Abstract
The structural, optical and electrical properties of plasma enhanced chemical vapor deposited silicon nitride layers are investigated, which have been used as a dielectric layer during RF MEMS fabrication. During growth, the gas ratio (SiH4/NH3) is varied between 0.33 and 0.5 and pressure is varied between 400 and 700 mTorr while deposition time is kept constant. The results in the films show differing properties. The thicknesses of the resultant films are between 150 to 220 nm with different gas flow ratios and pressures whereas the deposition time was kept constant. A Bruggeman effective medium approximation is utilized to model the refractive index of the films. Reflectance measurements were carried out in the range of 210–250 nm. The refractive indexes of the films varied between 1.79 and 2.03, with a dielectric constant varying from 6.66 to 7.22. Capacitance voltage measurements yield a fixed dielectric charge value in the low −1012 cm−2 while a breakdown voltage of 915 V μm−1 is achieved for films grown at the lowest gas ratio and pressure. The quality of Si/SixNy interface is also considered.
Similar content being viewed by others
References
Bustillo JM, Howe RT, Muller RS (1998) Surface micromaching for microelectromechanical systems. In: Proceedings of IEEE, vol 86, no 8, pp 1552–1574
Daldosso N, Melchiorri M, Riboli F et al (2004a) Fabrication and optical characterization of thin two-dimensional Si3N4 waveguides. J Mat Sci Semicond Process 7(4–6):453–458. doi:10.1016/j.mssp.2004.09.023
Daldosso N, Melchiorri M, Riboli F et al (2004b) Fabrication and optical characterization of thin two dimentional Si3N4 waveguides. J Mat Sci Semicond 7(4–6):453–458. doi:10.1016/j.mssp.2004.09.023
Dueñas S, Pelaez R, Castan E, Pinacho R, Quintanilla L, Barbolla J, Martil I, Gonzalez-Diaz G (1997) Experimental observation of conductance transients in Al/SiNx:H/Si metal-insulator-semiconductor structures. Appl Phys Lett 71(6):826–828. doi:10.1063/1.119658
Garcia S, Martil I, Gonzalez Diaz G, Castan E, Duenas S, Fernandez M (1998) Deposition of SiNx:H thin films by the electron cyclotron resonance and its application to Al/SiNx:H/Si structures. J Appl Phys 83:332–338. doi:10.1063/1.366713
Hines JH, Malocha DC et al. (1995) Deposition parameters studies and surface acoustic wave characterisation of PECVD silicon nitride films on lithium niobate. In: Proceedings of IEEE transaction on ultrasonics, ferroelectrics and frequency control, vol 42, no 3, pp 397–402
Mansour RR, Bakri-Kaseem M, Daneshmand M, Messiha N (2003) RF MEMS devices. In: Proceedings of international conference on MEMS, NANO and smart systems (ICMENS 2003), pp 103–107
Olson JM (2002) Analysis of LPCVD process conditions for the deposition of low stressed silicon nitride. Part I: preliminary LPCVD experiments. J Mat Sci Semicond Process 5(1):51–60. doi:10.1016/S1369-8001(02)00058-6
Sanders TJ, Caraway EL, Hall CJ et al (1997) Silicon nitride deposition process for low cost microelectronics applications. In: Proceedings of the 12th Bien- nial university/Government/Industry microelecttronic symposium, pp 173–176
Stesmans A (1989) The Si = Si3 defect at various 111 si/SiO2 and 111 Si/Si3N4 interfaces. J Semicond Sci Technol 4(12):1000–1011. doi:10.1088/0268-1242/4/12/005
Xu G, Jin P, Tazawa M, Yoshimura K (2003) Optical investigation of silicon nitride thin films deposited by r.f. magnetron sputtering. J Thin Solid Films 425(1–2):196–202. doi:10.1016/S0040-6090(02)01089-1
Gong C et al (2010) A deep-level transient spectroscopy study of silicon interface states using different nitride surface passivation scheme. Appl Phys Lett 96:1030507-1–103507-3. doi:10.1063/1.3358140
Khaliq MA, Shams QA, Brown WD, Naseem HA (1988) Physical properties of memory quality PECVD silicon nitride. J Electron Mater 17(5):355–359. doi:10.1007/BF02652118
Niklasson GA, Granqvist CG, Hunderi O (1981) Effective medium models for the optical properties of inhomogeneous materials. J Appl Optics 20(1):26–30. doi:10.1364/AO.20.000026
Rahman HU, Chan KY, Ramer R (2010) Cantilever beam designs for RF MEMS switches. J Micromech Microeng 20(075042):12. doi:10.1088/0960-1317/20/7/075042
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Rahman, H.U., Johnson, B.C., Mccallum, J.C. et al. Fabrication and characterization of PECVD silicon nitride for RF MEMS applications. Microsyst Technol 19, 131–136 (2013). https://doi.org/10.1007/s00542-012-1522-0
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00542-012-1522-0