physical SNOWPACK model for the Swiss avalanche warning, Part III: meteorological forcing, thin layer formation and evaluation. Cold Reg Sci Technol 35:169–184
Lepage MF, Schuyler GD (1988) A simulation to predict snow sliding and lift-off on buildings, Proceedings of the engineering foundation conference on a multidisciplinary approach to snow engineering. Santa Barbara, California
Letsinger SL, Olyphant GA (2007) Distributed energy-balance modeling of snow-cover evolution and melt in rugged terrain: tobacco Root Mountains, Montana, USA. J Hydrol 336(1–2):48–60
Loth B, Graf HF, Oberhuber JM (1993) Snow-cover model for global climate simulations. J Geophys Res 98(6):451–10–464
Male DH, Gray DM (1981) Snowcover ablation and runoff. Chapter 9 in handbook of snow, principles, processes, management and use. Pergammon Press pp 360–436
Ministry of Construction of the People’s Republic of China (1996) Energy conservation design standard(JGJ26-95). China Building Industry Press, Beijing
Ministry of Construction of the People’s Republic of China (2001) Design standard for energy efficiency of residential buildings in hot summer and cold winter zone(JGJ134-2001). China Building Industry Press, Beijing
Ministry of Construction of the People’s Republic of China (2006) Load code for the design of building structures(GB50009-2001). China Building Industry Press, Beijing
Ministry of Housing and Urban of People’s Republic of China (2010) Design standard for energy efficiency of residential buildings in severe cold and cold zones(JGJ26-2010). China Building Industry Press, Beijing
National Research Council of Canada(2005) National building code of Canada, Canada
Neale CMU, Tarboton DG, McDonnell JJ (1992) A spatially distributed water balance based on physical, isotropic and airborne remotely sensed data. Annual Tech. Rep., submitted to the U.S. Geological Survey. Utah State Univ., Utah Water Res. Lab., Logan
Ohara N, Kavvas ML (2006) Field observations and numerical model experiments for the snowmelt process at a field site. Adv Water Resour 29:194–211
Oke TR (1978) Boundary layer climate. Methuen & Co. Ltd
Sack RL, Arnholtz D, Haldeman JS (1987) Sloped roof snow loads using simulation. J Struct Eng, ASCE
Swift LW (1976) Algorithm for solar radiation on mountain slopes. Water Resour Res 12:108–112
Takakura M, Chiba T, Ito T, Tomabechi T (2000) On the term controlled by snow load: practical use of snow sliding on pitched roof. J Struct Constr Eng Trans AIJ 528:53–57
Tarboton DG, Luce CH (1996) Utah energy balance snow accumulation and melt model (UEB) computer model technical description and users guide. Utah water research laboratory and USDA forest service intermountain research station
U.S. Army Corps of Engineers (1956) Snow hydrology; summary report of the snow investigations. North Pacific Division, Portland
Williams KS, Tarboton DG (1999) The ABC’s of snowmelt: a topographically factorized energy component snowmelt model. Hydrol Process 13:1905–1920
Zeinivand H, Smedt DF (2010) Prediction of snowmelt floods with a distributed hydrological model using a physical snow mass and energy balance approach. Nat Hazards 54:451–468
Acknowledgments
This project is jointly supported by the National Natural Science Foundation (51278368), the Fundamental Research Funds for the Central Universities, and the Ministry of Science and Technology of China (SLDRCE08-A-03), which are gratefully acknowledged.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Zhou, X., Zhang, Y., Gu, M. et al. Simulation method of sliding snow load on roofs and its application in some representative regions of China. Nat Hazards 67, 295–320 (2013). https://doi.org/10.1007/s11069-013-0563-8
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11069-013-0563-8